Cultivation of Christmas trees is not a very common activity in Estonia at the moment. There are about 290 000 hectares of former agricultural and pasture lands, which are out of use in Estonia (Aastaraamat Mets 2007, 2008). Taking into account the knowhow from Europe, the hypothetical plantation was established and calculation of profitability was made. Profitability of Christmas tree cultivation was compared to the other alternative possibilities of land use. Achieving the output of saleable Christmas trees at least 50%, cultivation of Christmas trees is very competitive compared to other possibilities of land use, but at same time it is also the most capital-intensive.

In Latvia, almost 50% of all forests are privately owned. Due to hard economic situation in the 1990ies, many private forests have suffered from illegal forestry operations and overexploitation. One of economically most important tree species for private forest owners is Norway spruce. In this study the productivity of state-owned and private spruce forests was compared, assuming that the stand productivity of private forests should be lower compared to those owned by the state. Data gathered in the Forest Resource Inventory in 2004, 2005 and 2006 was used for the analysis. Total standing volume of the dominant stand and the current mean annual volume increment (CMAI) of spruce were used as main productivity indicators. The mean values of the main stand characteristics were found to be rather similar in state and private forests. The only significant differences were discovered in the mean diameter and CMAI of spruce in 60-90 years old stands; in both cases the values were higher in private forests. Site type and mixture degree were tested as the possible influencing factors. Although there were differences in the site type distribution between state and private forests, the influence of this factor on the CMAI of spruce proved to be insignificant. It was found out that the CMAI of spruce depended significantly on the mixture degree. The proportion of mixed stands in the state forests was considerably higher than in the private forests; presumably therefore the value of the CMAI in the state forests was significantly lower.

Large proportion of 30-50 years old spruce stands originated from overstocked plantations can be characterized by low growth potential and present serious problem to forest managers. Although according to legislation unproductive spruce stands can now be clearcut, possible alternative solution allowing a forest owner to remove only trees with the worst growth potential would be also welcome. To be able to recommend any silvicultural measures, information on the inner structural development of the stands is necessary. The aim of this study was to analyze temporal structure of several spruce stands that have originated from overstocked plantations and now belong to the 2nd (increased risk stands) or 3rd (unpromising stands) growth potential groups. Data for the study from seven sample plots located in Forest Research Station ''Kalsnava'' and thinned with different intensity were used. Tree diameter distribution, volume accumulation patterns and tree mortality were analyzed. Correlation between tree diameter and tree diameter difference in the observation period from 2000 to 2006 was weaker than in the observation period from 2006 to 2009, indicating further decline of growth potential. In most cases the major part of the volume was accumulated in the middle of the diameter class distribution. For most of the trees one or both sawlogs were of good or average quality. In order to develop optimal and profitable stand management model, the effect of different thinning methods in spruce stands of low growth potential should be studied in the future.

Wood based ash can be used as a liming material and fertilizer in forest, thus providing a solution for utilization of wood ash and formation of additional increment of trees, especially on organic soils, where lack of potassium and phosphorus is a well-known factor limiting the growth of trees. Yet, many studies have been made with adverse results mostly because of different soil types and species investigated. However, by now the best results on fertilization with wood ash have been found on drained peatlands, where some nutrient deficiencies have emerged. The aim of this study was to find out the growth response of Norway spruce on drained organic soils after spreading of potassium sulphate (K2SO4) and wood ash (WA). The experiment was carried out in three middle aged Norway spruce (Picea abies) stands on drained mineral and peat soil. Experiment consisted of three replications of each treatment in each stand including WA, K2SO4 and the control on 400 square meter sub-sample plots each. The diameter and height of trees were measured. The samples of increment cores were collected 4 years after fertilization to determine the additional volume increment, which varied from 8.5 m**3 haE-1 in WA plots and from 9.7 m**3 ha-1 to 17.2 m**3 haE-1 on K2SO4 plots. Both - the wood ash and potassium application - significantly increased the increment of Norway spruce on drained mineral and peat soil, although no significant differences were found between the treatments (p = 0.82, α = 0.05).

Climatic changes are shifting the potential tree distribution limits of many tree species northwards. One of such species is Fagus sylvatica, currently represented in Latvia only by a few stands. In order to increase knowledge on its potential use in the forest management, the aim of our study was to characterize the growth of beech in a young stand in the central part of Latvia. The stand of beech and spruce, mixed in rows with an initial spacing of 2.5 x 2.5 m in Oxalidosa forest type was assessed. Survival of European beech in clear cutting was similar to that observed for the native Norway spruce (73% and 79%, respectively), but both height and diameter were notably and significantly superior for wildlings at the mean age of 15 ± 2 years, reaching on average 7.4 ± 0.30 m and 8.9 ± 0.69 cm, respectively. Increasing ring width with increasing tree age for both tree species was observed until the last four years, when large and increasing superiority of beech over spruce, coinciding with reduction of ring width of spruce, was noted. It was most likely caused by intensified competition due to very wide crowns formed by young beech trees in the plantation with wide spacing: average crown radius reached 2.4 ± 0.16 m, for few trees exceeding even 4 m.

Pine, spruce and birch stem’s quality is different in regions of Latvia, but the differences are not included in the tables and models of assortment outcome. Therefore, it is not possible to predict accurately the outcome of round wood assortments. The aim of the research was to evaluate the regional differences of final felling sawlog outcome for Scots pine (Pinus sylvestris L.), Norway spruce (Picea abies (L.) Karst.) and birch (Betula spp.) in Latvia and to set the regions with a different sawlog outcome. Data from 1645 final felling areas was used for pine, 1202 for spruce and 1531 for birch from the years 2010 – 2012. Firstly, the sawlog outcome of 97 territorial units was set by using the data of the final felling areas sawlog outcome of pine, spruce and birch. Secondly, territorial units with a similar sawlog outcome were consolidated in regions. The smallest regional difference of sawlog outcome was found for spruce (9.4%), slightly larger for pine (10.5%) and the largest difference for birch (16.2%). Three regions with the different sawlog outcome were found for Scot pine, six for Norway spruce and seven for birch. Several spruces and birch regions have similar sawlog outcome but those do not have borders. They are between regions with higher or lower sawlog outcome. Sawlog outcome of neighbouring regions differ for at least 4 – 5%.

The study aims to find productivity of biofuel production in pre-commercial thinning, depending on the structure of assortments and to identify factors that influence the cost of mechanized tending of young stands. Five work methods were compared in the study, starting from standard thinning (production of sawn timber, pulpwood and firewood) with no use of accumulating device and finalizing with the biofuel method – no other assortments except biofuel are produced and the most intense use of accumulating device is considered. Accumulating device is not used for production of standard round-wood assortments. The experiments were implemented in February – March, 2013. The material produced in the study was used by ‘Graanul Pellets’ company to evaluate possibilities to use timber extracted in pre-commercial thinning of coniferous stands in production of premium class pellets. The average productivity in different stands is statistically different. The study shows that productivity of harvesting is 3.7 … 5.1 m**3 hE-1, which can be increased by more intensive use of accumulation. No difference found between work methods in forwarding trials, but productivity grows with increase of share of firewood. Average loading time 26 min, unloading 3.6 min, average load 6.0 m**3 . Prime-cost calculation shows that harvesting costs depending on the working method is in the range of 22.4 … 26.5 EUR mE-3. Comparison of potential expenses and incomes demonstrates that economically the most efficient is production of traditional assortments (sawn wood, small size sawn wood, pulp wood and firewood) with an active use of accumulating function.

According to the forecast, in future the number of storms in Latvia is going to increase. The wind and the snow are risk factors influencing damages of forests; the least tolerant species against wind damages is Picea abies (L.) Karst. It is impossible to avoid the damages caused by weather conditions – windbreaks, windthrows, snowbreaks, snow crushes and snowthrows in forests, since they reoccur in certain periods of time. The aim of the research was to analyze the impact of abiotic risk factors on the management of young Picea abies (L.) Karst. stands. Young stands of Norway spruce were researched in all regions of Latvia in 2011 and 2012. These stands were up to 40 years old. In total, 75 stands were measured and surveyed, and 257 sample plots were arranged, where the following damages were identified: frost damages, snow crushes, snowbreaks, snowthrows, windfall and windthrows. The sample plot method was used. The intensity of damages is higher on drained soils. The linear correlation between occurrence and intensity of impact damages caused by abiotic factors was significant (r = 0.988 is greater than r0.05 = 0.253). There is no significant (p = 0.686 is greater than α = 0.05) difference between the intensity of impact damages caused by abiotic risk factors in the stands with regular and irregular shapes of forest compartments. Irregular form forest plots have formed naturally, occurrence of abiotic factors there is 7.5% but the factor intensity – 6.7% and that is higher than in regular forest plots where abovementioned parameters reach 4.7% and 2.9%.

The properties of the transverse section surface of the wood are crucial when using it as an adhesive in finger joints. Contact angles of three test liquids sessile drops - water, diiodomethane and ethylene glycol - with known characteristics of surface free energy were measured on wood surface with the grain orientation 45 ° against the plane. Acid–base approach was used to calculate surface free energy and its characteristics of Scots pine (Pinus sylvestris L.) with moisture content of 21% and Norway spruce (Picea abies L. Karst) with moisture content of 10% wood samples from values of the contact angle. The wetting behavior of the wood samples was examined with the contact angle method (goniometer technique) in the Laboratory of the Department of Chemistry of Latvia University of Agriculture at the beginning of 2013. The aim of this study was to verify possibility of determining the contact angle values of the wood and calculate the surface free energy and its components of wood from the obtained contact angle values using acid-base theory. At the end of this study it was concluded that the acid–base approach is a suitable method to calculate surface free energy and its characteristics of wood from the values of the contact angle. Nevertheless, indirect methods of liquid drop contact angle value estimation must be used because direct determination is not feasible on wood surfaces with open capillaries.

Growing of economics and new technologies has caused the environment pollution and more intensive use of natural resources. The principles of stable and balanced forestry became more and more important. Ecologization forests economy directly and indirectly impacts environment, water, air, landscape. It is not allowed to use chemicals in ecological farms. In Lithuania the number of ecological farms is growing that is why the new effective ecological methods are needed to protect seedlings from weeds. Alternative to mechanical control of weed is to use high temperature. In ecological farms weed control after sowing time is pursued in mechanic, and recently in thermal way. In thermal weed control the surface of soil remains mechanically undisturbed, the roots of cultural plants remain undisturbed, too. These features are very important in forest nurseries, where different kinds of tree species are growing. Seedlings are very small at the beginning of growing, so mechanical weed control is difficult. Thermal weed control could be a good alternative. Comparable data of 2009-2011 thermal weed control research in Norway spruce (Picea abies (L.) H. Karst.) nursery is given. The efficiency of destroyed 16 weed sorts using thermal and mechanical ways of weed control is given. Thermal weed control for short age weeds is 20.3% more effective in comparison with mechanical way. Mechanical way is 35.2% more effective for perennial weeds. It was detected that in order to control weeds of different growth stages, it is necessary to use different treatment time of damp water stream.