Atmospheric emissions from road transport have increased all around the world since 1990 more rapidly than from other pollution sources. Moreover, they contribute to more than 25% of total emissions in the majority of the European Countries. This situation confirms the importance of road transport when complying with emission ceilings (e.g. Kyoto Protocol and National Emissions Ceilings Directive). A methodology has been developed to evaluate the effect of transport measures on atmospheric emissions (EmiTRANS). Its application to Spain in the horizon of 2020 allows the quantification of the effect of several measures on emission reductions. This quantification was done through scenario development. Several scenarios were calculated considering technical measures (e.g. vehicle scrapping systems, higher penetration of hybrid and electric vehicles, fuel substitution, etc.) and non-technical measures (mileage reduction, implementation of Low Emission Zones and/or Congestion Charges in main cities, reduction of average speeds, logistical improvements that affects heavy duty vehicle load factors, etc.). The scenarios show the effect of each measure on NOx, SO2, CO, PM10, PM2.5, VOC, CO2 and CH4 emissions. The main conclusion is the necessity to combine both technical and non-technical measures to increase global effectiveness. In the analysis of specific pollutants, there is a great dispersion on reductions effect: technical measures are more effective to reduce air pollutants while non-technical measures are better options to reduce greenhouse effect gases (even though they also reduce air pollutants in a less efficient way).

Human health problems and solutions. Urban gardening has spread worldwide in recent years as it enhances food security and selfsupply and promotes community integration. However urban soils are significantly enriched in trace elements relative to background levels. Exposure to the soil in urban gardens may therefore result in adverse health effects depending on the degree of contact during gardening, infant recreational activities and ingestion of vegetables grown in them. In order to evaluate this potential risk, 36 composite samples were collected from the top 20 cm of the soil of 6 urban gardens in Madrid. The aqua regia (pseudototal) and glycine-extractable (bioaccessible) concentrations of Co, Cr, Cu, Ni, Pb and Zn were determined by atomic absorption spectrophotometry. Additionally, pH, texture, Fe, Ca, and Mn concentrations, and organic matter and calcium carbonate contents were determined in all urban gardens and their influence on trace element bioaccessibility was analyzed.

Residues detected in pollen collected by honey bees are often used to estimate pesticide exposure in ecotoxicological studies. However, for a more accurate assessment of pesticides effect on foraging pollinators, residues found directly on flowers are a more realistic exposure approximation. We conducted a multi-residue analysis of pesticides on pollen and nectar of melon flowers collected from five fields. The cumulative chronic oral exposure Risk Index (RI) was calculated for Apis mellifera, Bombus terrestris and Osmia bicornis to multiple pesticides. However, this index could underestimate the risk since sublethal or synergistic effects are not considered. Therefore, a mixture containing three of the most frequently detected pesticides in our study was tested for synergistic impact on B. terrestris micro-colonies through a chronic oral toxicity test. According to the result, pollen and nectar samples contained numerous pesticide residues, including nine insecticides, nine fungicides, and one herbicide. Eleven of those were not applied by farmers during the crop season, revealing that melon agroecosystems may be pesticide contaminated environments. The primary contributor to the chronic RI was imidacloprid and O. bircornis is at greatest risk for lethality resulting from chronic oral exposure at these sites. In the bumblebee micro-colony bioassay, dietary exposure to acetamiprid, chlorpyrifos and oxamyl at residue level concentration, showed no effects on worker mortality, drone production or drone size and no synergies were detected when pesticide mixtures were evaluated. In conclusion, our findings have significant implications for improving pesticide risk assessment schemes to guarantee pollinator conservation. In particular, bee pesticide risk assessment should not be limited to acute exposure effects to isolated active ingredients in honey bees. Instead, risk assessments should consider the long-term pesticide exposure effects in both pollen and nectar on a range of bees that reflect the diversity of natural ecosystems and the synergistic potential among pesticide formulations.

Fertilized cropping systems are important sources of nitrous oxide (N2O) and nitric oxide (NO) to the atmosphere, and biotic and abiotic processes control the production and consumption of these gases in the soil. In fact, the inhibition of nitrification after application of urea or an ammonium-based fertilizer to agricultural soils has resulted in an efficient strategy to mitigate both N2O and NO in aerated agricultural soils. Therefore, the NO and N2O mitigation capacity of a novel nitrification inhibitor (NI), 2-(3,4- dimethyl-1H-pyrazol-1-yl) succinic acid isomeric mixture (DMPSA), has been studied in a winter wheat crop. A high temporal resolution of fluxes of NO and NO2, obtained by using automatic chambers for urea (U) and urea with DMPSA, allowed a better understanding of the temporal net emissions of these gases under field conditions. Seventy-five days after fertilization, the effective reduction of nitrification by DMPSA significantly decreased the production of NO with respect to the treatment without it, giving net consumption of NO in the soil ( 61.72 g-N ha 1 ) for U þ DMPSA in comparison to net production (227.44 g-N ha 1 ) for U. The explanation of NO deposition after NI application, due to biotic and abiotic processes in the soil-plant system, supposes a challenge that needs to be studied in the future. In the case of N2O, the addition of DMPSA significantly mitigated the emissions of this gas by 71%, though the total N2O emissions in both fertilized treatments were significantly greater than those of the control (43.69 gN ha 1 ). Regarding the fertilized treatments, no significant effect of DMPSA in comparison to urea alone was observed on grain yield nor bread-making wheat quality. To sum up, we got a significant reduction of N2O and NO with the addition of DMPSA, without a loss in yield and quality parameters in wheat.

Mediterranean Basin ecosystems, their unique biodiversity, and the key services they provide are currently at risk due to air pollution and climate change, yet only a limited number of isolated and geographically-restricted studies have addressed this topic, often with contrasting results. Particularities of air pollution in this region include high O3 levels due to high air temperatures and solar radiation, the stability of air masses, and dominance of dry over wet nitrogen deposition. Moreover, the unique abiotic and biotic factors (e.g., climate, vegetation type, relevance of Saharan dust inputs) modulating the response of Mediterranean ecosystems at various spatiotemporal scales make it difficult to understand, and thus predict, the consequences of human activities that cause air pollution in the Mediterranean Basin

A module to estimate risks of ozone damage to vegetation has been implemented in the Integrated Assessment Modelling system for the Iberian Peninsula. It was applied to compute three different indexes for wheat and Holm oak; daylight AOT40 (cumulative ozone concentration over 40 ppb), cumulative ozone exposure index according to the Directive 2008/50/EC (AOT40-D) and PODY (Phytotoxic Ozone Dose over a given threshold of Y nmol m−2 s−1). The use of these indexes led to remarkable differences in spatial patterns of relative ozone risks on vegetation. Ozone critical levels were exceeded in most of the modelling domain and soil moisture content was found to have a significant impact on the results. According to the outputs of the model, daylight AOT40 constitutes a more conservative index than the AOT40-D. Additionally, flux-based estimations indicate high risk areas in Portugal for both wheat and Holm oak that are not identified by AOT-based methods.

Emission inventories are databases that aim to describe the polluting activities that occur across a certain geographic domain. According to the spatial scale, the availability of information will vary as well as the applied assumptions, which will strongly influence its quality, accuracy and representativeness. This study compared and contrasted two emission inventories describing the Greater Madrid Region (GMR) under an air quality simulation approach. The chosen inventories were the National Emissions Inventory (NEI) and the Regional Emissions Inventory of the Greater Madrid Region (REI). Both of them were used to feed air quality simulations with the CMAQ modelling system, and the results were compared with observations from the air quality monitoring network in the modelled domain. Through the application of statistical tools, the analysis of emissions at cell level and cell – expansion procedures, it was observed that the National Inventory showed better results for describing on – road traffic activities and agriculture, SNAP07 and SNAP10. The accurate description of activities, the good characterization of the vehicle fleet and the correct use of traffic emission factors were the main causes of such a good correlation. On the other hand, the Regional Inventory showed better descriptions for non – industrial combustion (SNAP02) and industrial activities (SNAP03). It incorporated realistic emission factors, a reasonable fuel mix and it drew upon local information sources to describe these activities, while NEI relied on surrogation and national datasets which leaded to a poorer representation. Off – road transportation (SNAP08) was similarly described by both inventories, while the rest of the SNAP activities showed a marginal contribution to the overall emissions.

Noise pollution is a pervasive factor that increasingly threatens natural resources and human health worldwide. In particular, large-scale changes in road networks have driven shifts in the acoustic environment of rural landscapes during the past few decades. Using sampling plots from the Spanish Landscape Monitoring System (SISPARES), 16 km2 each, we modelled the spatio-temporal changes in road traffic noise pollution in Ecoregion 1 of Spain (approximately 66,000 km2). We selected a study period that was characterised by significant changes in the size of the road network and the vehicle fleet (i.e. between 1995 and 2014) and used standard and validated acoustic computation methods for environmental noise modelling (i.e. European Directive, 2002/49/EC) within sampling plots. We then applied a multiple linear regression to expand noise modelling throughout the whole of Ecoregion 1. Our results showed that the noise level increased by 1.7 dB(A) in average per decade in approximately 65% of the territory, decreased by 1.3 dB(A) per decade in about 33%, and remained unchanged in 2%. This suggests that road traffic noise pollution levels may not grow homogeneously in large geographical areas, maybe due to the concentration of large fast traffic flows on modern motorways connecting towns. Our research exemplifies how landscape monitoring systems such as cost-effective approaches may play an important role when assessing spatio-temporal patterns and the impact of anthropogenic noise pollution at large geographical scales, and even more so in a global context of constricted resources and limited availability of historical data on traffic and environmental noise monitoring.

A multiresidue method was developed for the simultaneous determination of 31 emerging contaminants (pharmaceutical compounds, hormones, personal care products, biocides and flame retardants) in aquatic plants. Analytes were extracted by ultrasound assisted-matrix solid phase dispersion (UA-MSPD) and determined by gas chromatography-mass spectrometry after sylilation. The method was validated for different aquatic plants (Typha angustifolia, Arundo donax and Lemna minor) and a semiaquatic cultivated plant (Oryza sativa) with good recoveries at concentrations of 100 and 25 ng g-1 wet weight, ranging from 70 to 120 %, and low method detection limits (0.3 to 2.2 ng g-1 wet weight). A significant difference of the chromatographic response was observed for some compounds in neat solvent versus matrix extracts and therefore quantification was carried out using matrix-matched standards in order to overcome this matrix effect. Aquatic plants taken from rivers located at three Spanish regions were analyzed and the compounds detected were parabens, bisphenol A, benzophenone-3, cyfluthrin and cypermethrin. The levels found ranged from 6 to 25 ng g-1 wet weight except for cypermethrin that was detected at 235 ng g-1 wet weight in Oryza sativa samples.

Zeolitic tuff constitutes a technical and economical feasible alternative to manage acidic waters in initial phases of generation. A study of cation exchange with two zeolitic tuffs from Ecuador and one from Cuba has been conducted using breakthrough curve methodology. Cations Mn2+, Cd2+, Cr3+,Zn2+, and Al3+ have been chosen owing to their presence in underground water in exploration activities (decline development)in Fruta del Norte (Ecuador). Zeolites characterized by X-ray diffraction and thermal stability after heating overnight as heulandites show a similar exchange behavior for the five cations studied. The clinoptilolite sample Tasajeras shows a relevant cation exchange performance expressed in the important increment of spatial time to reach the breakthrough point in comparison with heulandite samples. The maximum length of unused beds was found for Cr3+ and Zn2+ cations showing,therefore, a lower adsorption performance in relation with Mn2+ and Cd2+. A final disposal method of metal-loaded zeolites with cement is proposed. Keywords Natural zeolites . Acidic mine waters . Cation exchange capacity . Cation saturation curves . Metal-loaded zeolites . Cement pozzolanic additives