This paper presents the results of the study on columnar aerosol optical and physical properties and radiative effects directly observed over Dushanbe, the capital city of Tajikistan, a NASA AERONET site (equipped with a CIMEL sunphotometer) in Central Asia. The average aerosol optical depth (AOD) and Ångström exponent (AE) during the observation period from July 2010 to April 2018 were found to be 0.28 ± 0.20 and 0.82 ± 0.40, respectively. The highest seasonal AOD (0.32 ± 0.24), accompanied by the lowest average AE (0.61 ± 0.25) and fine-mode fraction in AOD (0.39), was observed during summer due to the influence of coarse particles like dust from arid regions. Fine particles were found in significant amounts during winter. The ‘mixed aerosol’ was identified as the dominant aerosol type with presence of ‘dust aerosol’ during summer and autumn seasons. Aerosol properties like volume size distribution, single scattering albedo, asymmetry parameter and refractive index suggested the influence of coarse particles (during summer and autumn). Most of the air masses reaching this site transported local and regional emissions, including from beyond Central Asia, explaining the presence of various aerosol types in Dushanbe’s atmosphere. The seasonal aerosol radiative forcing efficiency (ARFE) in the atmosphere was found high (>100 Wm⁻²) and consistent throughout the year. Consequently, this resulted in similar seasonally coherent high atmospheric solar heating rate (HR) of 1.5 K day⁻¹ during summer-autumn-winter, and ca. 0.9 K day⁻¹ during spring season. High ARFE and HR values indicate that atmospheric aerosols could exert significant implications to regional air quality, climate and cryosphere over the central Asian region and downwind Tianshan and Himalaya-Tibetan Plateau mountain regions with sensitive ecosystems.

Most of the previous researches estimate influencing factors impact on air quality average without considering the heterogeneity of influential factors on different levels of air quality. In order to detect the different effects of influencing factors on air quality index (AQI) between lower-AQI and higher-AQI cities, this study applies a spatial quantile regression model (SQRM) to investigate heterogeneity of influential factors on AQI, while accounting for spatial autocorrelation of AQI. The results show that heterogeneity effects of windspeed, terrain slope, urbanization sprawl and spatial autocorrelation on AQI are large across the entire AQI spectrum, while heterogeneity effects of precipitation, temperature, relative humidity, terrain fluctuation and urbanization intensity on AQI are not obvious. The spatial positive autocorrelation of AQI in higher-AQI cities is greater than that in lower-AQI cities. Compared with higher-AQI cities, the negative impact of terrain slope on AQI is lager in lower-AQI cities. One unit increase in wind speed contributes AQI to decrease 9.31 to 5.64 then to 5.39 for lower, medium and higher-AQI cities. One unit increase in urbanization sprawl would lead AQI increase 25.6 to 15.6 then to 10.5 for lower, medium and higher-AQI cities. The heterogeneity analysis of meteorological, topographic and socioeconomic factors effects on air quality are of guiding significance for realizing the differentiation of policy measures for air pollution prevention and control.

Attenuated backscatter profiles retrieved by the space borne active lidar CALIOP on-board CALIPSO satellite were used to measure the vertical distribution of smoke aerosols and to compare it against the ECMWF planetary boundary layer height (PBLH) over the smoke dominated region of Indo-Gangetic Plain (IGP), South Asia. Initially, the relative abundance of smoke aerosols was investigated considering multiple satellite retrieved aerosol optical properties. Only the upper IGP was selectively considered for CALIPSO retrieval based on prevalence of smoke aerosols. Smoke extinction was found to contribute 2–50% of the total aerosol extinction, with strong seasonal and altitudinal attributes. During winter (DJF), smoke aerosols contribute almost 50% of total aerosol extinction only near to the surface while in post-monsoon (ON) and monsoon (JJAS), relative contribution of smoke aerosols to total extinction was highest at about 8 km height. There was strong diurnal variation in smoke extinction, evident throughout the year, with frequent abundance of smoke particles at lower height (<4 km) during daytime compared to higher height during night (>4 km). Smoke injection height also varied considerably during rice (ON: 0.71 ± 0.65 km) and wheat (AM: 2.34 ± 1.34 km) residue burning period having a significant positive correlation with prevailing PBLH. Partitioning smoke AOD against PBLH into the free troposphere (FT) and boundary layer (BL) yield interesting results. BL contribute 36% (16%) of smoke AOD during daytime (nighttime) and the BL-FT distinction increased particularly at night. There was evidence that despite travelling efficiently to FT, major proportion of smoke AOD (50–80%) continue to remain close to the surface (<3 km) thereby, may have greater implications on regional climate, air quality, smoke transport and AOD-particulate modelling.

Human exposure to particulate matter (PM) originating from air pollution is inevitable since more and more population is present in large cities that are characterized by poor air quality. The impact on human health is evident and we need to intensify research regarding this problem to get molecular insight into versatile effects of chronic exposure to PM inducing organism responses and initiating the development of selected disorders. Herein, the impact of standard PM representing urban pollution on the structure and function of human serum albumin (HSA) was evaluated by the application of various analytical techniques. HSA was selected due to its high likeliness of being exposed to PM because of the abundance of this protein in blood. The studies were focused mainly on the inorganic residue of PM resulting from removing organic components by a low-temperature plasma. To mimic physiological conditions, dialysis technique was used to simulate the release of nanoparticles and ions from PM to aqueous environment under, which in turn may interact with biomolecules inside the living system. Capture of metals from the bulk suspension was found for many metals like Al, Fe, Zn and Pb in quantities of more than 1 mol of metal ions per mole of HSA. No significant structural changes of the protein upon dialysis with PM were observed, however, an increase in the thermal stabilization of the HSA structure was observed. Moreover, the interaction of HSA dialyzed in the presence of PM with selected drugs (warfarin, aspirin) was negatively affected, indicating a lower affinity of drugs towards the protein, even though only small conformational changes of the PM exposed protein were observed. Our findings point to a possible interference of air pollutants with the drugs taken by patients living in highly polluted areas.

This study aimed to provide a comprehensive characterisation of the indoor air quality during the sleeping period of 10 couples at Lisbon dwellings, using a multi-pollutant approach, and to understand how the compliance with legislation and guidelines was to assure a good indoor air quality. The assessment of indoor air quality was conducted in the cold season using real time monitors during the sleeping period for comfort parameters (temperature and relative humidity) and air pollutants (carbon dioxide – CO₂, carbon monoxide – CO, formaldehyde – CH₂O, total volatile organic compounds – VOCs, and particulate matter – PM₂.₅ and PM₁₀), together with active sampling of bioaerosols (fungi and bacteria) before and after the sleeping period. Lower compliance (less than 50% of the cases) with the Portuguese legislation was found for temperature, CO₂ (3440 ± 1610 mg m⁻³), VOCs (1.79 ± 0.99 mg m⁻³) and both bioaerosol types. In 70% of the cases, PM₂.₅ (15.3 ± 9.1 μg m⁻³) exceeded the WHO guideline of 10 μg m⁻³. All bedrooms presented air change rates above the recommended minimum value of 0.7 h⁻¹, highlighting that a good indoor air quality during sleep is not guaranteed.

This study presents the results of an integrated model developed to evaluate the environmental and health impacts of Electric Vehicle (EV) deployment in a large metropolitan area. The model combines a high-resolution chemical transport model with an emission inventory established with detailed transportation and power plant information, as well as a framework to characterize and monetize the health impacts. Our study is set in the Greater Toronto and Hamilton Area (GTHA) in Canada with bounding scenarios for 25% and 100% EV penetration rates. Our results indicate that even with the worst-case assumptions for EV electricity supply (100% natural gas), vehicle electrification can deliver substantial health benefits in the GTHA, equivalent to reductions of about 50 and 260 premature deaths per year for 25% and 100% EV penetration, compared to the base case scenario. If EVs are charged with renewable energy sources only, then electrifying all passenger vehicles can prevent 330 premature deaths per year, which is equivalent to $3.8 Billion (2016$CAD) in social benefits. When the benefit of EV deployment is normalized per vehicle, it is higher than most incentives provided by the government, indicating that EV incentives can generate high social benefits.

There is growing evidence that the very presence of human beings in an enclosed environment can impact air quality by affecting the concentrations of certain airborne volatile organic compounds (VOC). This influence increases considerably when humans perform different activities, such as using toiletries, or simply eating and drinking. To understand the influence of these parameters on the concentrations of selected airborne constituents, a study was performed under simulated residential conditions in an environmentally-controlled exposure room. The human subjects either simply remained for a certain time in the exposure room, or performed pre-defined activities in the room (drinking wine, doing sport, using toiletries, and preparation of a meal containing melted cheese). The impact of each activity was assessed separately using our analytical platform and exposure room under controlled environmental conditions. The results showed that prolonged human presence leads to increased levels of isoprene, TVOCs, formaldehyde and, to a lesser extent, acetaldehyde. These outcomes were further supported by results of meta-analyses of data acquired during several internal studies performed over two years. Furthermore, it was seen that the indoor concentrations of several of the selected constituents rose when the recreational and daily living activities were performed. Indeed, an increase in acetaldehyde was observed for all tested conditions, and these higher indoor levels were especially notable during wine-drinking as well as cheese meal preparation. Formaldehyde increased during the sessions involving sport, using toiletries, and cheese meal preparation. Like acetaldehyde, acrolein, crotonaldehyde and particulate matter levels rose significantly during the cheese meal preparation session. In conclusion, prolonged human residence indoors and some recreational and daily living activities caused substantial emissions of several airborne pollutants under ventilation typical for residential environments.

On December 31, 2019, the Chinese authorities reported to the World Health Organization (WHO) the outbreak of a new strain of coronavirus that causes a serious disease in the city of Wuhan, China. This outbreak was classified as SARS-CoV2 and is the cause of the COVID-19 disease. On March 11, 2020, the WHO declares it a Pandemic and today it is considered the greatest challenge in global health that humanity has faced since World War II and it is estimated that between 40 and 60% of the population worldwide will catch the virus. This has caused enormous challenges in countries around the world in social, economic, environmental and obviously health issues. These challenges are mainly due to the effects of the established quarantines in almost all capitals and major cities around the world, from Asia, Europe to America. However, these lockdown which began worldwide from January 23, have had a significant impact on the environment and on the air quality of cities as recently reported by NASA (National Aeronautics and Space Administration) and ESA (European Space Agency), with reductions according to them of up to 30% in some of the epicenters such as the case of Wuhan. Knowing that air pollution causes approximately 29% of lung cancer deaths, 43% of COPD deaths, and 25% of ischemic heart disease deaths, it is important to know the effects of quarantines in cities regarding air quality to take measures that favor populations and urban ecosystems when the emergency ends. Therefore, this paper describes the behavior of PM₂.₅ emissions particulate matter from the 50 most polluted capital cities in the world according to the WHO, measured before-after the start of the quarantine. Likewise, the impact at the local and global level of this emissions behavior, which averaged 12% of PM₂.₅ decrease in these cities.

Air quality in the megacity Delhi is affected not only by local emissions but also by pollutants from crop residue burning in the surrounding areas of the city, particularly the rice straw burning in the post monsoon season. As a major burning product, gaseous CO₂, which is rather inert in the polluted atmosphere, provides an alternative solution to characterize the impact of biomass burning from a new perspective that other common tracers such as particulate matters are limited because of their physical and chemical reactiveness. Here, we report conventional ([CO₂], δ¹³C, and δ¹⁸O) and unconventional (Δ¹⁷O) isotope data for CO₂ collected at Connaught Place (CP), a core area in the megacity Delhi, and two surrounding remote regions during a field campaign in October 18–20, 2017. We also measured the isotopic ratios near a rice straw burning site in Taiwan to constrain their end member isotopic compositions. Rice straw burning produces CO₂ with δ¹³C, δ¹⁸O, and Δ¹⁷O values of −29.02 ± 0.65, 19.63 ± 1.16, and 0.05 ± 0.02‰, respectively. The first two isotopic tracers are less distinguishable from those emitted by fossil fuel combustion but the last one is significantly different. We then utilize these end member isotopic ratios, with emphasis on Δ¹⁷O for the reason given above, for partitioning sources that affect the CO₂ level in Delhi. Anthropogenic fraction of CO₂ at CP ranges from 4 to 40%. Further analysis done by employing a three-component (background, rice straw burning, and fuel combustion) mixing model with constraints from the Δ¹⁷O values yields that rice straw burning contributes as much as ∼70% of the total anthropogenic CO₂, which is more than double of the fossil fuel contribution (∼30%), during the study days.

The current air pollution by SO₂ due to anthropogenic pressure in Poland was assessed based on sulfur concentrations in pine needles (Pinus sylvestris L.). On 308 monitoring sample plots located in pine stands distributed across Poland, measurements were conducted in mineral soil layers (0–10 cm, 10–40 cm, 40–100 cm) and in the soil organic layer (+5–0 cm). Samples of Scots pine foliage (current-year needles) were then collected, and the sulfur concentration in these needles was determined. Based on these data, a map of the spatial variability of sulfur concentrations in pine needles was drawn. The mean sulfur concentration in the pine needles was 854.8 mg kg⁻¹ in dry mass. Higher SO₂ emissions were noted in regions influenced by industry, such as the Upper Silesia and regions under strong urban pressure. Sulfur concentrations in Scots pine needles were related to the stands' degrees of defoliation. A comparison of the current sulfur concentrations in pine needles from biomonitoring in 2015–2016 with those from previous biomonitoring (in 1983–1985, by Dmuchowski and Bytnerowicz (1995) showed that air quality has improved and SO₂ emissions have decreased.