Arsenic (As) contamination and bioaccumulation are a serious threat to agricultural plants. To address this issue, we checked the efficacy of As tolerant plant growth promoting bacteria (PGPB), zinc oxide nanoparticles (ZnO NPs) and oxalic acid (OA) in Luffa acutangula grown on As rich soil. The selected most As tolerant PGPB i.e Providencia vermicola exhibited plant growth promoting features i.e solubilzation of phosphate, potassium and siderophores production. Innovatively, we observed the synergistic effects of P. vermicola, ZnO NPs (10 ppm) and OA (100 ppm) in L. acutangula grown on As enriched soil (150 ppm). Our treatments both as alone and in combination alleviated As toxicity exhibited by better plant growth and metabolism. Results revealed significantly enhanced photosynthetic pigments, proline, relative water content, total sugars, proteins and indole acetic acid along with As amelioration in L. acutangula. Furthermore, upregulated plant resistance was manifested with marked reduction in the lipid peroxidation and electrolyte leakage and pronounced antagonism of As and zinc content in leaves under toxic conditions. These treatments also improved level of nutrients, abscisic acid and antioxidants to mitigate As toxicity. This marked improvement in plants’ defense mechanism of treated plants under As stress is confirmed by less damaged leaves cell structures observed through the scanning electron micrographs. We also found substantial decrease in the As bioaccumulation in the L. acutangula shoots and roots by 40 and 58% respectively under the co-application of P. vermicola, ZnO NPs and OA in comparison with control. Moreover, the better activity of soil phosphatase and invertase was assessed under the effect of our application. These results cast a new light on the application of P. vermicola, ZnO NPs and OA in both separate and combined form as a feasible and ecofriendly tool to alleviate As stress in L. acutangula.

Antibiotic mycelial fermentation residues (AMFRs), which are emerging solid pollutants, have been recognized as hazardous waste in China since 2008. Nitrogen (N), which is an environmental sensitivity element, is largely retained in AMFR samples derived from fermentation substrates. Pyrolysis is a promising technology for the treatment of solid waste. However, the outcomes of N element during the pyrolysis of AMFRs are still unknown. In this study, the conversion of N element during the pyrolysis of AMFRs was tracked using XPS (X-ray photoelectron spectroscopy) and online TG-FTIR-MS (Thermogravimetry-Fourier transform infrared-Mass spectrometry) technology. In the AMFR sample, organic amine-N, pyrrolic-N, protein-N, pyridinic-N, was the main N-containing species. XPS results indicated that pyrrolic-N and pyridinic-N were retained in the AMFR-derived pyrolysis char. More stable species, such as N-oxide and quaternary-N, were also produced in the char. TG-FTIR-MS results indicated that NH3 and HCN were the main gaseous species, and their contents were closely related to the contents of amine-N and protein-N, and pyrrolic-N and pyridinic-N of AMFRs, respectively. Increases in heating rate enhanced the amounts of NH3 and HCN, but had less of an effect on the degradation degree of AMFRs. N-containing organic compounds, including amine-N, nitrile-N and heterocyclic-N, were discerned from the AMFR pyrolysis process. Their release range was extended with increasing of heating rate and carbon content of AMFR sample. This work will help to take appropriate measure to reduce secondary pollution from the treatment of AMFRs.

Hydrogen cyanide (HCN) comes from a wide range of sources, but it is highly toxic and corrosive, harming the environment and human health. This experiment used magnetic nano-Fe₃O₄ particles loaded with Cu (Cu-Fe₃O₄ magnetic nanoparticles) for electrochemical catalytic purification of HCN in a liquid phase pseudo-homogeneous system. The results show that the purification efficiency of Cu-Fe₃O₄ magnetic nanoparticles on HCN is 70% without electricity. After a certain voltage is applied, the degradation efficiency of 2 h with iron-carbon particles is significantly improved, and the degradation efficiency can reach about 95%. And the degradation efficiency increases with the increase of voltage. The electrochemical synergistic degradation mechanism of Cu-Fe₃O₄ magnetic nanoparticles is complex, which can directly catalyze the degradation of HCN or form CNO⁻ intermediates to further degrade into CO₂, H₂O, and NH₃. Meanwhile, Fe²⁺, Cu⁺, and other transition metal ions in the liquid phase participate in the Fenton-like reaction to further degrade HCN. The results show that the synergistic electrochemical degradation of HCN by Cu-Fe₃O₄ magnetic nanoparticles has excellent potential to degrade highly toxic gases.

The accumulation of heavy metal in the soil is a serious concern for sustainable food production due to their toxic effects on plants and other living things. The strategies are required on urgent bases for the management of metal-contaminated soils. Thus, the microbes from the genus Pseudomonas were characterized for different traits and lead (Pb)-resistant ability and their effects were assessed on growth, photosynthesis, antioxidant capacity, and Pb uptake by dill (Anethum graveolens L.). Furthermore, soil basal respiration and induced respiration in soil were also assessed under microbes and Pb stress. Among the tested three strains, Pseudomonas P159 and P150 were more tolerant to Pb stress than Pseudomonas P10, whereas P159 showed the highest values for phosphorus (P), siderophore, auxin, and hydrogen cyanide production. The bacterial inoculation increased the plant shoot dry weights, carbohydrates, proline, and chlorophyll contents under Pb stress. The catalase (CAT) and peroxidase (POD) activities of the plants were higher in bacterial-treated plants than control. The bacterial inoculation decreased Pb concentration in plants, and the response varied with the type of microbes. The bacterial strains enhanced the soil basal and induced respiration than respective Pb treatments alone. Overall, Pseudomonas P159 is potentially suitable for the remediation of Pb-contaminated soils. Graphical abstract

Volatile organic compounds (VOCs) decomposition by non-thermal plasma (NTP) has been receiving increasing attention from the scientific communities due to its advantages of easy operation, high efficiency, energy saving, and non-secondary pollution. But most of the researches are doing experiments and existing experiment methods cannot observe the micro physical and chemical processes. In order to make up for the deficiency of the experiment, herein, a numerical method was developed to analyze the decomposition behavior of HCN, C₃H₃N, C₃H₈, C₃H₆, CO, and NO in the VOCs treatment by NTP. Results indicated that increasing electron density or energy was beneficial to VOCs decomposition, but when the electron density and energy was too high, the promotion would be weakened. The influences of initial concentration of O₂ and H₂O on different VOCs decomposition were totally different. The increase of initial concentration of oxygen was beneficial to the decomposition of HCN, C₃H₈, CO, and NO, but the high concentration of oxygen could promote to generate C₃H₆ at the initial reaction stage. The decomposition of HCN and C₃H₃N are not restricted by dry or wet conditions, but the increase of the concentration of water vapor is advantageous to the decomposition of C₃H₈, CO, and NO. Graphical Abstract ᅟ

Stack gases of wood and oil burning boilers were analyzed by a low resolution FT-IR gas analyzer. Concentrations of carbon dioxide (CO₂), carbon monoxide (CO), nitric oxide (NO), nitrogen dioxide (NO₂), nitrous oxide (N₂O), hydrogen cyanide (HCN), sulfur dioxide (SO₂), methane (CH₄), and water vapor (H₂O) were predicted in real time by multicomponent analysis. Detection limits, linearity, analysis accuracy and long time repeatability were experimentally determined for selected gas components. Applicability of the measurement method was demonstrated by analysis of stack gas mixtures of known concentrations. The results indicate that all the primary stack gas components can be measured by the low resolution FT-IR gas analyzer with comparable results to single component measurement methods.

Hydrogen cyanide (HCN) is volatile and highly toxic with acute and chronic effects on humans. Gaseous HCN enters the atmosphere from natural processes or industrial activities, which lead to human exposure. Effective intervention in cases of HCN inhalation requires an efficient diagnostic tool. The existing physiologically based pharmacokinetic (PBPK) model for HCN cannot clearly simulate continuous HCN inhalation or predict HCN levels in inhaled air. The current study presents a PBPK model for continuous inhalation of HCN, called Human Continuous Cyanide Inhalation Predictor (HCCIP). Since existing data on pharmacokinetics of HCN inhalation are limited, HCCIP utilizes extensive data from the current authors’ PBPK model on cyanide ingestion. The structure of HCCIP comprises the lungs, kidneys, liver, and slowly perfused tissue. In both the human body and in exhaled air, HCCIP features the ability to predict concentration-time courses of cyanide. Moreover, HCCIP can predict HCN concentration in inhaled air from known blood cyanide levels. After completion, the results of HCCIP were validated against preexisting published datasets. The simulation results agreed with these datasets, validating the model. The HCCIP model is an effective tool for assessing risk from continuous HCN inhalation, and HCCIP extends the capabilities of air dispersion modeling, such as AERMOD or CALPUFF, to assess HCN risk from specific release sources.

The removal of cyanide compounds in soil by leaching was investigated in flask and column tests. All the experiments were conducted under alkaline conditions to prevent loss of hydrogen cyanide. Results showed that leaching progressed rapidly when the leaching temperature or the initial cyanide concentration was high. The obtained cyanide data in the flask test fitted an inner diffusion process, as described by a shrinking core model. In the batch column test, the cyanide concentration decreased from 44.06 to 9.86 mg/kg when the leaching intensity was 79 L/(m² h) after 23.8 h leaching. The leaching process for the cyanide compounds was divided into two stages according to the batch column test despite the decrease in the leaching velocity as the cyanide concentration in soil declined. Cyanide removal in the batch column test was better than that in the flask test due to the higher gradient of cyanide concentration. The aqueous solution containing cyanide compounds was decomposed effectively by the hybrid process of ozone and UV rays. Furthermore, the leaching and decomposition of the soil and leaching wastewater were performed with a continuous column test with circulating leaching liquid. The cyanide compounds in the soil and wastewater were removed effectively.

The NO emission characteristics of Datong bituminous coal and Yangquan anthracite in O₂/H₂O/CO₂ atmospheres were investigated by using a fixed-bed reactor system, and the emission characteristics were compared with the experimental results from O₂/N₂ and O₂/CO₂ atmospheres, especially at low O₂ concentrations and high temperatures. The results showed that NO emissions of pulverized coal in O₂/CO₂ environments were less than those in the O₂/N₂ environments, regardless of the O₂ concentration and the furnace temperature. Adding H₂O decreased the possibility of reactions between the reductive groups (NH) and the oxygen radical during devolatilization, which led to a decrease in NO emissions at 1000 °C. However, as the furnace temperature increased, “additional” nitrogen precursors (HCN and NH₃) generated by enhanced char-H₂O gasification were quickly oxidized to generate a large amount of NO during char oxidation that exceeded the amount of NO reduced by NH during devolatilization. Thus, the NO emissions in O₂/CO₂/H₂O atmosphere were higher than those in O₂/CO₂ atmosphere at a low O₂ concentration. However, as the O₂ concentration increased, the NO emissions in O₂/CO₂/H₂O atmosphere became lower than those in O₂/CO₂ atmosphere because the effect of H₂O gasification became weaker. The NO emissions of Yangquan anthracite (YQ) were higher than those of DT, but the changing trend of YQ was similar to that of DT.

Due to its high adaptability, cassava (Manihot esculenta Crantz) is one of the world’s most cultivated and consumed plants after maize and rice. However, there are relatively few scientific studies on this important crop. The objective of this review was therefore to summarize and discuss the available information on cassava cropping in order to promote sustainable practices in terms of production and consumption. Cassava cultivation has been expanding recently at the global scale and is widely consumed in most regions of South America, Africa, and Asia. However, it is also characterized by the presence in its roots of potentially toxic hydrocyanic acid. Furthermore, cassava can also absorb pollutants as it is currently cultivated near roads or factories and generally without consideration for potential sources of soil, water, or atmospheric pollution. Careful washing, peeling, and adequate preparation before eating are therefore crucial steps for reducing human exposure to both environmental pollutants and natural hydrocyanic acid. At present, there is not enough precise data available on this staple food crop. To improve our knowledge on the nutritive benefits versus health risks associated with cassava consumption, further research is necessary to compare cassava cultivars and precisely study the influence of preparation methods.