Serious pollution is caused by heavy metals (HMs) emission during sludge combustion treatment, but the addition of minerals has the ability to alleviate the migration of HMs to the gaseous state. In this study, HMs (As, Cr, Zn and Cu) behavior, speciation, and environmental risk during sludge combustion with CaO and montmorillonite (MMT) additive was investigated in the lab-scale tube furnace. The results showed that the sludge combustion was mainly determined by volatile matter. In general, CaO inhibited the volatilization of Cr, Zn, and Cu, but promoted As volatilization. MMT inhibited the volatilization of HMs, but the effect was not obvious at high temperatures. Besides, the improvement of retention effect was not found for Cr and Cu with the increase of CaO at 1000 °C, there might exist threshold value for CaO on HMs retention process. Meanwhile, CaO increased acid-soluble fraction of As significantly at high temperatures, decreased residual fraction of Cr by oxidation, converted Zn and Cu to residual fraction. MMT increased the acid-soluble fraction of As and residual fraction of Cr. In view of the HMs environmental risk in ash, the combustion temperature of sludge was necessary to control under 1000 °C and minerals additive amount was needed to manage above 1000 °C.

The long-term use of animal manure in agriculture has resulted in estrogen pollution, which poses risks to facility vegetable soils. Owing to the complex soil composition, estrogen may exhibit a variety of behaviors at the water/soil interface. This study demonstrated the role of humic acid (HA) on the 17β-estradiol (E2) adsorption by clay minerals (montmorillonite, kaolinite, and hematite). The interfacial behaviors were investigated using adsorption kinetics and isotherms data. Then, the effects of temperature, pH, and bisphenol A (BPA) on the interactions between humic-mineral complexes and E2 were explored. The adsorption of E2 is an exothermic and spontaneous process, and the addition of HA to minerals significantly promoted their E2 adsorption capacities. Higher pH levels (>10) and the presence of BPA decreased the adsorption capacities of minerals and mineral complexes for E2. Moreover, intercalation, hydrophobic partitioning, π-π interactions and hydrogen bonding could dominate the E2 adsorption onto complexes. These results provided insight into the interfacial behaviors of E2 on the surfaces of humic-mineral complexes and promoted the understanding of the migration and transport of estrogens in soils.

Iron-bearing clays are ubiquitously distributed as mineral dusts in the atmosphere. Bromophenols were reported as the major products from thermal decomposition of the widely used brominated flame retardants (BFRs). However, little information is available for the reactivity of iron associated with mineral dusts to interact with the atmospheric bromophenols and the subsequent toxic effects. Herein, three common clay minerals (montmorillonite, illite and kaolinite) were used to simulate mineral dusts, and the reactions with gaseous 2-bromophenol were systematically investigated under environmentally relevant atmospheric conditions. Our results demonstrate that structural Fe(III) in montmorillonite and Fe(III) from iron oxide in illite mediated the dimerization of 2-bromophenol to form hydroxylated polybrominated biphenyl and hydroxylated polybrominated diphenyl ether. The surface reaction is favored to occur at moisture environment, since water molecules formed complex with 2-bromophenol and the reaction intermediates via hydrogen bond to significantly lower the reaction energy and promote the dimerization reaction. More importantly, the formed dioxin-like products on clay mineral dust increased the toxicity of the particles to A549 lung cell by decreasing cell survival and damaging cellular membrane and proteins. The results of this study indicate that not only mineral dust itself but also the associated surface reaction should be fully considered to accurately evaluate the toxic effect of mineral dust on human health.

Bacteria–phyllosilicate complexes are commonly found in natural environments and are capable of immobilizing trace metals. However, the molecular binding mechanisms of heavy metals to these complex aggregates still remain poorly understood. This study investigated Cd adsorption on Gram-positive Bacillus subtilis, Gram-negative Pseudomonas putida and their binary mixtures with montmorillonite using surface complexation model, Cd K-edge extended X-ray absorption fine structure (EXAFS) spectroscopy and isothermal titration calorimetry (ITC). We have shown that larger amounts of Cd are adsorbed by B. subtilis than by P. putida at pH<∼6, and Cd sorption that binding to phosphate groups plays a more important role in P. putida than in B. subtilis. This remind us that we should consider the microbe species when predict the biochemical behavior of trace metals in microbe-bearing environments. The observed Cd adsorption on the binary bacteria–clay composites was more than that predicted based on the component additivity approach. When taking bacteria–clay (1:1 mass ratio) as a representative example, an approximately 68%:32% metal distribution between the bacterial and mineral fraction was found. Both the EXAFS and ITC fits showed that the binding stoichiometry for Cd-carboxyl/phosphate was smaller in the binary mixtures than that in pure bacteria. We proposed that the significant deviations were possibly due to the physical-chemical interaction between the composite fractions that might reduce the agglomeration of the clay grains, increase the negative surface charges, and provide additional bridging of metals ions between bacterial cells and clays.

The synthesis of clay-biochar composite has been recognized as an effective way to enhance the removal of pollutants. The interaction between clay mineral and biomass during thermal pyrolysis and the sorption capacity for ionic/nonionic organic containments have not been elaborated. In this study, two types of biochar were obtained from pyrolytic carbonization of the cellulosic-rich corn straw (C) and lignin-rich pine wood (P) at 500 or 700 °C. Typical clay minerals kaolinite and montmorillonite were selected to prepare clay-biochar composite. The results showed that the addition of clay mineral could strengthen dehydration reaction of corn straw biomass and reinforce its carbon structure. Montmorillonite-biochar composite owned more CC functional groups and porous structure than kaolinite-biochar composite. The addition of clay minerals could promote electrostatic attraction of ionic formed norfloxacin (NOR) on clay-pine wood biochar. However, the sorption capacity of nonionic diethyl phthalate (DEP) adsorption on clay-corn straw biochar decreased, owing to that clay increased the compactness of the biochar carbon structure, thus inhabited hydrophobic partition of nonionic organic compounds on disordered carbon fraction. The results from this study provide insights into the suitable contaminated site remediation by clay-biochar composite.

Heavy metal pollution is very common in soils. Soils are complex systems including minerals, bacteria, and various other substances. In Cd(II) contaminated soil, the combined effects of clay minerals and heavy metals on bacterial biofilm and Cd(II) adsorption are unappreciated. Our study showed that the combination of clay minerals (goethite, kaolinite, and montmorillonite) and heavy metals promoted Serratia marcescens S14 biofilm development significantly more than clay minerals or Cd(II) alone. The amount of biofilm after binary treatment with clay minerals and Cd(II) was 2.3–7.3 times than that in control. Mineral-induced cell death and the expression of the fimA, bsmA, and eps were key players in biofilm formation. Binary treatment with montmorillonite and Cd(II) significantly enhanced biofilm development and consequently increased the adsorption of Cd(II). Cd(II) removal is the result of co-adsorption of bacteria and minerals. Bacterial biofilm played an important role in Cd(II) adsorption. FTIR spectroscopy showed the components of biofilm were not affected by minerals and revealed the functional groups –OH, –NH, –CH₂, –SH, –COO participated in Cd(II) immobilization. Our findings are of fundamental significance for understanding how minerals and Cd(II) affect biofilms and thereby enhance Cd(II) adsorption and predicting the mobility and fate of heavy metals in heavy metal-contaminated soil.

High-performance two-dimensional montmorillonite supported-poly (acrylamide-co-acrylic acid) hydrogel for dye removal was investigated. Montmorillonite cooperated with acrylamide and acrylic acid via polymerization, hydrogen-bond, amidation and electrostatic interactions to form the three-dimensional reticular-structured hydrogel with the free entrance for macromolecules. Adsorption tests revealed that the efficient removal (97%) for methylene blue at high concentration (200 mg/L) could be achieved via a small dose of hydrogel (0.5 g/L) within a short time (20 min). The excellent adsorption performance was profited from the electronegative surface and fully exposed reaction sites of two-dimensional montmorillonite, which could save the treatment cost and promote the removal effect compared with the conventional adsorbents. The adsorption process of methylene blue onto hydrogel could be fitted by both the pseudo-first-order and pseudo-second-order kinetics models, and the adsorption isotherm corresponded to the Sips model. The mechanism analysis based on Fourier transform infrared spectroscopy and X-ray photoelectron spectroscopy measurements illustrated that the reaction between carboxyl groups and methylene blue molecules as well as the cation-exchange enabled the hydrogel performing extraordinary adsorption efficiency.

Copper oxide nanoparticles (CuO NPs) is one of the most commonly used metal oxide nanoparticles for commercial and industrial products. An increase in the manufacturing and use of the CuO NPs based products has increased the likelihood of their release into the aquatic environment. This has attracted major attention among researchers to explore their impact in human as well as environmental systems. CuO NPs, once released into the environment interact with the biotic and abiotic constituents of the ecosystem. Hence the objective of the study was to provide a holistic understanding of the effect of abiotic factors on the stability and aggregation of CuO NPs and its correlation with their effect on the development of zebrafish embryo. It has been observed that the bioavailability of CuO NPs decrease in presence of humic acid (HA) and heteroagglomeration of CuO NPs occurs with clay minerals. CuO NPs, CuO NPs + HA and CuO NPs + Clay significantly altered the expression of genes involved in development of dorsoventral axis and neural network of zebrafish embryos. However, the presence of HA with clay showed protective effect on zebrafish embryo development. These findings provide new insights into the interaction of NPs with abiotic factors and combined effects of such complexes on developing zebrafish embryos genetic markers.

Increasing interests in carbon dots (CDs) research resulted in the increased production of CDs and the risk to be released into the environment, including surface water and groundwater. To assess the environmental behavior of CDs, the stability of CDs in aqueous solutions were first examined by different environmental conditions, followed by the systematic investigation of the adsorption behaviors of CDs onto Al2O3 surface. Electrostatic interactions were considered as the dominant forces in CDs adsorption onto Al2O3 process, which were further confirmed by controlling experiments as compared with other minerals or oxides, such as montmorillonite, kaolinite and SiO2. Theoretical calculations and characterization of Al2O3/CDs revealed chemisorptions exist in the adsorption process. Our investigation results provided fundamental understanding towards the interaction of CDs with Al2O3 surface, and potential fate of CDs under natural conditions in aquatic environment, as well as in soils and sediments.

The fractionation and speciation of As in a contaminated soil were investigated, and a remediation strategy was tested. Regarding speciation, we found that As(V) prevails over As(III) whereas more than 40% of total arsenic is in organic form. The fractionation of As was investigated with two sequential extraction methods: a low mobility was found. Then we tested the possibility of using phosphoric acid to extract As from the soil and cleaning the washing effluents by sorption onto montmorillonite. The efficiency of the extraction and of the adsorption onto the clay were also investigated for Cr, Cu, Fe, Mn, Ni, Pb and Zn, whose total concentrations and fractionation in the soil are reported here. The extraction percentages for As and metals ranged from 30 to 65%; the residual proportions in the soil are presumably in very unreactive forms. Montmorillonite showed a good uptake capacity towards the investigated pollutants. Arsenic in a contaminated soil was present in different forms and it was extracted by soil washing followed by effluent treatment by sorption onto a natural clay.