The research was conducted during the period of 2007-2011 in the fields fertilized by manure of pig breeding complex. According to the fertilization value of manure, the following total nitrogen levels reached the fields each year: 2007 – 169, 2008 – 167, 2009 - 168, 2010 - 168, 2011 – 168 kg haE-1. Ptotal reached the fertilized fields accordingly: 2007 – 9.4, 2008 – 18.9, 2009 – 12.0, 2010 – 10.8, 2011 – 13.5 kg haE-1. The aim of the research was to explore the impact of manure fertilized fields of a pig breeding complex on the water quality of streams. Streams, flowing through fields fertilized with manure, are usually polluted with nitrogen. The increase in Ntotal concentrations in streams’ water below fertilized fields was affected by precipitation (r = -0.31), fertilization rate (r = 0.41) as well as mineral nitrogen reserves in the soil (r = 0.20). Phosphorus concentrations in streams’ water were low and corresponded to a very good streams’ water ecological condition, except in times, when the water inflowing into the fertilized fields was already contaminated with this element. It was determined that an extremely high impact on streams’ water quality below fertilized fields comes from Ptotal concentration in streams’ water above fertilized fields (r = 0.91) as well as from the drainage water inflowing from fertilized fields into the streams (r = 0.71). Neither Ntotal, nor Ptotal pollution was observed in drainage water, because the highest concentrations during the research period were lower than the maximum allowable concentrations by 1.1 and 6.5 times respectively.

The aim of the study was to determine and compare calcium and phosphorus content in pedal mass, visceral mass and shell of wild and bred trial groups’ snails (Helix pomatia). The trial was performed from May to September of 2011 at the Roman Snail Research Facility of the Research Institute of Biotechnology and Veterinary Medicine „Sigra”, of Latvia University of Agriculture (LLU). Snails were divided in 4 trial groups depending on the diets. Samples were collected from the local natural population of snails and experimental breeding farm in spring (May), summer (July) and autumn (September). Significant differences (p is less than 0.05) were found between the levels of the calcium and phosphorus content in the edible part (pedal mass) and visceral mass in wild snails and experimental trial groups.

The investigations were carried out during the period 2006-2011 in the land of the Water resources management institute of ASU, in the village of Lipliūnai on Endocalcari Endohypogleyic Cambisol (CMg-n-w-can). The base of investigations is 3 drainage systems, which contain cereals differing in fertilization and grass crop rotations. The aim of investigations is to determine the crop rotations differing in fertilization and these relations with cycles of phosphorus in agroecosystem. Higher productive was perennial grass crop rotation. In the conditions of cereal crop rotations this productive was 3-46% lesser. The highest concentration of P-PO4 3- in drainage water was received in the conditions of higher fertilization cereals crop rotation while highest concentration of total P was in the conditions of grass crop rotation. The concentration of P-PO4 3- in drainage water essentially depends on amount of mobile P2 O5 in soil, fertilization, productivity of field crops, drainage runoff as well as cumulative balance of P. The highest leaching of P-PO4 3- and total P by drainage was received under the conditions of higher fertilization cereals crop rotation. The leaching of P-PO4 3- essentially depends on fertilization, drainage runoff as well as cumulative and yearly balance of P. The application of all crop rotations was distinguished by positive P balance.

Most of the regulated rivers are situated in the middle part of Lithuania. Approximately 90% of all agricultural lands are drained in the Basin of Nevezis River, which is one of the most sensitive basins in Lithuania due to the lack of water and potential anthropogenic pollution. The goal of the research is to assess the impact of drainage on Nevezis River flow. Following the data series of 62 years, it was determined that water balance of Nevezis Basin is characterized by negative water balance during May-September due to higher evapotranspiration than average precipitation amount of the same period. It was stated that the average annual flow coefficient of the whole 10th hydrologic region of Lithuania was 0.3 till reclamation. It decreased to 0.28 during the period of intensive reclamation; however, the average annual flow was 0.35 from the year 1980, i.e., it increased in comparison with the period till reclamation. The average flow coefficient of warm period was 0.10 till reclamation, and remained the same during the period of 1956-1980, while the data of 1981-1995 show that the average flow coefficient increased – 0.11. After assessing the meteorological conditions and soil water balance of the Basin of Nevezis River it might be stated that the primary reason of water lack in the basin is climatic conditions. Drainage systems can hardly have a significant impact on wateriness of Nevezis River.

Invention of light weight cellular wood material (CWM) with a trade mark of Dendrolight is one of the most important innovations in wood industry of the last decade. Currently CWM has been used as core material for sandwichpanels. These three layer panels are used in furniture industry and have wide non-structural applications. The aim of the research was to define the thermal properties of CWM and evaluate various wall envelopes where solid wood cellular material is used. There were 4 specimens of cellular wood material manufactured with nominal dimensions thickness 120 mm, length and with 600 mm to determine thermal conductivity and thermal transmittance according to standard EN 12667:2002. The specimens were manufactured of four layer 112 mm thick Scots pine (Pinus sylvestris L.) CWM double faced with 4 mm thick high-density fiberboard (HDF). Adhesive used in the bonding process was polivinilacetate Cascol 3353. Each direction (parallel, perpendicular) was represented by two specimens. Common procedure to evaluate the energy efficiency of building envelope is to calculate thermal transmittance in static conditions. The influence of the cellular material orientation to its thermal properties was investigated. Coefficient of thermal conductivity was determined for both material directions of CWM (l0 =0.0977 W∙m-1∙K-1 l90=0.148 W∙m-1∙K-1), combining the test method of EN 12667:2002 and calculation method of standard EN 6946:2008. To calculate thermal transmittance of various wall envelopes calculation software in JavaScript environment was created. Various compositions of external walls were assessed, thermal transmittance of these structures were calculated according to standard EN 6946:2008.

The aim of investigations was to compare different absorber material efficiency to examine collector tracking the Sun and stationary collector efficiency as well as the efficiency of insulated and non-insulated collectors. The 0.1x0.5x1.0 meter long experimental solar collectors were constructed for investigations and different types of absorber materials were made. The manifold length, the Sun radiation effect on the degree of air heating was analyzed. ASHARE used standard 93-2003 is determined for insulated and non-insulated solar collectors and absorber effectiveness. We determined the influence of the Sun radiation on the air heating degree for those types of absorbers. The experimental data were measured and recorded in the electronic equipment REG (electronic metering and recording equipment of temperature, radiation and lighting). The collector covered material was a polystyrol plate and different absorbers. We compared insulated and non-insulated collectors to prove that the insulated collector is more effective. The insulated collector was made of the collector surfaces faced with cellular plastic two cm plates. Our task was to calculate the air heating solar collector efficiency. The collector tracking the Sun is approximately 30% more efficient than the same type of stationary collectors in operation time for 6 hours. Insulation increases solar panel efficiency especially in windy weather. The insulated collector demonstrates almost two times higher efficiency than the non-insulated collectors (up to 93%) with absorbent material steel tinplate on top.

Tree species identification is important for a variety of natural resource management and monitoring activities especially in forest inventory. The objective of research is to identify tree species using digital aerial photography and LIDAR data in Latvian forest conditions. The study outlines a number of tree species identification possibilities: the ability to identify conifers and deciduous trees; the ability to identify pine and spruce; the ability to identify birch, aspen and black alder. The study site is a forest in the middle part of Latvia at Jelgava district (56º39’ N, 23º47’ E). Aerial photography camera (ADS 40) and laser scanner (ALS 50 II) were used to capture the data. LIDAR resolution is 9 points m-2 (500 m altitude). The image data is RGB, NIR and PAN spectrum with 20 cm pixel resolution. During the study a modified region growing algorithm was developed to determine tree canopy and tree species identification using threshold segmentation, Fourier transform, frequency filtering and reverse Fourier transform. Tree species classification of coniferous and deciduous trees is possible in 82% of the cases; the first storey of the trees can be classified correctly in 96% of the cases, but the second storey of the trees only in 49% of the cases. Spruce identification is possible in 81.1% of the cases, for first storey trees in 89.6% of the cases and for the second storey trees in 72.9% of cases. Deciduous tree correct classification is possible in 63% of the cases, birch 75%, black alder 60% and aspen only in 41% of the cases.

The stump lifting trials were implemented in 5 forest compartments of the JSC ‘’Latvia state forest’’ Vidusdaugava, Rietumvidzeme, Zemgale and Ziemeļkurzeme forestries in autumn, 2012. Total extracted area was 3.5 ha, excluding control. Two stump extraction buckets were compared in these trials – CBI (made in Canada) and MCR-500 (made in Latvia). The scope of the study was to estimate if the prototype of the MCR-500 can compete with stump lifting buckets having positive feedback from industry. Considering that the CBI head cannot prepare soil, this operation was not done by the MCR-500 either. In total 1796 stumps were marked and their main parameters were taken in all trial areas. Extracted biomass was estimated theoretically using biomass expansion factors elaborated in Nordic countries. Allegro CX field computers with SDI software were used in time studies to obtain information about productivity and distribution of productive time in a work cycle. The study demonstrated that productivity of stump extraction with both stump lifting buckets did not differ significantly in 6 cases out of total 10 comparisons.

The first independent career related decisions are made during the ninth grade of the elementary school when the further educational institution is selected. The concept of possible selves can be used in career education to help students increase self-awareness, explore and generate options, and formulate plans to achieve future goals. The aim of the article is to examine rural adolescents’ ability to generate career-related possible selves and plausible strategies to attain these possible selves. On the basis of the Possible Selves Theory, the open-ended measure was developed by the author. The pilot research was carried out in Latvia in January 2013. Forty six nine-graders from two rural elementary schools and two rural secondary schools participated in the research. Next year and adult possible selves generated by rural adolescents include such domains as education, employment, leisure activities, physical and personal development, as well as interpersonal relationships and lifestyle. The most important ones are domains of education and employment. Statistically significant differences of the results among the gender subgroups are not found in the research, statistically significant differences exist between the possible selves and their attaining strategies generated by rural secondary school students and rural elementary school students.

The most important part in forest inventory based on remote sensing data is individual tree identification, because only when the tree is identified, we can try to determine its characteristic features. The objective of research was to explore remote sensing methods to determine individual tree position using LiDAR and digital aerial photography in Latvian forest conditions. The study site was a forest in the middle of Latvia – in Jelgava district (56º39’ N, 23º47’ E). Aerial photography camera (ADS 40) and laser scanner (ALS 50 II) were used to capture the data. LiDAR resolution was 9p m2 (500 m altitude). The image data is RGB, NIR and PAN spectrum with 20 cm pixel resolution. Image processing was made using Fourier transform, frequency filtering, and reverse Fourier transform. LiDAR data processing methods was based on canopy height model, Gaussian mask, and local maxima. Field measurements were tree coordinates, species, height, diameter at breast height, crown width and length. Using combined LiDAR and optical imagery data allows detecting at least 63% of all trees and about 85% of the dominant trees.