The impact of point and diffuse sources for 26 per- and polyfluoroalkyl substances (PFASs) in northern Europe were investigated by studying Swedish rivers (n = 40) and recipient seawater (Baltic Sea and Kattegat; n = 18). Different composition profiles were observed in the rivers, with ten rivers having a remarkably high fraction of perfluoroalkane sulfonic acids (PFSAs; 65% of the ƩPFASs) as compared to other rivers (19%) suggesting major impact of one or several source types dominated by PFSAs. Population density and low latitude (south) were strongly correlated to the widely used perfluorooctanesulfonic acid (PFOS), perfluorooctanoic acid (PFOA) as well as to perfluorohexanesulfonic acid (PFHxS). Significant relationships between several PFCAs and PFSAs (i.e. perfluorobutanoic acid (PFBA), perfluoroheptanoic acid (PFHpA), PFOA, perfluorobutanesulfonic acid (PFBS), and PFHxS) and dissolved organic carbon (DOC) were detected (p < 0.05), indicating chemical binding and co-transport with DOC in fresh water and seawater. Partial least squares regression analysis showed that perfluoroalkyl carboxylic acids (PFCAs) were related to latitude according to their perfluorocarbon chain length (C3, C7, C8, C9, C10 and C11), with longer chains associated with higher latitudes. This suggests the presence of mechanisms promoting higher prevalence of longer chained PFCAs in the north, e.g. precursor degradation, and/or aerosol associated stabilization of PFCAs and their precursors.

Contaminated sediment can release hydrophobic organic contaminants (HOCs) and thereby act as a secondary source of primarily legacy hazardous substances to the water column. There is therefore a need for assessments of the release of HOCs from contaminated sediment for prioritization of management actions. In situ assessment of HOC sediment-to-water flux is currently done with (closed) benthic flux chambers, which have a sampling time exceeding one month. During this time, the water inside the chamber is depleted of oxygen and the effect of bioturbation on the sediment-to-water release of HOCs is largely ignored. Here we present a novel benthic flux chamber, which measures sediment-to-water flux of legacy HOCs within days, and includes the effect of bioturbation since ambient oxygen levels inside the chamber are maintained by continuous pumping of water through the chamber. This chamber design allows for sediment-to-water flux measurements under more natural conditions. The chamber design was tested in a contaminated Baltic Sea bay. Measured fluxes were 62–2300 ng m⁻² d⁻¹ for individual polycyclic aromatic hydrocarbons (PAHs), and 5.5–150 ng m⁻² d⁻¹ for polychlorinated biphenyls (PCBs). These fluxes were 3–23 times (PAHs) and 12–74 times (PCBs) higher than fluxes measured with closed benthic chambers deployed in parallel at the same location. We hypothesize that the observed difference in HOC flux between the two chamber designs are partly an effect of bioturbation. This hypothesized effect of bioturbation was in accordance with literature data from experimental studies.

The release of copper (Cu) and zinc (Zn) from vessels and leisure crafts coated with antifouling paints can pose a threat to water quality in semi-enclosed areas such as harbors and marinas as well as to coastal archipelagos. However, no reliable, practical and low-cost method exists to measure the direct release of metals from antifouling paints. Therefore, the paint industry and regulatory authorities are obliged to use release rate measurements derived from either mathematical models or from laboratory studies. To bridge this gap, we have developed a novel method using a handheld X-Ray Fluorescence spectrometer (XRF) to determine the cumulative release of Cu and Zn from antifouling paints. The results showed a strong linear relationship between XRF Kα net intensities and metal concentrations, as determined by ICP-MS. The release of Cu and Zn were determined for coated panels exposed in harbors located in the Baltic Sea and in Kattegat. The field study showed salinity to have a strong impact on the release of Cu, i.e. the release increased with salinity. Contrary, the effect of salinity on Zn was not as evident. As exemplified in this work, the XRF method also makes it possible to identify the governing parameters to the release of Cu and Zn, e.g. salinity and type of paint formulation. Thus, the XRF method can be used to measure environmentally relevant releases of metallic compounds to design more efficient and optimized antifouling coatings.

Despite their ban on small vessels in 1989 in the EU, organotin compounds (OTCs) are still being released into the environment due to their presence in historic paint layers on leisure boats. 23 paint samples scraped from recreational boats from three countries around the Baltic Sea were analyzed for total tin (Sn) and OTCs. Two antifouling paint products were also subjected to the same analyses. A new method for the detection of Sn in paint flake samples was developed and found to yield more accurate results compared to four different acid digestion methods. A new method was also developed for the extraction of OTCs from ground paint flakes. This endeavor revealed that existing methods for organotin analysis of sediment may not have full recoveries of OTCs if paint flakes are present in the sample. The hull paint samples had Sn concentrations ranging from 25 to 18,000 mg/kg paint and results showed that tributyltin (TBT) was detected in all samples with concentrations as high as 4.7 g (as Sn)/kg paint. TBT was however not always the major OTC. Triphenyltin (TPhT) was abundant in many samples, especially in those originating from Finland. Several other compounds such as monobutyltin (MBT), dibutyltin (DBT), tetrabutyltin (TeBT), monophenyltin (MPhT) and diphenyltin (DPhT) were also detected. These could be the result of degradation occurring on the hull or of impurities in the paint products as they were also identified in the two analyzed paint products. A linear correlation (r2 = 0.934) was found between the total tin content and the sum of all detected OTCs. The detection of tin can therefore be used to indicate the presence of OTCs on leisure boats.

Levels of neurotoxic methylmercury (MeHg) in phytoplankton are strongly associated to water MeHg concentrations. Because uptake by phytoplankton is the first and largest step of bioaccumulation in aquatic food webs many studies have investigated factors controlling seasonal changes in water MeHg concentrations. However organic matter (OM), widely accepted as an important driver of MeHg production and uptake by phytoplankton, is known for strong interannual variability in concentrations and composition within systems. In this study, we explore the role of OM on spatial and interannual variability of MeHg in a subarctic coastal sea, the northern Baltic Sea. Using MeHg (2014: 80 ± 25 fM; 2015: <LOD fM; 2016: 21 ± 9 fM) and OM measurements during late summer/early fall, we find that dissolved organic carbon (DOC) and humic matter content explain 60% of MeHg variability. We find that while labile DOC increases MeHg levels in the water, humic content reduces it. We propose that the positive association between MeHg and labile DOC shows that labile DOC is a proxy for OM remineralization rate in nearshore and offshore waters. This is consistent with other studies finding that in situ MeHg production in the water column occurs during OM remineralization. The negative association between water humic content and MeHg concentration is most likely due to humic matter decreasing inorganic mercury (HgII) bioavailability to methylating microbes. With these relationships, we develop a statistical model and use it to calculate MeHg concentrations in late summer nearshore and offshore waters between 2006 and 2016 using measured values for water DOC and humic matter content. We find that MeHg concentrations can vary by up to an order of magnitude between years, highlighting the importance of considering interannual variability in water column MeHg concentrations when interpreting both short and long term MeHg trends in biota.

Polyurethane foam (PUF) disk passive samplers were deployed at one inland and two island locations in the Bothnian Bay region of the northern Baltic Sea. Uptake was linear over 81–147 d and a temperature range of −2.6 to 14.2 °C for organochlorine pesticides (OCPs) and current-use pesticides (CUPs) having log KOA ≥9 at ambient temperatures. Partial saturation of the PUF disks occurred for the more volatile OCPs hexachlorocyclohexanes (HCHs) and hexachlorobenzene (HCB), and for bromoanisoles (BAs), which are products of bromophenols released by natural and anthropogenic sources. Correction for nonlinear uptake of these was made using experimentally measured PUF-air partition coefficients. Passive-derived air concentrations of pesticides were uniform over the bay and agreed within a factor of 2 or better with levels determined by active (pumped) sampling at one of the island stations. Levels of OCPs were similar to those reported at background sites in the European and Canadian Arctic and at monitoring stations in the central Baltic and southern Scandinavia, indicating long-range transport. The insecticide chlorpyrifos was 10 times lower at bay stations than in the Canadian Arctic. Insight to sources and processes was gained by examining compound profiles. Fractions Falpha = α-HCH/(α-HCH + γ-HCH) and FTC = trans-chlordane/(trans-chlordane + cis-chlordane) at bay stations were higher than in the Norwegian and Finnish Arctic and similar to those at the southern monitoring stations. Volatilization of chlordanes from Baltic seawater may also modify FTC. Higher FTriBA = 2,4,6-TriBA/(2,4,6-TriBA + 2,4-DiBA) distinguished local volatilization from the Baltic Sea versus lower FTriBA found at the inland site and reported in air on the Norwegian coast, suggesting westerly transport from the Atlantic across Norway and Sweden.

The abundance, weight and composition of marine debris were determined at the northwest coast of the Isle of Rügen in 2015. A total number of 1115 macrolitter items were registered, resulting in an abundance of 304±88.96 items per 100m of beach length and therefore being greater than the abundances found for other beaches at the Baltic Sea. Macrolitter items were predominantly composed of plastic, on average 83%. The four beaches under investigation have different exposition as well as touristic levels. The differing influence of wind and water currents as well as recreational activities on the macrolitter at these beaches was detectable. The distribution of items within a beach segment was analyzed by implementing D-GPS and drone aerial photography. The results of this analysis suggested that the identity of the substrate as well as the presence of vegetation are both major influencing factors in the macrolitter distribution.

Two LC-MS/MS methods including different sample preparation and quantitative processes showed a good agreement for analysis of the herbicides MCPA, mecoprop, isoproturon, bentazon and chloridazon, and the metabolite chloridazon-methyl-desphenyl (CMD) in estuarine waters. Due to different sensitivity of the methods only one could be used to analyze marine samples. The transport of these compounds to the Baltic Sea via ten German estuaries and their distribution between coastal water and sediments was studied. The results showed that all selected compounds can be transported to the Baltic Sea (0.9–747ng/L). Chloridazon, bentazon, isoproturon and CMD were detected (0.9–8.9ng/L) in the coastal waters and chloridazon and isorproturon in the sediments (5–136pg/g d.w.). Levels of contaminants in the sediments could be influenced by the total organic carbon content. Concentrations observed in the Baltic Sea are most likely not high enough to cause acute effects, but long term effect studies are strongly recommended.

Contamination of sandy beaches of the Baltic Sea in Kaliningrad region is evaluated on the base of surveys carried out from June 2015 to January 2016. Quantity of macro/meso/microplastic objects in the upper 2cm of the sandy sediments of the wrack zone at 13 sampling sites all along the Russian coast is reported. Occurrence of paraffin and amber pieces at the same sites is pointed out. Special attention is paid to microplastics (range 0.5–5mm): its content ranges between 1.3 and 36.3 items per kg dry sediment. The prevailing found type is foamed plastic. No sound differences in contamination are discovered between beaches with high and low anthropogenic load. Mean level of contamination is of the same order of magnitude as has been reported by other authors for the Baltic Sea beaches.

The occurrence of pharmaceuticals and personal care products (PPCPs) in the marine environment is of great concern. This study was done to determine the emergence of eight pharmaceuticals and eleven ultraviolet filters (UV-Filters) in 5 rivers/streams discharging into the Baltic Sea. Furthermore, a focus was put on the influence of wastewater treatment plant as indirect source and the occurrence of the PPCPs in close beach proximity. Two pharmaceuticals (sulfamethoxazole, salicylic acid) and two UV-filters (2-phenylbenzimidazole-5-sulfonic acid, octocrylene) were detected in all analyzed water samples, with concentration ranging from 0.6ng/L to 836.3ng/L. In all rivers the PPCP concentration decreases towards the Baltic Sea. Sulfamethoxazole was detected at comparable concentration along the coast, which leads to the assumption of stable concentration in beach proximity. Along the coast UV-filters appeared in varying concentrations, leading to the conclusion that the direct input into the marine environment plays a bigger role than the indirect input.