Groundwater and surface water contamination have been linked to inadequate or failing on-site residential wastewater treatment and disposal systems. The potential for groundwater contamination in coastal areas with shallow water tables is higher; subsequently the ability of soil, microorganisms, and vegetation to mitigate pollutants may be reduced. This study evaluated the performance of the four types of on-site wastewater treatment and disposal systems predominantly used on the Mississippi Gulf Coast. One type of system was deemed inappropriate for this region as none of the dozens of installations examined were functioning acceptably. Of the remaining three types, subsurface water samples were collected from representative sites using lysimeters and monitoring wells. Apart from general performance evaluation of these systems, seasonal changes translating into possible variation in disposal efficiencies and groundwater contamination were investigated. Statistical analysis of variations in organics (COD and BOD₅), nitrogen (TKN and NH ₄ ⁺ –N), and fecal coliform concentrations was used to identify probable deficiencies in systems tested and to recommend changes to governing standards.

Consumer demand for cleaned squid generates a substantial amount of waste that must be properly disposed of, creating an economic burden on processors. A potential solution to this problem involves converting squid by-products into an organic fertilizer, for which there is growing demand. Because fertilizer application to lawns can increase the risk of nutrient contamination of groundwater, we quantified leaching of NO3–N and PO4–P from perennial ryegrass turf (Lolium perenne L.) amended with two types of fertilizer: squid-based (SQ) and synthetic (SY). Field plots were established on an Enfield silt loam, and liquid (L) and granular (G) fertilizer formulations of squid and synthetic fertilizers were applied at 0, 48, 146, and 292 kg N ha−1 year−1. Levels of NO3–N and PO4–P in soil pore water from a depth of 60 cm were determined periodically during the growing season in 2008 and 2009. Pore water NO3–N levels were not significantly different among fertilizer type or formulation within an application rate throughout the course of the study. The concentration of NO3–N remained below the maximum contaminant level (MCL) of 10 mg L−1 until midSeptember 2009, when values above the MCL were observed for SQG at all application rates, and for SYL at the high application rate. Annual mass losses of NO3–N were below the estimated inputs (10 kg N ha−1 year−1) from atmospheric deposition except for the SQG and SYL treatments applied at 292 kg N ha−1 year−1, which had losses of 13.2 and 14.9 kg N ha−1 year−1, respectively. Pore water PO4–P levels ranged from 0 to 1.5 mg P L−1 and were not significantly different among fertilizer type or formulation within an application rate. Our results indicate that N and P losses from turf amended with squid-based fertilizer do not differ from those amended with synthetic fertilizers or unfertilized turf. Although organic in nature, squid-based fertilizer does not appear to be more—or less—environmentally benign than synthetic fertilizers.

In the last few years, a great deal of research on soil has been carried out in order to develop a low-cost remediation method for reducing the environmental risks due to the pollution caused by heavy metals. In the light of this, the zeolitization achieved in soils mixed with coal fly ash could be a useful answer to reduce the amount and the mobility of metals in polluted areas. In this study, a selected soil treated with coal fly ash and artificially contaminated with Zn or Pb was used to synthesize zeolite at low temperature in laboratory and on a bench-scale experiments. Mineralogical data showed that the synthesis of zeolite X took place readily after the first month, and the amount of the newly formed mineral increased during the entire 1-year-long incubation period. The presence of toxic elements does not interfere with zeolite crystallization, whereas the chemical analysis indicated that a reduction in heavy metal availability takes place in the samples characterized by the presence of zeolite.

The effects of a five-pesticide mixture on pesticide accumulation, phytohormone levels (indole-3-acetic acid, gibberellic acid, jasmonic acid, and salicylic acid), pigment contents (total chlorophyll and carotenoid), antioxidant enzyme (catalase and guaiacol peroxidase) activities, lipid peroxidation product (malondialdehyde), and DNA profiles were investigated in the leaves of Veronica beccabunga. Laboratory-acclimatized plants were treated with a mix of five pesticides (atrazine, disulfoton, chlorpyrifos, metalaxyl, and ethion) in doses of 50 ppt, 1 ppb, 100 ppb, and 1 ppm for 1, 3, and 6 days. The accumulation of each pesticide, from highest to lowest, was as follows: chlorpyrifos, atrazine, metalaxyl, disulfoton, and ethion. The amounts of total chlorophyll and protein decreased with increased pesticide concentration. Antioxidant enzyme activities and malondialdehyde amount increased linearly with increasing pesticide exposure. However, the highest pesticide concentration caused decreases in guaiacol peroxidase (POD) activity and malondialdehyde (MDA) content at all treatment times. Both jasmonic and salicylic acid levels increased with pesticide exposure and decreased gradually after. It was also determined that application of the pesticide mixture affected the DNA profiles of V. beccabunga. The most band changes were detected on the sixth day of treatment.

The number of Enterobacteriaceae, with particular attention given to the presence of Escherichia coli and Klebsiella pneumoniae, was determined in hospital effluents and municipal wastewater after various stages of purification. The emission of these microorganisms to the ambient air near wastewater treatment plant (WWTP) facilities and to the river water, which is a receiver of the WWTP effluent, was also studied using fluorescence in situ hybridization (FISH) and cultivation methods. The number of Enterobacteriaceae determined by cultivation and fluorescence methods in different kinds of sewage sample ranged from 0.5 × 10³ to 2.9 × 10⁶ CFU/ml and from 2.2 × 10⁵ to 1.3 × 10⁸ cells/ml, respectively. Their removal rates during treatment processes were close to 99 %, but the number of these bacteria in the WWTP outflow was quite high and ranged from 5.9 × 10³ to 3.5 × 10⁴ CFU/ml and from 1.1 × 10⁵ to 6.1 × 10⁵ cells/ml, respectively. In the river water and the air samples, the number of Enterobacteriaceae was also high and ranged from 4.1 × 10³ to 7.9 × 10³ CFU/ml and from 3 to 458 CFU/m³, respectively. The numbers of these microorganisms obtained from fluorescence and cultivation methods were statistically and significantly correlated; however, the analysis of the studied samples indicated that the FISH method gave values up to 10³-fold times greater than those obtained by the cultivation method. From a sanitary point of view, this means that the number of viable fecal bacteria is systematically underestimated by traditional culture-based methods. Thus, the FISH proves to be a method that could be used to estimate bacterial load, particularly in air samples and less contaminated river water.

Electrochemical processes in industrial effluents have been studied as a means to obtain higher efficiency in wastewater treatment. Heterogeneous photocatalysis appears as a low-cost alternative through the use of lower wattage lamps and thermal TiO₂ films. Photocatalysis became a clean process for water treatment due to hydroxyl radicals generated on semiconductor surface. Such radicals are able to degrade several organic compounds. This study used different electrodes and analytical methods for degradation of phenol molecules to reduce treatment costs, improve efficiency, and identify compounds formed during the decomposition of phenolic molecules. Thermal growth of TiO₂ film was observed on the titanium electrode in rutile form. Application of an electrical potential on the Ti/TiO₂ working electrode increases efficiency in reducing concentration of phenol after photocatalytic treatment. Still, high energy radiation (UVC) showed best degradation rates in photolytic process. Different compounds formed during the degradation of phenol were also identified in the UVC–PE treatment.

The use of plant-derived sorbent was investigated as a remediation strategy for low-energy intertidal wetlands contaminated by crude oil spills. Effectiveness of plant-derived sorbent as a wicking agent was evaluated in microcosms simulating intertidal wetlands. Microcosms were designed to impose three different oil penetration depths (0.25, 0.5, and 1.0 cm), two different tidal amplitudes (±5 and ±10 cm above oil-contaminated surface), and two different types of sorbents (raw bagasse and hydrophobic-treated bagasse). We observed that the use of plant-derived sorbent was beneficial not only in removing oil but also in preventing further contamination. Oil penetration depth and tidal amplitude both negatively influenced the effectiveness of the sorbent. Effectiveness of the hydrophobic-treated sorbent was always higher than that of untreated one at any given oil penetration depth and tidal amplitude. Effectiveness of hydrophobic-treated sorbent was relatively low compared to that of raw bagasse. The most plausible explanation is that oil wicking mainly occurred during low tide. From a cost-effectiveness point of view, we suggest the use of raw bagasse immediately after an oil spill for remediation of low-energy intertidal wetlands. The observed results imply that this technique has potential to stimulate biodegradation by wicking oil out of contaminated intertidal wetlands subsurface to the aerobic zone where biodegradation can take place.

Specific activity of tritium (³H) in precipitation and specific activity of ¹³⁷Cs in ground-level air were monitored at three locations in Belgrade (Meteorological Station of Belgrade at Zeleno Brdo (ZB), Meteorological Station Usek (USEK), and Vinča Institute of Nuclear Sciences (VINS)). Data presented cover the period 1985–1997 for ¹³⁷Cs for all locations and 1985–2009 (ZB), 1988–1997 (USEK), and 1988–2009 (VINS) for ³H. Concentrations of ³H in precipitation have been determined using electrolytic enrichment and liquid scintillation spectrometer LKB-Wallac 1219 RackBeta. The activity of ¹³⁷Cs in air was determined on an HPGe detector (Canberra, relative efficiency 23 %). ³H concentrations in precipitation ranged from 0.40 ± 0.08 to 74.6 ± 5.2 Bq l⁻¹ decreasing with distance from the nuclear facilities. Significantly higher tritium levels were measured in samples in VINS compared with those from an off-site location. The observed seasonal variations of tritium concentration indicate the stratospheric source of tritium. Increases in activity concentration of ¹³⁷Cs in the atmosphere were observed after the nuclear plant accident at Chernobyl in April 1986. The concentrations obtained for ¹³⁷Cs in 1986 were compared with the integrated air concentrations of ¹³⁷Cs in the region. The increases of ¹³⁷Cs air concentrations in 1987 and 1988 were attributed to local resuspensions from the ground. Since 1989, the activity level before the accident has been obtained. The average monthly concentrations of ¹³⁷Cs in ground-level air were shown spread maximum in spring–summer period and pronounced maximum during winter. The obtained results were statistically analyzed, i.e., the following parameters were determined: tritium deposition, monthly activities of ³H and ¹³⁷Cs, seasonal indices, radionuclide loading indices, and linear correlation coefficients.

We examined the effects of an amended mixture of three pesticides, atrazine (72.7 g), S-metolachlor (54.5 g), and permethrin (both cis and trans isomers; 11.4 g), on 10-day sediment toxicity to Hyalella azteca in a managed natural backwater wetland after a simulated agricultural runoff event. Sediment samples were collected at 10, 40, 100, 300, and 500 m from inflow 13 days prior to amendment and 1, 5, 12, 22, and 36 days post-amendment. Background pesticide concentrations ranged from <1 to 977, <1 to 119, and <1 to 2 μg kg⁻¹, for atrazine, S-metolachlor, and permethrin, respectively. Average post-amendment atrazine and S-metolachlor were 2,915–3,927 and 3–20 μg kg⁻¹, respectively at 10–40 m and 538–872 and <1 μg kg⁻¹, respectively at 300–500 m. Average post-amendment permethrin was 65–200 μg kg⁻¹ at 10–40 m and 1–10 μg kg⁻¹ at 300–500 m. H. azteca 10-day survival varied spatially and temporally up to 100 m from inflow. Animal growth, independent of survival, was reduced 40 and 100 m from inflow on day 36, showing continued sediment toxicity of up to 100 m from inflow more than 1 month after amendment. Animal survival and growth were unaffected at 300 and 500 m from inflow throughout the study period. Correlations of pesticide concentrations and H. azteca responses indicated that observed sediment toxicity was primarily from permethrin with potential additional synergistic toxicity from atrazine and methyl parathion. Study results indicate that natural backwater wetlands can be managed to ameliorate pesticide mixture 10-day sediment toxicity to H. azteca within 300 m of inflow and smaller wetlands (≤100 m) may require several months of effluent retention to mitigate effects.

The shell of a gastropod (Achatina Achatina) was used as a precursor for the synthesis of nano calcium oxide (NC) via the sol–gel technique. The NC was characterized and the performance evaluation in chromium (Cr) (VI) abstraction was assessed in a fixed bed. The operating characteristics of the NC-Cr (VI) system were analysed with the mass transfer model and the mass transfer zone parameters were found to fluctuate with changes in the initial Cr (VI) concentration. The evaluation of the equilibrium data, generated from the fixed bed studies, showed that the sorption of Cr (VI) occurred via monolayer adsorption mechanism, and the monolayer sorption capacity was 833.33 mg/g. Different kinetic models (i.e., Adams–Bohart, Thomas, Wolborska, and Yoon–Nelson models) were applied to experimental data to predict the breakthrough curves and to determine the parameters of the column useful for process design. The kinetic analysis showed that the Yoon and Nelson model had the best fitting of the experimental data. The data obtained for Cr (VI) removal, when the NC bed height was optimized, were well described by bed depth service time model.