Emission inventories are databases that aim to describe the polluting activities that occur across a certain geographic domain. According to the spatial scale, the availability of information will vary as well as the applied assumptions, which will strongly influence its quality, accuracy and representativeness. This study compared and contrasted two emission inventories describing the Greater Madrid Region (GMR) under an air quality simulation approach. The chosen inventories were the National Emissions Inventory (NEI) and the Regional Emissions Inventory of the Greater Madrid Region (REI). Both of them were used to feed air quality simulations with the CMAQ modelling system, and the results were compared with observations from the air quality monitoring network in the modelled domain. Through the application of statistical tools, the analysis of emissions at cell level and cell – expansion procedures, it was observed that the National Inventory showed better results for describing on – road traffic activities and agriculture, SNAP07 and SNAP10. The accurate description of activities, the good characterization of the vehicle fleet and the correct use of traffic emission factors were the main causes of such a good correlation. On the other hand, the Regional Inventory showed better descriptions for non – industrial combustion (SNAP02) and industrial activities (SNAP03). It incorporated realistic emission factors, a reasonable fuel mix and it drew upon local information sources to describe these activities, while NEI relied on surrogation and national datasets which leaded to a poorer representation. Off – road transportation (SNAP08) was similarly described by both inventories, while the rest of the SNAP activities showed a marginal contribution to the overall emissions.

[Departement_IRSTEA]Eaux [TR1_IRSTEA]BELCA | International audience | This study investigates the ability of the biodynamic model to predict the trophic bioaccumulation of cadmium (Cd), chromium (Cr), copper (Cu), nickel (Ni) and zinc (Zn) in a freshwater bivalve. Zebra mussels were transplanted to three sites along the Seine River (France) and collected monthly for 11 months. Measurements of the metal body burdens in mussels were compared with the predictions from the biodynamic model. The exchangeable fraction of metal particles did not account for the bioavailability of particulate metals, since it did not capture the differences between sites. The assimilation efficiency (AE) parameter is necessary to take into account biotic factors influencing particulate metal bioavailability. The biodynamic model, applied with AEs from the literature, overestimated the measured concentrations in zebra mussels, the extent of overestimation being site-specific. Therefore, an original methodology was proposed for in situ AE measurements for each site and metal.

no sp Assessment of Nitrogen Fluxes to Air and Water from Site Scale to Continental Scale | Modelling complex systems such as farms often requires quantification of a large number of input factors. Sensitivity analyses are useful to reduce the number of input factors that are required to be measured or estimated accurately. Three methods of sensitivity analyses (The Morris method, the rank regression and correlation method and the Extended Fourrier Amplitude Sensitivity Test method) were compared in the case of the CERES-EGC model applied to crops of a dairy farm. The qualitative Morris method provided a screening of the input factors. The two other quantitative methods were used to investigate more thoroughly the effects of input factors. The two other quantitative methods were used to investigate more thoroughly the effectos on input factors on output variables.Despite differences in terms of concepts and assumptions, the three methods provided similar results. Among the 44 factors under study, N2O emissions were mainly sensitive to the fraction of N2O emitted during denitrification, the maximum rate of nitrification, the soil bulk density and the cropland area.

International audience

International audience

peer reviewed | Monoterpenes are compounds naturally emitted by wooden materials. A preliminary study had demonstrated the occurrence of some monoterpenes in the timber frame constructions. Contrary to the active sampling, the passive sampling with Radiello® device simplifies the sampling step that is an interest in indoor environment. However, the knowledge of the sampling rate is necessary for quantification via the passive samplers Radiello®. Radiello® sampler with Tenax TA cartridge was evaluated for the 4-h concentration measurements of nine monoterpenes (α-pinene, β-pinene, d-limonene, Δ3-carene, camphene, carvone, 1,8-cineole, linalool and p-cymene). The performance parameters of the method (calibration curve, trueness, repeatability, blank level, stability of samples) were estimated. The sampling rates were first evaluated under the standard conditions in an exposure chamber. The influences of three environmental factors (temperature (T), relative humidity (RH) and concentration level (C)) on the sampling rates were also evaluated following a full factorial design at two factor levels (low and high). The monoterpenes concentrations in the exposure chamber were followed by an active sampling on tube Tenax TA. For both sampling devices, analyses were realized by TD-GC-MS. The results of this study demonstrated that the Radiello® device is suitable for the measurement of 5 of 9 studied monoterpenes. The sampling rates were defined by an equation including two factors, temperature and relative humidity. Temperature is found to be the most important factor leading to variability of the all monoterpene sampling rates. An equation allowing to estimate the sampling rate was established for every studied compound. Measurements of monoterpenes with the Radiello® device were then carried out on new wooden houses and compared with measurements obtained by active sampling on Tenax TA tubes.

International audience | Apple orchards are highly manipulated crops in which large amounts of pesticides are used. Some of these pesticides lack target specificity and can cause adverse effects in non-target organisms. In order to evaluate the environmental risk of these products, the use of transplanted sentinel organisms avoids side-effects from past events and facilitate comparison of multiple sites in a short time. We released specimens of the terrestrial snail <em>Xeropicta derbentina</em> in each 5 of two kinds of apple orchards with either conventional or organic management strategies plus in a single abandoned orchard. After one month, individuals were retrieved in order to measure acetylcholinesterase (AChE) activity. Mean values of AChE activity were significantly reduced in all conventional apple orchards compared to the others. Results show that the measurement of biomarkers such as AChE inhibition in transplated <em>X. derbentina</em> could be useful in the environmental risk assessment of post-authorized pesticides

International audience | Field plots were established at a timber treatment site to evaluate remediation of Cu contaminated topsoils with aided phytostabilization. Soil containing 2600 mg kg−1 Cu was amended with a combination of 5 wt% compost and 2 wt% iron grit, and vegetated. Sequential extraction was combined with extended X-ray absorption fine structure (EXAFS) spectroscopy to correlate changes in Cu distribution across five fractions with changes in the predominant Cu compounds two years after treatment in parallel treated and untreated field plots. Exchangeable Cu dominated untreated soil, most likely as Cu(II) species non-specifically bound to natural organic matter. The EXAFS spectroscopic results are consistent with the sequential extraction results, which show a major shift in Cu distribution as a result of soil treatment to the fraction bound to poorly crystalline Fe oxyhydroxides forming binuclear inner-sphere complexes.