A test program was conducted at laboratory and pilot scale to assess the ability of clays used in drilling mud (calcite, bentonite and barite) to create oil-mineral aggregates and disperse crude oil under arctic conditions. Laboratory tests were performed in order to determine the most efficient conditions (type of clay, MOR (Mineral/Oil Ratio), mixing energy) for OMA (Oil Mineral Aggregate) formation. The dispersion rates of four crude oils were assessed at two salinities. Dispersion was characterized in terms of oil concentration in the water column and median OMA size. Calcite appeared to be the best candidate at a MOR of 2:5. High mixing energy was required to initiate OMA formation and low energy was then necessary to prevent the OMAs from resurfacing. Oil dispersion using Corexit 9500 was compared with oil dispersion using mineral fines.

We determined the abundance and virulence of Vibrio parahaemolyticus in seawater and bivalves from the Gyeongnam coast in Korea, a major area for the seafood industry, during 2004–2016. V. parahaemolyticus is one of the most common pathogen causing seafood-borne illnesses in Korea, and increases during the summer. Its occurrence in seawater and bivalve samples was seasonally dependent, with high levels during the summer to early autumn. There were more strains in the area of sea continually exposed to inland wastewater. Only 5.1% and 3.5% of V. parahaemolyticus isolates from seawater and bivalves, respectively, had the trh gene, and only the bivalve isolates produced the tdh gene at levels below 2%. Continuous monitoring is clearly needed to reduce seafood-borne outbreaks of disease caused by V. parahaemolyticus, and to reveal the occurrence patterns and the presence of toxic genes of the strains in different marine environments.

Concentrations of selected antibiotic compounds from different groups were measured in sediment samples (14 analytes) and in near-bottom water samples (12 analytes) collected in 2011–2013 from the southern Baltic Sea (Polish coastal zone). Antibiotics were determined at concentration levels of a few to hundreds of ng g−1 d.w. in sediments and ng L−1 in near-bottom waters. The most frequently detected compounds were sulfamethoxazole, trimethoprim, oxytetracycline in sediments and sulfamethoxazole and trimethoprim in near-bottom waters. The occurrence of the identified antibiotics was characterized by spatial and temporal variability. A statistically important correlation was observed between sediment organic matter content and the concentrations of sulfachloropyridazine and oxytetracycline. Risk assessment analyses revealed a potential high risk of sulfamethoxazole contamination in near-bottom waters and of contamination by sulfamethoxazole, trimethoprim and tetracyclines in sediments. Both chemical and risk assessment analyses show that the coastal area of the southern Baltic Sea is highly exposed to antibiotic residues.

In this study we report the concentration levels of heavy metals (including Pb, Cd, Hg, Cr, Ni, Fe, Mn, Cu) in ballast water of commercial ships, entering Bushehr port for the first time in the region of the Persian Gulf. The concentration levels of Cu and Fe in all samples of the ballast water were higher compared with the coastal waters of Bushehr port. In the case of Cd, 76.47% of samples had higher concentration level compared with the coastal waters of Bushehr port. Results showed that in a long term the ballast water has the potential to change the chemical quality in marine environments and also may affect the human health and marine ecosystem where ships discharge their ballast water. Therefore, permanent monitoring as well as treatment of ballast water before discharging is crucial to keep the marine environment health.

Hurricanes can cause widespread environmental pollution that has yet to be fully articulated. This study develops a predictive water quality model to forecast potential contamination resulting from buckled or ruptured storage tanks in coastal industrialized areas when subjected to storm surge. The developed EFDC-Storm Surge model (EFDC-SS) couples EPA's EFDC code with the SWAN-ADCIRC hurricane simulation model. EFDC-SS is demonstrated using the Houston Ship Channel in Texas as a testbed and hurricane Ike as a model hurricane. Conservative and decaying dye runs evaluated various hurricane scenarios, combined with spills released at different locations and release times. Results showed that tank locations with shorter distances to the main waterbody and lower ground elevations have a higher risk of inundation and rapid spill mass transport. It was also determined that hurricane strength and landfall location, the location of the spill, and the spill release time relative to peak surge were interdependent.

Contamination level, chemical fraction and ecological risk of heavy metals in sediments from Daya Bay (DYB) were conducted in this study. The results revealed that the concentration of Cr, Cu, Zn, As, Cd and Pb in sediments were in the range of 36.38–90.33, 9.54–61.32, 33.54–207.33, 7.80–18.43, 0.13–0.43 and 15.89–30.01 mg kg−1, respectively, with bioavailable fractions of 13.29, 54.16, 47.60, 32.74, 68.14, 26.59%, respectively. A modified potential ecological risk index (MRI) was used for the ecological risk assessment, with ecological risk contribution ratios of 75.73, 14.29, 5.47, 1.74, 1.57 and 1.21% for Cd, As, Cu, Cr, Pb and Zn, respectively. The main contaminants were Cd and As, with their ecological risks “High” and “Moderate” levels, and their enrichment degrees “Moderately Severe” and “Moderate”, respectively. The multivariate statistical analysis suggested that the various anthropogenic activities along the bay might contribute mainly to the heavy metals contamination in DYB.

Ballast water is essential for maintaining the balance and integrity of a ship. However, exchanging ballast water resulted in discharging water of different origins in vessel recipient ports, and this may have caused ecosystem disturbance or aquatic pollution. The ballast water management (BWM) system is essential for the purification and disinfection of the ballast water that is taken up. Because current BWM systems widely use biocides for the treatment of aquatic organisms, the biocides may result in unintended toxicity of the discharged ballast water. In this study, we suggested thymol and carvacrol as chemical biocides for BWM systems and investigated their effectiveness using Artemia salina and Escherichia coli. Thymol and carvacrol showed biocidal effects in our study. A combination of these substances showed a synergistic increase in the biocidal effects. Moreover, carvacrol naturally degrades after disinfection, which indicates that natural substances may be promising candidates to increase the efficacy and reduce unwanted side effects of the BWM system.

In the present study, we analyzed the influence of untreated sewage exposure on carbon (δ¹³C) and nitrogen (δ¹⁵N) isotopic composition and several biochemical responses in the barnacle Balanus glandula. The main objective was to evaluate whether changes in stable isotopes signature do reflect biochemical sub-lethal effects in a sewage influence gradient. Stable isotopes analysis showed differences in isotope signatures between close sewage influence and distant sites, being δ¹³C signatures stronger than that of δ¹⁵N. Regarding biochemical effects, although organisms close to the effluent would be clearly exposed to contaminants (increased GST activity) the oxidative stress would not be too evident (peroxidases and ACAP not affected). The most affected physiological aspect was the digestive one, reflected in increased alkaline proteases and lipases activities. A clear relation between δ¹⁵N and GST activity was found, showing to δ¹⁵N as an indicator of potential exposure to chemical contaminants.

Wild animals in their natural environment could provide a big source of information, but sampling can be very challenging, above all for protected species, like marine mammals. Nevertheless, significant data can be obtained sampling stranded animals right after their death, taking into account proper sampling time and methodology.RNA samples from the skin of 12 individuals including the species Stenella coeruleoalba, Tursiops truncatus, and Grampus griseus were used to test 4 potential gene markers of anthropogenic contaminants exposure. The individuals were sampled in 3 geographic areas: the Adriatic, Ionian and Tyrrhenian seas. Three out of the 4 genes tested showed higher expression in the samples collected from the Adriatic Sea. Minute skin samples tell the story of the specific geographic location where the marine mammal spent its life, thanks to the different impact on gene expression exerted by different contamination levels.

We comprehensively investigated sedimentary Hg in Yellow and East China Seas (YECSs), which constitute potentially important depocenters for large anthropogenic Hg emissions from mainland China. A large dataset of Al-TOC-Hg concentrations led to an in-depth understanding of sedimentary Hg in the entire YECSs, including distribution and its determinants, source-to-sink, background levels, inventory in flux and budget, and accumulation history. Especially, the net atmospheric Hg flux to the sediments was estimated to be 1.3 × 10−5 g/m2/yr, which corresponded reasonably well to that calculated using a box model. About 21.2 tons of atmospheric Hg (approximately 4% of the total anthropogenic atmospheric Hg emissions from China) were buried annually in the YECS basin. This result implies that most of atmospheric Hg from China is transferred to the surface of the Pacific (including the East/Japan Sea and South China Sea) by the westerlies and, consequently, can play a critical role in open-sea aquatic ecosystems.