Methyl bromide is an excellent fumigant but has been banned because it has high potential for depleting the ozone layer which leads to many environmental and human health hazard issues. In this connection, effectiveness of carbon dioxide (CO₂, 99.9%) was studied as an alternative to methyl bromide under various exposure timings, 25 ± 1 °C, against different developmental stages of the almond moth, Cadra cautella, and red flour beetle, Tribolium castaneum. In case of C. cautella, the LT₉₉ against adult, pupa, and larval stages was achieved after 37.5, 78.1, and 99.9 h of CO₂ application, respectively. While for T. castaneum, the LT₉₉ values were obtained after exposure timings of 29.3, 153.9, and 78.4 h against adult, pupa, and larval stages, respectively. Adults were very susceptible; in contrast, pupae and larvae were more tolerant. The susceptibility order was observed as follows: T. castaneum adult > C. cautella adult > C. cautella pupae > T. castaneum larvae > C. cautella larvae > T. castaneum pupae. This study could be useful in developing the management strategies to prevent stored dates from C. cautella and T. castaneum infestation.

Genotypic differences in cadmium (Cd) transport in developing grains of barley (Hordeum vulgare L.) were investigated using detached ears cultured in a nutrient solution containing 0.5 and 5 μM Cd. Cd concentration in each part of the ear in W6nk2 (a low-grain-Cd-accumulation genotype) was much less than in Zhenong8 (a high accumulator) with 0.5 μM Cd treatment. However, Cd concentration in W6nk2 grains increased with an increase in external Cd level and was similar to Zhenong8 with 5 μM Cd treatment. Awn removal, a high relative humidity (RH, 90%) and addition of sucrose markedly decreased grain Cd concentration in Zhenong8 but less affected Cd transport to grain in W6nk2. Stem girdling reduced Cd transport to developing grains with 5 μM Cd treatment, especially for W6nk2, whereas no effect was found in either genotype with low Cd treatment. Our results suggested that higher grain Cd in Zhenong8 is closely related to a larger capacity for xylem transport and is connected with Cd translocation in xylem and phloem sap.

Realistic implementation of ion selective electrodes (ISEs) into environmental monitoring programs has always been a challenging task. This could be largely attributed to difficulties in validation of ISE assay results. In this study, the electrochemical response of amoxicillin trihydrate (AMX), ciprofloxacin hydrochloride (CPLX), trimethoprim (TMP), and norfloxacin (NFLX) was studied by the fabrication of sensitive membrane electrodes belonging to two types of ISEs, which are polyvinyl chloride (PVC) membrane electrodes and glassy carbon (GC) electrodes. Linear response for the membrane electrodes was in the concentration range of 10⁻⁵–10⁻² mol/L. For the PVC membrane electrodes, Nernstian slopes of 55.1, 56.5, 56.5, and 54.0 mV/decade were achieved over a pH 4–8 for AMX, CPLX, and NFLX, respectively, and pH 3–6 for TMP. On the other hand, for GC electrodes, Nernstian slopes of 59.1, 58.2, 57.0, and 58.2 mV/decade were achieved over pH 4–8 for AMX, CPLX, and NFLX, respectively, and pH 3–6 for TMP. In addition to assay validation to international industry standards, the fabricated electrodes were also cross-validated relative to conventional separation techniques; high performance liquid chromatography (HPLC), and thin layer chromatography (TLC)-densitometry. The HPLC assay was applied in concentration range of 0.5–10.0 μg/mL, for all target analytes. The TLC-densitometry was adopted over a concentration range of 0.3–1.0 μg/band, for AMX, and 0.1–0.9 μg/band, for CPLX, NFLX, and TMP. The proposed techniques were successfully applied for quantification of the selected drugs either in pure form or waste water samples obtained from pharmaceutical plants. The actual waste water samples were subjected to solid phase extraction (SPE) for pretreatment prior to the application of chromatographic techniques (HPLC and TLC-densitometry). On the other hand, the fabricated electrodes were successfully applied for quantification of the antibiotic residues in actual waste water samples without any pretreatment. This finding assures the suitability of the fabricated ISEs for environmental analysis.

In this study, manganese peroxidase (MnP) from an indigenous white-rot fungus Ganoderma lucidum IBL-05 was insolubilized in the form of cross-linked enzyme aggregates (CLEAs) using various aggregating agents, i.e., acetone, ammonium sulfate, ethanol, 2-propanol, and tert-butanol, followed by glutaraldehyde (GA) cross-linking. The precipitant type, MnP, and GA concentrations affected the CLEAs activity recovery and aggregation yield. Among precipitants used, acetone appeared to be the most efficient aggregation agent, providing the highest activity recovery and aggregation yield of 31.26 and 73.46%, respectively. Optimal cross-linking was noticed using 2.0% (v/v) GA and 8:1 (v/v) MnP to GA ratio at 3.0 h cross-linking time under continuous agitation at 4 °C. The highest recovered activity and aggregation yield were determined to be 47.57 and 81.26%, respectively. The MnP-CLEAs, thus synthesized, were tested to investigate their bio-catalytic capacity for removing two known endocrine-disrupting chemicals (EDCs), e.g., nonylphenol and triclosan in a packed bed reactor system. The insolubilized MnP efficiently catalyzed the biodegradation of both EDCs, transforming over 80% in the presence of MnP-based system. A maximal of 100% decolorization was recorded for Sitara textile (SIT-based) effluent, followed by 95.5% for Crescent textile (CRT-based) effluent, 88.0% for K&N textile (KIT-based) effluent, and 84.2% for Nishat textile (NIT-based) effluent.

This study aims to examine the validity of the environmental Kuznets curve (EKC) and pollution haven hypotheses in Mexico, Indonesia, South Korea, Turkey, and Australia (MIKTA) countries from 1982 to 2011 by using a panel vector auto regressive (PVAR) model. Empirical findings imply that the EKC hypothesis is rejected by the MIKTA sample. However, PVAR estimations reveal Granger causality from income level, foreign direct investment (FDI) inward, and energy consumption to CO₂ emissions. Orthogonalized impulse-response functions are derived from PVAR estimations. According to the analysis results, the response of CO₂ emissions to a shock on FDI is positive. These results assert that FDI has a detrimental effect on environmental quality in MIKTA countries which means the pollution haven hypothesis is confirmed by the MIKTA sample. Therefore, MIKTA countries should revise their current economic growth plans to provide sustainable development and also re-organize their legal infrastructure to induce usage of renewable energy sources.

Magnetic biomonitoring techniques and in situ topsoil magnetic susceptibility measurements have been shown to be rapid, cost-effective, and useful methods for investigating roadside pollution. However, combustible vegetation in samples makes it very difficult to use them in high-temperature magnetic experiments although the thermal alteration of spontaneous magnetization is a fundamental magnetic property and can be used to identify reliably the magnetic minerals. Here, we report the first magnetic biomonitoring results of dust deposited on plant leaves along the Tateyama-Kurobe Alpine route at the highly protected Midagahara wetland areas of Mt. Tateyama in Toyama, Japan. In-field magnetic susceptibility from 15 sites (161 points) shows higher susceptibilities near the roadside. Dust deposited on the leaves of Sasa kurilensis, or dwarf bamboo, has been wiped off at 12 sites (64 samples) with a commercial ethanol wipe sheet or silica wool damped in ethanol and subjected to rock magnetic analyses. Thermomagnetic remanence curves and low-temperature behaviors for samples collected near the roadside using silica wool show clearly that the main magnetic mineral in the dust is partially oxidized magnetite. Further, detailed rock magnetic analyses and elemental analyses of leaves in the study area indicate that (a) the magnetic mineralogy on leaves’ surface is consistent throughout the study area and (b) higher saturation isothermal remanent magnetization intensities as well as higher concentrations of Pb, Fe, Cr, and Y are observed near the roadside, i.e., the closer to the roadside, the more anthropogenic materials, including partially oxidized magnetite, are present. Also, microscopic observations show the lack of spherical grains, indicating that dust on the roadside leaves is derived from passing vehicle rather than industrial process. Both rock magnetic and geochemical results show that S. kurilensis would be an excellent candidate for investigating air pollution. Also, the proposed wiping-off method of collecting dust from plant surfaces is an effective non-destructive method that can be applied even in highly restricted collection areas, because detailed magnetic mineralogy, including superparamagnetic minerals, could be determined with the use of silica wool for use in both high- and low-temperature experiments.

This paper reports on a study that investigated the aquatic toxicity of new non-ionic surfactants derived from renewable raw materials, polyoxyethylene glycerol ester (PGE), and their binary mixtures with anionic and non-ionic surfactants. Toxicity of pure PGEs was determined using representative organisms from different trophic levels: luminescent bacteria (Vibrio fischeri), microalgae (Pseudokirchneriella subcapitata), and freshwater crustaceans (Daphnia magna). Relationships between toxicity and the structural parameters such as unit of ethylene oxide (EO) and hydrophilic-lipophilic balance (HLB) were evaluated. Critical micellar concentration (CMC) in the conditions of the toxicity test was also determined. It was found that the toxicity of the aqueous solutions of PGE decreased when the number of EO units in the molecule, HLB, and CMC increased. PGEs showed lower CMC in marine medium, and the toxicity to V. ficheri is lower when the CMC was higher. Given their non-polar nature, narcosis was expected to be the primary mode of toxic action of PGEs. For the mixture of surfactants, we observed that the mixtures with PGE that had the higher numbers of EO units were more toxic than the aqueous solutions of pure surfactants. Moreover, we found that concentration addition was the type of action more likely to occur for mixtures of PGE with lower numbers of EO units with non-ionic surfactants (alkylpolyglucoside and fatty alcohol ethoxylate), whereas for the mixture of PGE with lower EO units and anionic surfactant (ether carboxylic derivative), the most common response type was response addition. In case of mixtures involving amphoteric surfactants and PGEs with the higher numbers of EO units, no clear pattern with regard to the mixture toxicity response type could be observed.

To reveal the seasonal variations and sources of PM₂.₅-bound polycyclic aromatic hydrocarbons (PAHs) during haze and non-haze episodes, daily PM₂.₅ samples were collected from March 2015 to February 2016 in a mixed multi-function area in Hangzhou, China. Ambient concentrations of 16 priority-controlled PAHs were determined. The sums of PM₂.₅-bound PAH concentrations during the haze episodes were 4.52 ± 3.32 and 13.6 ± 6.29 ng m⁻³ in warm and cold seasons, respectively, which were 1.99 and 1.49 times those during the non-haze episodes. Four PAH sources were identified using the positive matrix factorization model and conditional probability function, which were vehicular emissions (45%), heavy oil combustion (23%), coal and natural gas combustion (22%), and biomass combustion (10%). The four source concentrations of PAHs consistently showed higher levels in the cold season, compared with those in the warm season. Vehicular emissions were the most considerable sources that result in the increase of PM₂.₅-bound PAH levels during the haze episodes, and heavy oil combustion played an important role in the aggravation of haze pollution. The analysis of air mass back trajectories indicated that air mass transport had an influence on the PM₂.₅-bound PAH pollution, especially on the increased contributions from coal combustion and vehicular emissions in the cold season.

Two elementary schools (Shiuguang and Fongrong) from Yulin County in Taiwan, near a main area of potential exposure to Aeolian river-dust, were selected to collect outdoor and indoor PM₁₀ aerosols and to measure five metals in PM₁₀ (As, Ni, Cr, Cd, and Mn). Significant relationships (p < 0.01) were found between outdoor PM₁₀ concentrations at Lunbei’s air quality monitoring station and the two elementary schools. The outdoor PM₁₀ concentrations at the monitoring station and the schools’ indoor PM₁₀ concentrations also showed significant correlations. This study also established a relationship between the outdoor and indoor concentrations of PM₁₀ and metals in the schools. Estimations were made regarding students’ 8 h of exposure to metal concentrations from river-dust episodes during 1994–2012, based on correlation equations that were shown to be statistically significant.