The effluent stream of the anaerobic digestion processes, the digestate, accommodates high residual organic content that needs to be further treated before discharge. Anaerobic treatment of digestate would not only reduce the residual organic compounds in digestate but also has a potential to capture the associated biogas. High-rate anaerobic reactor configurations can treat the waste streams using lower hydraulic retention times which requires less footprint opposed to the conventional completely stirred tank reactors. This study investigated the high-rate anaerobic treatment performance and the associated biogas capture from the digestate of a manure mixture composed of 90% laying hen and 10% cattle manures in fixed-film reactors. The results indicated that it was possible to reduce total chemical oxygen demand content of the digestate by 57–62% in 1.3–1.4 days of hydraulic retention time. The corresponding biogas yields obtained were in the range of 0.395–0.430 Lbiogas/g VSadded which were found to be comparable to many raw feedstocks. Moreover, significant total phosphorus reduction (36–47%) and greenhouse gas capture (over 14.5–18.1 tCO2e/d per m3 digestate) were also recorded in the anaerobic fixed-film reactors.

The numerical and mass concentrations of microplastics collected at 36 sites on the surfaces of 29 Japanese rivers were mapped and compared with four basin characteristics (basin area, population density, and urban and agricultural ratios) and six water quality parameters (pH, biochemical oxygen demand (BOD), suspended solids (SS), dissolved oxygen (DO), total nitrogen (T-N), and total phosphorus (T-P)) in each river basin. Microplastics were found in 31 of the 36 sites, indicating that some plastics fragment into small pieces before reaching the ocean. The microplastic concentrations are significantly correlated with urbanisation and population density, indicating that the microplastic concentrations in the river depend on human activities in the river basin. Furthermore, we found a significant relationship between the numerical and mass concentrations and BOD, which is an environmental indicator of river pollution. This result demonstrates that microplastic pollution in river environments has progressed more in polluted rivers with poor water quality than in rivers with good water quality, leading to the conclusion that the sources and inflow processes of microplastics in river environments are similar to those of other pollutants. Our findings can help identify potential sources (i.e., point and non-point sources) of fragmented microplastics to improve waste management in Japan and model the transport fluxes of fragmented microplastics in Japanese rivers using water quality parameters and basin characteristics.

This study was initiated after the appearance of chlorotic and necrotic lesions on vegetation in the vicinity of a glassworks. The aim was to establish whether the cause was an uncontrolled release of gaseous fluorides. Five different plant species (Norway spruce, peach, common hornbeam, common bean, common grape vine) were collected in the influenced area, and the fluorine (F) content was determined by a fluoride ion selective electrode after prior total sample decomposition by alkaline carbonate fusion. The measurement results were reported together with their measurement uncertainties (MUs), which were evaluated according to the Guide to the Expression of Uncertainty in Measurement. The F contents at comparable distances from the emitter and in a clean area, free from natural or anthropogenic fluoride emissions, were 87–676 and 10 μg g⁻¹, respectively, thereby confirming the release of gaseous fluorides from the glassworks. The F contents in samples of Norway spruce taken at various radial distances from the emitter suggest that the emitted gaseous fluorides were spread about evenly in all directions from the source following an inverse-power function. Estimated distances at which the F content would decrease to 50 μg g⁻¹ (allowed maximum content of F in feeding stuffs) and 21 μg g⁻¹ (maximum fluoride content in vegetables and fruits in relation to the upper limit of fluoride intake for humans) were 378 m and 571 m, respectively, from the emitter. Evaluation of our results for compliance with specification revealed a lack of regulation on fluoride content in the diet of humans and animals as well as a lack of guidelines on how to take into account MU.

Roxarsone (3-nitro-4-hydroxyphenylarsonic acid, ROX) is an arsenic-containing compound widely used as a feed additive in poultry industries. ROX excreted in chicken manure can be transformed by microbes to different arsenic species in the environment. To date, most of the studies on microbial transformation of ROX have focused on anaerobic microorganisms. Here, we isolated a pure cultured aerobic ROX-transforming bacterial strain, CZ-1, from an arsenic-contaminated paddy soil. On the basis of 16S rRNA gene sequence, strain CZ-1 was classified as a member of the genus Enterobacter. During ROX biotransformation by strain CZ-1, five metabolites including arsenate (As[V]), arsenite (As[III]), N-acetyl-4-hydroxy-m-arsanilic acid (N-AHPAA), 3-amino-4-hydroxyphenylarsonic acid (3-AHPAA) and a novel sulfur-containing arsenic species (AsC₉H₁₃N₂O₆S) were detected and identified based on high-performance liquid chromatography-inductively coupled plasma mass spectrometry (HPLC-ICP-MS), HPLC-ICP-MS/electrospray ionization mass spectrometry (ESI-MS) and HPLC-electrospray ionization hybrid quadrupole time-of-flight mass spectrometry (ESI-qTOF-MS) analyses. N-AHPAA and 3-AHPAA were the main products, and 3-AHPAA could also be transformed to N-AHPAA. Based on the results, we propose a novel ROX biotransformation pathway by Enterobacter. sp CZ-1, in which the nitro group of ROX is first reduced to amino group (3-AHPAA) and then acetylated to N-AHPAA.

We analyzed paired serum, urine, and hair samples from 94 Korean children and adults to investigate levels of 11 perfluoroalkyl acids (PFAAs). The effects of demographic factors and dietary habits on PFAA exposure were also assessed based on the paired samples. The total PFAA concentrations were 2.4–31 ng/mL in serum, not detected–9.5 ng/mL in urine, and 0.48–15 ng/g in hair. Levels of perfluoropentanoic acid (PFPeA) and perfluorohexanoic acid (PFHxA), which have short carbon chains, were 1.5–5 fold higher in urine and hair than in serum. The PFAA concentrations in serum exhibited a decreasing trend with age from young childhood to adolescence, followed by an increasing trend after adolescence. For most PFAA species, concentrations in serum were higher in adult males than in adult females (p < 0.01). No sex difference was evident in the urine and hair samples. In addition, there was no age difference in the urine samples, but in the hair samples, we observed higher concentrations of PFAAs in children than in the other age groups (p < 0.01). The consumption rates of fish and water showed significant correlations with serum (positive correlation) and hair (negative) concentrations, respectively. No relationships between serum and hair/urine levels for most PFAAs were observed, except between serum and hair levels for perfluorooctanoic acid (PFOA).

This study examined the spatial and temporal variations of severe particulate pollution days (SPPDs) in China by using observed PM₂.₅ concentrations during April 2013 to February 2018 from the Ministry of Environmental Protection of China. SPPDs were defined as those with observed daily mean PM₂.₅ concentrations larger than 150 μg m⁻³. Observations showed that northern China had the highest number of SPPDs during the studied period. Since 2015, the number of SPPDs in northwestern China is comparable to or even higher than that observed in Beijing-Tianjin-Hebei (BTH). The highest numbers of SPPDs observed within BTH and the Yangtze River Delta (YRD) were 122 (33), 95 (17), 57 (15), 78 (18), and 31 (25) days in 2013, 2014, 2015, 2016, and 2017, respectively, indicating a general decreasing trend as a result of emission reduction measures. SPPDs occurred mainly from November to February in BTH and in December and January in the YRD. The major circulation patterns associated with large-scale SPPDs were analyzed by using principal component analysis. Five typical synoptic weather patterns were identified for BTH. The most dominant weather type (a cold high centered over the Xinjiang and Mongolian regions) for BTH was also responsible for most of the SPPDs in the YRD. These results have important implications for emission control strategies during SPPDs. Emission control measures can be applied once the dominant circulation patterns have been predicted.

Contamination by plastic debris has been documented in most regions of the world, but their occurrence in high mountain areas has not been investigated to date. Here we present the first report of the occurrence and amount of microplastic in any terrestrial glacier environment. In the supraglacial debris of the Forni Glacier (Italian Alps), we observed the occurrence of (mean ± standard error) 74.4 ± 28.3 items kg⁻¹ of sediment (dry weight). This amount is within the range of variability of microplastic contamination observed in marine and coastal sediments in Europe. Most plastic items were made by polyesters, followed by polyamide, polyethylene and polypropylene. We estimated that the whole ablation area of Forni Glacier should host 131–162 million plastic items. Microplastic can be released directly into high elevation areas by human activities in the mountain or be transported by wind to high altitude. The occurrence of microplastic on Forni Glacier may be due to the gathering of debris coming from the large accumulation area into the relatively smaller ablation area of the glacier, as a consequence of its flow and melting.

Measurement of solute-transport parameters through soils for a wide range of solute- and soil-types is time-consuming, laborious, expensive and practically impossible. So, indirect methods for estimating the transport parameters by pedo-transfer functions are now advancing. This study developed and evaluated an Artificial Neural Network (ANN) model for estimating the transport velocity (V), dispersion coefficient (D) and retardation factor (R) of NaAsO₂, Pb(NO₃)₂, Cd(NO₃)₂, C₉H₉N₃O₂ and CaCl₂ from the basic soil properties. Breakthrough data of the solutes were measured in 14 agricultural soils of Bangladesh by time-domain reflectometry (TDR) in repacked soil columns under unsaturated steady-state water-flow conditions. The transport parameters of the chemicals were determined by analyzing the solute breakthrough data. Bulk density (γ), organic carbon (OC), clay (C) content, pH, median grain diameter (D₅₀) and uniformity coefficient (Cᵤ) of the soils were determined. An ANN model for V, D and R was developed by using data of eight soils, validated/tested with the data of five soils and verified with the data of one soil. Clay content and bulk density of the soils were the most sensitive input variables to the ANN model followed by other soil properties (OC, C, pH, D₅₀ and Cᵤ). The model reliably predicted V, D and R with relative root-mean-square error (RRMSE) of 0.028–0.363, mean error (ME) of – 0.00004 to 0.0005, bias error (BOE%) of 0–0.003 and modeling efficiency (EF) of >0.99. Thus, the ANN model can significantly enhance prediction of pollution transport through soils in terms of cost and effort.

In this paper, the equilibrium and mass transfer kinetics of Sr2+ sorption onto 3 types of microplastics, including polyethylene terephthalate (PET), polyethylene (PE), and polyvinyl chloride (PVC) were investigated. A novel film-pore mass transfer (FPMT) model was developed and used to study the sorption kinetics and mechanisms. This model can be used to describe the external mass transfer (EMT) and the internal mass transfer (IMT) processes and to calculate the diffusion rate. The FPMT model could successfully predict the kinetics data of Sr2+ sorption onto microplastics. The maximum value of the EMT rate achieved at the beginning of sorption was 103 μg g−1·h−1 for PET, 247 μg g−1·h−1for PE, and 854 μg g−1·h−1 for PVC, and then it decreased dramatically with time. The IMT rate was far less than the EMT rate, and decreased slowly with time. The overall sorption rate of Sr2+ onto microplastics was controlled by the external mass transfer step.

Worldwide the seafloor has been recognized as a major sink for microplastics. However, currently nothing is known about the sediment microplastic pollution in the North Pacific sector of the Arctic Ocean. Here, we present the first record of microplastic contamination in the surface sediment from the northern Bering and Chukchi Seas. The microplastics were extracted by the density separation method from collected samples. Each particle was identified using the microscopic Fourier transform infrared spectroscopy (μFTIR). The abundances of microplastics in sediments from all sites ranged from not detected (ND) to 68.78 items/kg dry weight (DW) of sediment. The highest level of microplastic contamination in the sediment was detected from the Chukchi Sea. A negative correlation between microplastic abundance and water depth was observed. Polypropylene (PP) accounted for the largest proportion (51.5%) of the identified microplastic particles, followed by polyethylene terephthalate (PET) (35.2%) and rayon (13.3%). Fibers constituted the most common shape of plastic particles. The range of polymer types, physical shapes and spatial distribution characteristics of the microplastics suggest that water masses from the Pacific and local coastal inputs are possible sources for the microplastics found in the study area. In overall, our results highlight the global distribution of these anthropogenic pollutants and the importance of management action to reduce marine debris worldwide.