Colony formation is an essential stage of cyanobacterial blooms. High calcium concentration can promote Microcystis aeruginosa aggregation behavior, but the mechanism of colony formation caused by calcium has rarely been reported. In this study, high calcium-induced colony formation was identified as a shift from cell adhesion to cell division, rather than only cell adhesion as previously thought. Algae responded to this calcium-induced environmental pressure by aggregating and forming colonies. Algal cells initially secreted large quantities of extracellular polysaccharides (EPS) and rapidly aggregated by cell adhesion. The highest aggregation proportion was up to 68.93%. However, high calcium concentrations cannot completely inhibit algal cell growth, but only delay the algae into the rapid growth phase. With adaption to calcium and existing high EPS content, the daughter cells reduced EPS synthesis and the aggregation proportion decreased. The increasing growth rate was also responsible for the decreased xylose content in EPS. The mechanism of colony formation changed to cell division. The downregulation of genes related to EPS secretion also supported this hypothesis. Overall, these results can benefit for our understanding of cyanobacterial bloom formation.

Spherical biochar derived from saccharides (glucose, sucrose, and xylose) was prepared through two steps: pre-hydrothermal carbonization at 190 °C and calcination at low temperatures (200–325 °C). The spherical biochar was characterized by Brunauer–Emmett–Teller (BET) surface area analysis, Fourier transform infrared spectroscopy, zeta potential, scanning and transmission electron microscopies, and X-ray diffraction. The result indicated that the spherical biochar exhibited low S BET (15–22 m²/g), but abundant superficial active oxygen-containing functional groups. The spherical biochar possessed a negatively charged surface within solution pH 2.0–11. The adsorption process of Pb²⁺, Cu²⁺, and methylene green 5 (MG5) was strongly dependent on the solution pH and reached fast equilibrium at approximately 60 min. The maximum Langmuir adsorption capacity (Q°ₘₐₓ) exhibited the following order: glucose-biochar > sucrose-biochar > xylose-biochar prepared at 300 °C. The selective adsorption order of glucose-biochar was Cu²⁺ (0.894 mmol/g) > Pb²⁺ (0.848 mmol/g) > MG5 (0.334 mmol/g). The electrostatic attraction played a determining role in the adsorption mechanism of pollutant cations. The adsorption of anionic dye (acid red 1) on the spherical biochar was negligible because of electrostatic repulsion. The spherical biochar can serve as a newer and promising adsorbent to remove toxic pollutant cations from water media.

In this study, the influences of organic carbon sources (OCS, including xylose, glucose, maltose, sucrose, and starch) and inorganic and organic nitrogen sources (INS, including ammonia chloride and sodium nitrate; ONS, including arginine, alanine, proline, and valine) and metal ions (including Na⁺, K⁺, Mn²⁺, Zn²⁺ and Cu²⁺) on the growth, lipid accumulation, and nitrogen and phosphorus (N&P) removal capabilities of oleaginous Scenedesmus sp. LX1 under heterotrophic conditions were investigated. The results showed that glucose was the only OCS for Scenedesmus sp. LX1 to grow well with specific growth rate of 0.935 days⁻¹, maximum biomass of 1.72 g L⁻¹, and largest removal rates of N&P and organic carbon reaching 72.228%, 93.034%, and 19.208%, respectively. After 11 days of cultivation, the maximal biomass reached in the group with starch or glucose while maximal lipid and triacylglycerol (TAG) yields reached in the groups with maltose and sucrose, respectively. Sodium nitrate was best nitrogen source as the largest algal density, maximal yields of lipids and TAGs, and highest N&P removal rates reached up to 1.105 × 10⁷ cells·mL⁻¹, 196.70 mg L⁻¹, 5.19 mg L⁻¹, 89.61% and 100%, respectively. Scenedesmus sp. LX1 was found to have great tolerance to Na⁺, K⁺, Mn²⁺, and Zn²⁺ while 0.5 mg L⁻¹ Cu²⁺ had a strong inhibition on growth and N&P removal rate of Scenedesmus sp. LX1. Concentration increasing of five metal ions all caused the yield increases of microalgal lipid and TAGs. Graphical abstract

Effectiveness of steam explosion (SE) pretreatment for deconstructing the complex structural carbohydrates (SC) and lignin recalcitrance properties of rice straw (RS) for conjunctive improvement of biofuel yield and waste valorization was evaluated. This work exhibited successful pretreatment of RS at a different pressure (1.2, 1.5, and 1.8 MPa) and retention (3, 6, 9, and 12 min) for enhancement of SC contribution to biomethane production. Regression analysis demonstrated that SE pretreatment efficiency improved at high-temperature and short-retention time for biodegradation of RS. Maximum cumulative methane yield (EMY) achieved 254.8 mL/gvs at 1.2 MPa (3 min) of SE-treated RS with 62.7% of very significant improvement compared with untreated RS (156.6 mL/gvs). Furthermore, solid fraction of xylose, arabinose, cellobiose, glucose, and acid-soluble lignin in SE-treated RS of 1.2 MPa (3 min) were biodegraded by 27.4%, 46.4%, 100%, 48.8%, and 14.1%, respectively, after anaerobic digestion. Therefore, SE pretreatment was an encouraging approach for enhancing SC conversion to biomethane and waste resource to circular economy.

Background, aim, and scope Polysaccharides are renewable resources representing an important class of polymeric materials of biotechnological interest, offering a wide variety of potentially useful products to mankind. Exopolysaccharides (EPSs) of microbial origin with a novel functionality, reproducible physico-chemical properties, stable cost and supply, became a better alternative to polysaccharides of algal origin. EPSs are believed to protect bacterial cells from desiccation, heavy metals or other environmental stresses, including hostimmune responses, and to produce biofilms, thus enhancing the cells chances of colonising special ecological niches. One of the most important stress factor is salt stress for microorganisms. The present investigation is aimed to determine correlation between salt resistance and EPS production by three cyanobacterial isolates (Synechocystis sp. BASO444, Synechocystis sp. BASO507 and Synechocystis sp. BASO511). It is also aimed to investigate the effect of salt concentrations on EPS production by cyanobacteria and effect of salt on monosaccharide composition of EPS. Materials and methods Cyanobacterial isolates were identified by 16 S rRNA analysis. Its salt (NaCl) tolerance and association with exopolysaccharides (EPSs) production in three cyanobacterial isolates were investigated. Also, EPS was analysed by HPLC for monomer characterization. Results Increased EPS production was associated with NaCl tolerance. The most tolerant isolate, Synechocystis sp. BASO444, secreted the most EPS (500 mg/L). EPS production by Synechocystis sp. BASO444, Synechocystis sp. BASO507 and Synechocystis sp. BASO511 was investigated following exposure to 0.2 and 0.4 M NaCl. Also, flasks containing medium without NaCl were inoculated in the same manner to serve as controls. The monosaccharide compositions of EPS produced by the three isolates following exposure to 0.2 M NaCl were analysed by HPLC. Control EPS of BASO444 was composed of glucose (97%) and galacturonic acid (3%). The composition of BASO511 (control) was glucose (95%), xylose (4.80%), arabinose (0.13%), glucuronic acid (0.03%) and galacturonic acid (0.04%). However, the composition of BASO507 (control) was glucose (0.98%), xylose (98.00%), arabinose (1.00%), glucuronic acid (0.01%) and galacturonic acid (0.01%). In the presence of 0.2 M NaCl, EPS compositions and ratios of three cyanobacterial isolates changed. Discussion Although hyperproduction of EPS in response to starvation, antiviral activity, thickening agent and cosmetic industry for product formulations has been reported for cyanobacteria, the effect of NaCl on EPS production in cyanobacteria is not a popular area of study. There are no clear reports correlating EPS production and NaCl tolerance. The gap in the data about the effect of NaCl on cyanobacterial EPS production was filled by this investigation, and the results of our study have important implications in both the industrial and environmental arenas. Conclusions Our results indicate that 1) exposure to elevated concentrations of NaCl affects the composition of EPS produced by Synechocystis sp. BASO444, Synechocystis sp. BASO507 and Synechocystis sp. BASO511, and 2) there is a correlation between NaCl tolerance and EPS production in some cyanobacteria. Recommendations and perspectives Differences in the monosaccharide composition and ratios of EPS may promote NaCl tolerance in these microorganisms. As well, these alternative composition polysaccharides may be important for industrial applications.

To characterize coprophilous fungi for converting lignocellulose into lipids, four fungal strains utilizing cellulose microcrystalline and xylan were screened. The fungi were identified as Cladosporium sp. F1, Circinella sp. F6, Mycocladus sp. F49, and Byssochlamys sp. F52 based on the ITS1-5.8S-ITS2 sequence similarity. The strain F52 accumulated 336.0 mg/L reducing sugars on cottonseed shells treated with ethanol. The combination of F1 + F52 increased the reducing sugar accumulating rates. However, the activities of avicelase and xylanase were not correlated with the reducing sugars accumulated by the test strains. Strains F6 and F52 produced higher cellular lipids (above 530.7 mg/L) than other strains. However, the strain F52 could produce more cellular lipids with xylose and mannose as the sole carbon sources. The results indicated that the reducing sugar contents accumulated by the different strains were influenced by the fungal taxa and ligocellulosic types. With fibrolytic and lipid accumulating activities, diverse fungi harboring in herbivore feces need to be further characterized.