Machining of wood of soft deciduous trees is currently based on the knowledge about cutting of wood of hard deciduous and coniferous trees and has not developed a comprehensive research methodology of cutting processes. Therefore, the objective of the study is a development of methodology for longitudinal sawing with circular saw and straight milling that would be utilized with a purpose of acquiring further knowledge on wood cutting and the improvement of cutting tool designs. Sub-objective of the study is determination of duration of cutter’s wear periods when using developed methodology. For the purpose of solving problems regarding cutting process of soft deciduous wood, the optimization of cutting tools and cutting modes were carried out in conditions that comply with the tendencies of the practise. The cutting process was carried out by a computer numerical control machine and the data acquisition by electronic measuring instruments. Aspen (Populus tremula L.) wood was used for wood samples. The methodology was developed for sawing, which complements the authors previously described methodology of the milling process investigations. Initially, only the results of periods of cutter wear and cutting velocity effects on these periods when milling process is used were obtained. It was concluded that the methodology can be used for further investigations and the critical wear period begins two times later when cutting velocity increases twice.

When the measurements of power consumed by cutting mechanism electromotor are made, the mechanical cutting power cannot be obtained, because they are different physical processes. However, determination of electricity power is relatively simpler. Therefore, both powers are determined in the study, in order to evaluate coherence between them. Computer numerical control machine was used for climb-sawing of aspen (Populus tremula L.) wood with a circular saw. Mechanical cutting power was calculated from measurements of cutting force, but the electric ones – from measurements of current and voltage. As a result, changes of both powers and of specific cutting work, on what the analytical calculation of cutting power is based, were obtained depending on length of the cutting trajectory. It is found out, that mechanical cutting power is greater than electric power, and it is useful to use for the analytical calculation, based on determination of the specific cutting work, wear coefficient of the cutter that depends not only on the duration of work of cutter, but also on feed speed and the length of the cutting trajectory.