In order to improve the heavy metal wastewater treatment by avoiding formation of amorphous sludge phase, we develop a faster formation of high crystalline layered double hydroxide (LDH) sludge to remove Cu and Zn from wastewater by controlled double-jet precipitation (CDJP) without hydrothermal or heat aging post-treatment. A series of experimental procedures are conducted to determine the optimal parameters. Results show that the optimal adding rate, pH value, and stirring rate is 0.5 mL min⁻¹, 9.0, and 500 rpm, respectively. The CuZnAl-LDH phase sludge is formed in a well-crystallized hexagonal platelet, which assembled into a flower-like architecture. Comparative studies show that the formation of amorphous LDH sludge in conventional precipitation (CP) could be divided roughly into two stages—from the mixed copper hydroxide, zinc hydroxide, and scarbroite to the mixed low crystallinity CuAl-LDH and ZnAl-LDH. However, in CDJP method, the high crystalline LDH sludge evolved from a new four-step evolution process that is the formation of an amorphous (quasi-)multinary metastable ternary CuZnAl-LDH phase, followed by the indiffusion of cations and substitution of anions to fabricate crystalline LDH, the integrated LDH hexagonal platelets assembled into a flower-like architecture by the screw dislocation growth mechanism, the coarsening growth of each ternary LDH platelet, respectively. Thereinto, the formation of (quasi-)multinary metastable LDH phase instead of metal hydroxide in initial stage would be an obvious advantage of the CDJP method compared to CP method due to the former skipping the sequential precipitation.

In this paper, the adsorption behavior of zinc onto magnetic zeolite/cellulose nanofibers (MZNF) was studied. The prepared adsorbent was characterized by SEM, FTIR, and VSM analyses. The mass ratio of adsorbent in composite, pH, contact time, adsorbent dosage, initial Zn⁺² concentration, temperature, and agitation speed were investigated in batch experiments. The results showed that zeolite played an important role in the prepared nanocomposite due to its great surface area. pH 7 exhibited the highest Zn⁺² removal efficiency. Rapid adsorption at the first 30 min of the reaction is one of the advantages of the prepared adsorbents. Moreover, increase at temperature led to higher efficiency and maximum efficiency was attained at 30 °C. Under optimum conditions, MZNF showed removal efficiency of 96% and maximum adsorption capacity of 9.45 mg/g. The presence of the competing ions did not reduce the efficiency of the process and adsorption efficiency was higher than 93%. The calculated RSD of 1.42% exhibits the suitability of the process. Equilibrium data were examined by various isotherms and kinetics equations. It was concluded that Pseudo second-order model and Langmuir models described the adsorption process well. Based on these results, MZNF obtained in this work can be served as a promising candidate for Zn⁺² removal in wastewater.

Grafting polyacrylamide (PAM) chains onto microparticles may combine the advantages of the flocculation property of the former and the fast sedimentation of the later to realize better flocculation performance. In this work, inexpensive microcrystalline cellulose (MCC) microparticles, and monomer of acrylamide (AM) were mixed, and then irradiated under microwave. The obtained material was characterized by Fourier transform infrared spectroscopy and X-ray diffraction, and the results demonstrated successful modification of MCC with AM on the particle surface. The modification procedure has been carefully investigated to obtain an optimum preparation condition. Kaolin suspension was selected as a model to evaluate the flocculation properties of the obtained AM-MCC. Our results indicate that the AM-MCC with the highest grafting ratio of 95.5% exhibits the best flocculation performance, which is even better than that of PAM, and the turbidity can be decreased to 1.4% of the naked kaolin suspension within 2.5 min. Therefore, this work provides a low cost strategy to prepare biodegradable AM-MCC, which may have promising potential application in the water treatment and other fields.

The shortage of drinking water is a major problem in the rural areas of the Mekong Delta, especially, when surface water, a main local direct drinking water source is being threatened by pesticide pollution and salinity intrusion. A hybrid process coupling electrodialysis (ED) and nanofiltration (NF) is proposed as an effective process easy to setup in a small plant to treat complex matrix with high salinity and pesticide concentration as is the Mekong Delta surface water. Performance of the ED–NF integration was evaluated with synthetic solutions based on the comparison with a single NF step generally used for pesticide removal. Both energy consumption and water product quality were considered to assess process efficiency. The ED stage was designed to ensure a 50% removal of salinity before applying NF. As expected, the NF rejection is better in the hybrid process than in a case of a single NF step, especially for pesticide rejection. The integration of a NF stage operated with NF270 membrane consumes less energy than that with NF90 membrane but its efficiency was observed not high enough to respect the Vietnamese guidelines. Using NF90, the optimal recovery rate of the NF stage varies from 30 to 50% depending on the salt content in the feed.

Bisphenol A (BPA) is a key endocrine-disrupting chemical (EDC) in the manufacturing industry. It is found in the structure of compounds such as polycarbonate and epoxy in combination with other chemicals. Our objective was to investigate the effect of BPA on rat ovaries. A total of 32 female rats were divided into four equal groups: In group 1 (control), vehicle was administered; in group 2, BPA 50 μg/day was administered intraperitoneally; in group 3, BPA 100 mg/kg/day was administered intraperitoneally; and in group 4, BPA 100 mg/kg/day and vitamin C (50 mg/kg) were administered intraperitoneally, while vitamin E (50 mg/kg) was administered intramuscularly. Thirty days after the treatment, the effects of BPA on the ovaries were evaluated by terminal deoxynucleotidyltransferase [TdT]-mediated dUTP-biotin nick end labeling (TUNEL) assay. There was no difference in the number of apoptotic cells between group 2 and group 4. In addition, there was no significant difference between control group and group 2, 4. However, the number of apoptotic cells per unit area was significantly increased in group 3 compared with all groups (p < 0.01, p < 0.05). In conclusion, this study showed that high doses of BPA (100 mg/kg/day) have a toxic effect on the ovaries. The fact that the number of apoptotic cells in the group administered with high dose of BPA + 50 mg/kg/day vitamin C + 50 mg/kg/day vitamin E was lower than that of the high-dose BPA-administered group shows that these vitamins may have a protective effect.

Eutrophication models are effective tools for assessing aquatic environments. The lake ecosystem consists of at least three trophic levels: phytoplankton, zooplankton, and fish. However, only a few studies have included fish sub-models in existing eutrophication models. In addition, no specific value or range is available for certain parameters of the fish sub-model. In the present study, a lake microcosm experimental system was established to determine the range of fish sub-model parameters. A three-trophic-level eutrophication model was established by combining the fish sub-model and eutrophication model. The Bayesian Markov Chain Monte Carlo and genetic algorithm method was used to calibrate the parameters of the eutrophication model. The results show that the maximum relative errors were due to phosphate (5.31%), the minimum relative error was due to nitrate (1.94%), and the relative error of dissolved oxygen, ammonia N, zooplankton, and chlorophyll ranged from 3 to 4%. Compared with the two-trophic-level eutrophication model, the relative errors of ammonia nitrogen (4.17%), phosphate (− 5.31%), and nitrate (1.94%) in the three-trophic-level eutrophication model were lower than those in the two-trophic-level eutrophication model, indicating that the three-trophic-level eutrophication model can obtain highly accurate simulation results and provide a better understanding of eutrophication models for future use.

Anticoagulant rodenticides (ARs) have been used for decades for rodent control worldwide. Research on the exposure of the environment and accumulation of these active substances in biota has been focused on terrestrial food webs, but few data are available on the impact of ARs on aquatic systems and water organisms. To fill this gap, we analyzed liver samples of bream (Abramis brama) and co-located suspended particulate matter (SPM) from the German Environmental Specimen Bank (ESB). An appropriate method was developed for the determination of eight different ARs, including first- and second-generation ARs, in fish liver and SPM. Applying this method to bream liver samples from 17 and 18 sampling locations of the years 2011 and 2015, respectively, five ARs were found at levels above limits of quantifications (LOQs, 0.2 to 2 μg kg⁻¹). For 2015, brodifacoum was detected in 88% of the samples with a maximum concentration of 12.5 μg kg⁻¹. Moreover, difenacoum, bromadiolone, difethialone, and flocoumafen were detected in some samples above LOQ. In contrast, no first generation AR was detected in the ESB samples. In SPM, only bromadiolone could be detected in 56% of the samples at levels up to 9.24 μg kg⁻¹. A temporal trend analysis of bream liver from two sampling locations over a period of up to 23 years revealed a significant trend for brodifacoum at one of the sampling locations.

To improve crop yielding, a large amount of fungicides is continuously applied during the agricultural management, while the effects of fungicides residues on microbial processing of N in soil need further study. In the present study, two broad spectrum fungicides, chlorothalonil and carbendazim, were applied at the rates of 5, 10, and 50 mg of active ingredient (A.I.) per kg of dry soil combined with urea with 200 mg of N per kg of dry soil under laboratory conditions. The results showed that chlorothalonil obviously retarded the hydrolysis of urea, whereas carbendazim accelerated it in 4 days after the treatments (P < 0.05). Chlorothalonil reduced denitrification, nitrification, and N₂O production (P < 0.05), but not for carbendazim. Further analysis on N-associated microbial communities showed chlorothalonil reduced nitrosomonas populations at the rates of 10 and 50 mg of A.I. per kg and autotrophic nitrifying bacterial populations at three application rates (P < 0.05), but Carbendazim decreased nitrosomonas populations only at the rate of 50 mg of A.I. per kg and also autotrophic nitrifying bacterial populations at three rates and heterotrophic nitrifying bacterial populations at the rates of 10 and 50 mg of A.I. per kg. The reasons for this difference were ascribed to arrest urea hydrolysis and impediment of denitrification and nitrification processes by chlorothalonil. In conclusion, to improve crop yielding, chlorothalonil might be more beneficial to conserve soil N by improving soil N fertility, compared with carbendazim.

The continuous adsorption-desorption of methylene blue (MB) on an invasive macrophyte, Salvinia minima, was investigated in fixed-bed columns. The effects of bed depth (h) (9.30, 18.70, and 28 cm), inlet dye concentration (C₀) (51 ± 1.20, 154 ± 2.00, and 250 ± 1.50 mg L⁻¹), and flow rate (Q) (7 and 14 mL min⁻¹) on dye removal and breakthrough curves were assessed. Thomas, modified dose-response (MDR) and bed depth service time (BDST) models were fitted to the experimental data. Desorption and regeneration studies were also performed. The breakthrough time was affected by h, C₀, and Q. The dynamic bed capacity at the breakthrough point (qb) increased with increasing h but decreased with increasing C₀ and Q. Dynamic bed capacities (qₑ) from 318 to 322 mg g⁻¹ were achieved at h = 28 cm, C₀ = 154 ± 2.0, or 250 ± 1.50 mg L⁻¹, independently of the Q value. High MB removals were also observed (75–78%). FTIR analysis revealed that hydroxyl and carboxyl groups could be involved in dye adsorption. MDR and BDST models were both successfully used to predict the breakthrough curves of MB adsorption onto S. minima. A high regeneration efficiency (> 87%) was obtained after three adsorption-desorption cycles. These results confirm that the use of S. minima biomass could be a very efficient and eco-friendly alternative for MB adsorption in continuous mode.

Deterring the spread of invasive fishes is a challenge for managers, and bigheaded carp (including bighead and silver carp, Hypophthalmichthys spp.) are invasive fish that have spread throughout large portions of the Mississippi River basin and threaten to invade the Great Lakes’ ecosystem. Studies have shown that elevated levels of carbon dioxide gas (CO₂) have the ability to act as a nonphysical fish barrier, but little work has been done on the efficacy of CO₂ to deter fish movement in flowing water. An annular swim flume was used to measure Ubᵤᵣₛₜ and sprint duration of the model species largemouth bass (Micropterus salmoides) across a range of pCO₂ levels (< 400 μatm [ambient]; 10,000 μatm; 50,000 μatm; and 100,000 μatm). This species was tested as a proxy because of the likelihood of a similar CO₂ response being produced, as well as constraints in obtaining and housing appropriately sized Asian carp. A significant decrease in Ubᵤᵣₛₜ swimming occurred when exposed to 100,000 μatm. No effects on sprint duration were detected. In both swimming tests, 15% of fish lost equilibrium when exposed to 50,000 μatm pCO₂, while 50% of fish lost equilibrium when exposed to 100,000 μatm. Together, results define target levels for managers to impede the spread of largemouth bass and potentially other invasive freshwater fishes, helping guide policy to conserve aquatic ecosystems.