The main objective with this study has been to study injection techniques for subsea dispersant injection (SSDI) to recommend techniques relevant for both laboratory studies and operational response equipment.The most significant factor was the injection point of the dispersant in relation to the release of the oil. The dispersant should be injected immediately before or after the oil is released. Then the dispersant will mix into the oil and reduce IFT before the oil enters the turbulent zone where initial droplet formation occurs.All injection techniques tested gave significant reductions in oil droplet sizes. However, due to the rapid oil droplet formation in turbulent jets and possible formation of surfactant aggregates in the oil, premixing of dispersants should not be used for experimental studies of subsea dispersant injection. This could underestimate dispersant effectiveness and produce results that might not be representative for up-scaled field conditions.

Dredged sediments have different physical and chemical characteristics compared with the sediments in place, which generates multiple effects on the environment.In this study, we show that the sampling strategy used to monitor the effects of dredge spoil deposition on the surrounding environment can lead to different interpretations. It appears that sediment sample replicates may or may not be necessary, depending on the studied area, the prevailing environmental forcings before sediment sampling and the combination of these two factors. The proposed modus operandi allows us to optimize both the confidence on the obtained results and the cost of the sediment studies (sampling and laboratory analyses). The results are based on the sediment fine fraction, which is considered as a key environmental component due, for example, to its strong association with the structure of benthic faunal communities as well as its role in the build-up of pollutants.

The aim of this study was to determine the levels of trace metals (Cd, Cr, Cu, Fe, Mn, Ni, Pb and Zn) in plastic pellets collected from two sandy beaches on the island of Vis, Croatia. A total of 92 pellets in a sediment volume of 3965 mL were collected at the investigated sampling sites. Concentrations of pellets in sediment samples ranged from 6 to 36 particles dm−3 of wet sediment. Mean particle weight of the collected beached pellets ranged from 17 mg to 31 mg. Trace metal concentrations in plastic pellets were greater than the concentrations reported for seawater in the investigated area, which indicates that plastic pellets sorb metals from the marine environment. The adsorbed trace metals may enter the food chain due to incidental ingestion of microplastic particles by marine animals, which presents a potential human health risk due to consumption of seafood.

The presence of toxic elements in fish represents a hazard for human health, especially in Mediterranean countries and other regions with high per-capita fish consumption. The present research, carried out along the northern Catalan coast (NW Mediterranean), aimed to determine the levels of trace metals and arsenic in the muscle of white seabream Diplodus sargus (L.), a common demersal species of growing interest for fisheries and aquaculture. Average mercury concentrations widely exceeded the limits imposed by EU despite the low contamination levels previously reported for the study area, stressing the potential risk associated to the consumption of medium-sized, non-predatory fishes. The other analyzed elements fell within the recommended limits. Preliminary results about the feeding habits of D. sargus are reported, in order to determine feeding habitat and items of the analyzed specimens.

A new mercury (Hg) evasion model for the Adriatic Sea was developed accounting for the ocean mixed layer depth in order to decrease Hg depletion at the surface. Previously modelled airborne Hg species and measured Hg in the ocean were used. Simulations were run using one- and two-way coupled atmosphere-ocean models. Discrepancies in evasion between the applied coupling schemes were shown to be insignificant. The model was evaluated by applying various wind parameterisations and diffusive coefficient formulae. Relatively high discrepancies among the applied methods were observed. The results of a shorter simulation were extrapolated over a one-year period by applying a measurement-based adaptation. We obtained good agreement with previously published data on Hg evasion in the entire Mediterranean area, thus confirming the suitability of the new model for Hg evasion simulations. Model computations performed for the Adriatic Sea resulted in levels of evasion approximately two times lower than previously estimated.

Mediterranean seagrasses have been hailed for their numerous ecosystem services, yet they are undergoing a decline in their coverage. The major complication with resolving this tendency is the sparsity of data on their overall distribution. This study addresses the suitability of the recently launched Sentinel-2 satellite for mapping the distribution of Mediterranean seagrass meadows. A comprehensive methodology is presented which applies atmospheric and analytical water column corrections and compares the performance of three different supervised classifiers. Remote sensing of the Thermaikos Gulf, northwestern Aegean Sea (Greece, eastern Mediterranean Sea) reveals that the utilization of Support Vector Machines on water column corrected reflectances yields best accuracies. Two Mediterranean seagrasses, Posidonia oceanica and Cymodocea nodosa, cover a total submerged area of 1.48km2 between depths of 1.4–16.5m. With its 10-m spatial resolution and 5-day revisit frequency, Sentinel-2 imagery can mitigate the Mediterranean seagrass distribution data gap and allow better management and conservation in the future in a retrospective, time- and cost-effective fashion.

The effects of dissolved oxygen and nutrient loading on the concentrations and species of phosphorus at the sediment–water interface were evaluated under laboratory conditions. The results showed that the redox potential was significantly correlated with the total phosphorus, total dissolved phosphorus, total nitrogen, ammonium and nitrate nitrogen levels in an aerobic setting, but no significant correlations were observed under anaerobic conditions. The dynamic equilibrium between the overlying water and sediment tended to balance out over time, and the concentration gradient reduced, when the nutrient loading was changed. The greatest variation was observed in the level of iron/aluminum-bound phosphorus, while the calcium-bound phosphorus and organic phosphorus contents showed relatively minor changes. This study not only illustrates the phosphorus transfer mechanism between sediment and water, but can also contribute to the management and protection of Bohai Bay.

We evaluated benthic bacterial communities as bioindicators in environmental impact assessments of salmon aquaculture, a rapidly growing sector of seafood industry. Sediment samples (n=72) were collected from below salmon cages towards distant reference sites. Bacterial community profiles inferred from DNA metabarcodes were compared to reference data from standard macrofauna biomonitoring surveys of the same samples. Deltaproteobacteria were predominant in immediate vicinity of the salmon cages. Along the transect, significant shifts in bacterial community structures were observed with Gammaproteobacteria dominating the less-impacted sites. Alpha- and beta-diversity measures of bacterial communities correlated significantly with macrofauna diversity metrics and with five ecological status indices. Benthic bacterial communities mirror the reaction of macrofauna bioindicators to environmental disturbances caused by salmon farming. The implementation of bacterial eDNA metabarcoding in future Strategic Framework Directives is an alternative cost-effective high-throughput biomonitoring solution, providing a basis for management strategies in a matter of days rather than months.

Microplastics generated by plastics waste degradation are ubiquitous in marine and freshwater basins, posing serious environmental concerns. Raman and FTIR spectroscopies, along with techniques such as pyrolysis-GC/MS, are typically used for their identification. We present a procedure based on gel permeation chromatography (GPC) coupled with fluorescence detection for semi-quantitative selective determination of the most common microplastics found in marine shoreline sediments: poly(styrene) (PS) and partially degraded polyolefins (LDPEox). By operating the detector at either 260/280 or 370/420 nm excitation/emission wavelengths PS can be distinguished from LDPEox upon GPC separation. Semi-quantitative determination of microplastics contents is also possible: dichloromethane extracts of PS and LDPEox yield linear plots of fluorescence peak area vs concentration (0–5.0 mg/mL range) and were used as reference materials for quantification of the microplastics content in sand samples collected in the winter berm and dune sectors of a Tuscany beach in Italy.

A global beach litter assessment is challenged by use of low-efficiency methodologies and incomparable protocols that impede data integration and acquisition at a national scale. The implementation of an objective, reproducible and efficient approach is therefore required. Here we show the application of a remote sensing based methodology using a test beach located on the Saudi Arabian Red Sea coastline. Litter was recorded via image acquisition from an Unmanned Aerial Vehicle, while an automatic processing of the high volume of imagery was developed through machine learning, employed for debris detection and classification in three categories. Application of the method resulted in an almost 40 times faster beach coverage when compared to a standard visual-census approach. While the machine learning tool faced some challenges in correctly detecting objects of interest, first classification results are promising and motivate efforts to further develop the technique and implement it at much larger scales.