The worldwide increase in human population raises a big threat to the food security of each people as the land for agriculture is limited and even getting reduced with time. Therefore, it is essential that agricultural productivity should be enhanced significantly within the next few decades to meet the large demand of food by emerging population. Not to mention, too much dependence on chemical fertilizers for more crop productions inevitably damages both environmental ecology and human health with great severity. Exploitation of microbes as biofertilizers is considered to some extent an alternative to chemical fertilizers in agricultural sector due to their extensive potentiality in enhancing crop production and food safety. It has been observed that some microorganisms including plant growth promoting bacteria, fungi, Cyanobacteria, etc. have showed biofertilizer-like activities in the agricultural sector. Extensive works on biofertilizers have revealed their capability of providing required nutrients to the crop in sufficient amounts that resulted in the enhancement of crop yield. The present review elucidates various mechanisms that have been exerted by biofertilizers in order to promote plant growth and also provides protection against different plant pathogens. The aim of this review is to discuss the important roles and applications of biofertilizers in different sectors including agriculture, bioremediation, and ecology.

The rate of methylene blue and terephthalic acid degradation assisted with double metal-modified catalyst (0.1 mol% Cu and 1.0 mol% Zr) was enhanced as compared with single metal-modified catalysts (0.1, 0.5 mol% Cu and 1.0 mol% Zr). The wet impregnation method was used for copper and zirconium modification of the surface of Aeroxide P25 TiO₂ particles. Simultaneous loading of both metals on the surface of P25 leads to an increased specific surface area of the obtained material despite negative Cu influence. The tendency of stabilization and agglomerate size rising with the time for Cu and Zr-modified catalysts were traced by dynamic light scattering (DLS) measurements. The observed optical characteristics suggest that Cu compensated the broadening of band gap caused by Zr loading. Crystal structure of obtained photocatalysts was explored by XRD; morphological data and particle size were obtained by SEM. EDX was used for Zr and Cu content determination. Cu K-edge extended X-ray absorption fine structure (EXAFS) and X-ray absorption near edge structure (XANES) analytical techniques were used to investigate the local Cu neighbourhood in the samples and to identify copper coordination and valence state of copper species in the synthesized nanocomposites.

We report a facile method to tune TiO₂ nanoparticles’ morphology by modifying and an acid-catalyzed sol-gel synthesis with Pluronic P123. Synthesized particles were characterized by transmission electron microscopy, BET analysis, and X-ray diffraction spectroscopy. XRD analysis revealed a high anatase content while BET measurements showed that porous volume strongly depends on the amount of P123. We demonstrate that high amounts of P123 increase particle’s aspect-ratio from spherical to rod-shape morphology. We evaluated the photocatalytic performances for the removal of methyl viologen (paraquat) and found that best performances are obtained for the following weight ratio P123/TiO₂ = 7.5. Furthermore, P25 is less active than synthesized nanoparticles.

Over a period of 8 years (2007–2014), we were evaluating seed quality and morphological abnormalities in Scots pine trees affected as a result of the Chernobyl accident. The calculated dose rates for the trees at the study sites varied from background values at the reference sites to 40 mGy/year at the most contaminated site. We investigated whether radioactive contamination and/or weather factors could decrease the reproductive capacity or increase the frequency of morphological abnormalities of needles in pine trees. Scots pine seeds are characterized by high interannual variability of viability, which is largely determined by weather conditions. No consistent differences in reproductive capacity were detected between the impacted and reference populations. Brachyblasts with three needles were found only in the affected populations; however, their frequency was very low and only at the very border of significance at the p < 0.10 level.

Chlordecone (CLD), a highly persistent organochlorine pesticide commonly encountered in French West Indies (FWI) agricultural soils, represents a major source of contamination of FWI ecosystems. The potential of chemical reduction for remediation of CLD-contaminated soil has been investigated in laboratory pilot-scale 80 kg mesocosms for andosol, ferralsol, and nitisol from FWI banana plantations. Six cycles consisting of a 3-week reducing phase followed by a 1-week oxidizing phase were applied, with 2 % (dw/dw) Daramend® (organic plant matter fortified with zero valent iron) added at the start of each cycle. Complementary amendments of zero valent iron and zinc (total of 3 % dw/dw) were added at the start of the first three cycles. After the 6-month treatment, the CLD soil concentration was lowered by 74 % in nitisol, 71 % in ferralsol, and 22 % in andosol. Eleven CLD-dechlorinated transformation products, from mono- to penta-dechlorinated, were identified. None of them accumulated over the duration of the experiment. Six of the seven ecotoxicological tests applied showed no difference between the control and treated soils. The treatment applied in this study may offer a means to remediate CLD-contaminated soils, especially nitisol and ferralsol.

An easily recoverable homemade TiO₂ catalyst (GICA-1) has been evaluated during the overall photodegradation process, understood as photocatalytic efficiency and catalyst recovery step, in the solar light-assisted photodegradation of isoproturon and its reuse in two consecutive cycles. The global feasibility has been compared to the commercial TiO₂ P25. The homemade GICA-1 catalyst presented better sedimentation efficiency than TiO₂ P25 at all studied pHs, which could be explained by its higher average hydrodynamic particle size (3 μm) and other physicochemical surface properties. The evaluation of the overall process (isoproturon photo-oxidation + catalyst recovery) revealed GICA-1 homemade titania catalyst strengths: total removal of isoproturon in less than 60 min, easy recovery by sedimentation, and reusability in two consecutive cycles, without any loss of photocatalytic efficiency. Therefore, considering the whole photocatalytic cycle (good performance in photodegradation plus catalyst recovery step), the homemade GICA-1 photocatalyst resulted in more affordability than commercial TiO₂ P25. Graphical abstract

In a globalized world, the world trade fleet plays a pivotal role in limiting transport costs. But, the management of obsolete ships is an acute problem, with most Ship Recycling Facilities (SRF) situated in developing countries. They are renowned for their controversial work and safety conditions and their environmental impact. Paradoxically, dismantlement is paid for by the shipowners in accordance with international conventions therefore it is more profitable for them to sell off ships destined for scrapping. Scuttling, the alternative to scrapping, is assessed in the present review to compare the cost/benefit ratios of the two approaches. Although scrapping provides employment and raw materials – but with environmental, health and safety costs – scuttling provides fisheries and diving tourism opportunities but needs appropriate management to avoid organic and metal pollution, introduction of invasive species and exacerbation of coastal erosion. It is also limited by appropriate bottom depth, ship type and number. The present review inventories the environmental, health, safety, economic, and forensic aspects of each alternative.

The concentrations of 9 organophosphate flame retardants (OPFRs) were determined in 56 indoor and 9 outdoor air samples in the Rhine/Main area in Germany. The indoor samples were collected from seven different indoor microenvironments including private cars, private homes, floor/carpet stores, building material markets, schools, offices, and day care centers, while outdoor samples were simultaneously collected close to the indoor sampling locations. The total OPFR concentrations (∑OPFRs) in indoor air ranged from 3.30 to 751.0 ng/m³ with a median of 40.23 ng/m³, which was approximately eight times higher than those in outdoor air (median 5.38 ng/m³), indicating that sources of OPFRs predominate in the indoor environment. Tris(2-chloroisopropyl)phosphate (TCPP), tris(isobutyl)phosphate (TiBP), and tributyl phosphate (TnBP) were the dominating compounds both in indoor and outdoor air. The median concentration of ∑OPFRs in private cars (180.3 ng/m³) was significantly higher than that in private homes (12.51 ng/m³), schools (36.23 ng/m³), day care centers (31.80 ng/m³), and building material markets (31.17 ng/m³) (p < 0.05). Distribution profiles of OPFRs varied among different indoor microenvironments, which are evidenced by dominating indoor air concentrations of non-Cl-OPFRs in day care centers, floor/carpet stores, schools, and of Cl-OPFRs in other indoor microenvironments. Multivariate analyses revealed three distinct groups for OPFRs, i.e., TiBP/TnBP, TEP/TCEP/TDCPP, and TCPP, whose concentrations were closely associated with the distribution profiles and pollution characteristics of materials predominating in different indoor microenvironments.

Bacterial cellulose (BC) is a homopolymer and it is distinguished from plant-based cellulose by its unique properties such as high purity, high crystallinity, high water-holding capacity, and good biocompatibility. Microalgae are unicellular, photosynthetic microorganisms and are known to have high protein, starch, and oil content. In this study, Chlorella vulgaris was evaluated as source of glucose for the production of BC. To increase the starch content of algae the effect of nutrient starvation (nitrogen and sulfur) and light deficiency were tested in a batch assay. The starch contents (%) were 5.27 ± 0.04, 7.14 ± 0.18, 5.00 ± 0.08, and 1.35 ± 0.04 for normal cultivation, nitrogen starvation, sulfur starvation, and dark cultivation conditions, respectively. The performance of enzymatic and acidic methods was compared for the starch hydrolysis. This study demonstrated for the first time that acid hydrolysate of algal starch can be used to substitute glucose in the fermentation medium of Komagataeibacter hansenii for BC production. Glucose was used as a control for BC production. BC production yields on dry weight basis were 1.104 ± 0.002 g/L and 1.202 ± 0.005 g/L from algae-based glucose and glucose, respectively. The characterization of both BCs produced from glucose and algae-based glucose was investigated by scanning electron microscopy and Fourier transform infrared spectroscopy. The results have shown that the structural characteristics of algae-based BC were comparable to those of glucose-based BC.

Eragrostis plana Nees (EPN) was used as new and eco-friendly adsorbent for the removal of crystal violet dye (CV) from aqueous solution. Specific surface area (BET), scanning electron microscopy (SEM), infrared spectroscopy (ATR–FTIR), point of zero charge (pHPZC), and modified Boehm titration method were used to characterize the EPN material. The effects of initial pH of solution, adsorbent mass, contact time and initial dye concentration, and temperature were studied in batch adsorption mode. Kinetic data were evaluated by pseudo-first-order and pseudo-second-order models. The result exhibited that pseudo-second-order model well described the adsorption kinetics of CV onto EPN. Langmuir, Freundlich, and Sips isotherm models were used for analysis of the isothermal data. The equilibrium data of adsorption of CV onto EPN was better fitted with the Sips isotherm. Based on the Sips isotherm model, the maximum adsorption capacity was 76.20 ± 1.20 mg g⁻¹ at 333 K. A high desorption of CV from EPN was obtained using 1.00 mol L⁻¹ of CH₃COOH as eluent. The thermodynamic data indicated that the adsorption was spontaneous, endothermic, and physical process. EPN can be used as alternative adsorbent to remove CV from aqueous solution.