Refinar búsqueda
Resultados 361-370 de 762
A Thermochemical Conversion Study on the Combustion of Residue-Derived Fuels
2009
Skodras, G | Grammelis, P | Basinas, P | Prokopidou, M | Kakaras, E | Sakellaropoulos, G. P
Two different waste-derived by-products were examined and compared. Based on the thermogravimetric tests performed, it was proved that their decomposition occurs in two weight loss steps represented by two shoulders in the derivative thermogravimetric curves. The first shoulder is attributed to the devolatilisation of hemicellulose, cellulose and lignin and the second one to the plastic fraction of the waste. Similarities in the degradation behaviour were observed for both wastes, despite of their different origin. Increased plastic fractions resulted in slightly higher conversions and lower pyrolysis rates. Enhanced lignocellulosic fractions led to higher rates during combustion. The lignocellulosic fraction was increased proportionally to the inorganic residue that remained after combustion. A wide variation of weight losses was attained even in refuse-derived fuel (RDF) samples of the same origin, whilst stronger deviations were observed in the decomposition of the plastic fraction. The independent parallel, first-order, reactions model was elaborated for the kinetic analysis of the pyrolysis results. The thermal degradation of the RDF samples was modelled assuming four parallel reactions corresponding to the devolatilisation of cellulose, hemicellulose, lignin and plastics. Increased activation energies were calculated for the plastics fraction, whilst lignin presented the lowest contribution in the pyrolysis of the samples. Generally, both RDF samples presented similar kinetic constants despite their heterogeneity.
Mostrar más [+] Menos [-]Evaluation of the Removal of Pollutants from Petrochemical Wastewater Using A Membrane Bioreactor Treatment Plant
2009
Llop, Anna | Pocurull, Eva | Borrull, Francesc
A submerged membrane bioreactor (MBR) was used to treat two types of petrochemical wastewater: olefin process wastewater and total petrochemical wastewater. Various operational MBR conditions, such as influent pH and hydraulic retention time (HRT), were tested while these wastewaters were treated. The MBR treatment of olefin process wastewater reduced chemical oxygen demand (COD) and total organic carbon (TOC) by around 90% in both cases, and more than 90% of the suspended solids (SS) were removed. When MBR was used, the reduction in COD and TOC was also high for the total petrochemical wastewater, and was compared with the reduction obtained when the conventional activated sludge treatment plant was used (CASP). However, MBR effluent wastewaters showed high conductivity so for some reuse purposes subsequent reverse osmosis (RO) treatment would be needed. We characterized the MBR influent and MBR effluent wastewaters using a sequential solid phase extraction (SSPE) followed by gas chromatography-mass spectrometry (GC-MS) analyses. The main compounds that were tentatively identified were hydrocarbons, alkyl benzenes, phenols, acidic acids and esters, almost all of which could be partially or completely removed by MBR treatment.
Mostrar más [+] Menos [-]Chemical Composition of PM₁₀ and PM₂.₅ and Seasonal Variation in South Brazil
2009
Teixeira, Elba Calesso | Meira, Lindolfo | Santana, Eduardo Rodrigo Ramos de | Wiegand, Flavio
This paper presents experimental data on particulate matter (PM₁₀ and PM₂.₅) in the atmosphere of Candiota--South Brazil. Samples were collected using stacked filter units equipped with polycarbonate filters, which separate particles into two fractions: coarse 10-2.5 μm and fine <2.5 μm. The particulate matter was collected from January 2003 to September 2004 at three sampling sites: Acegua, 8 de Agosto, and Três Lagoas. The collected material was analyzed for Na, Mg, Al, Si, S, Cl, K, Ca, Ti, V, Cr, Mn, Fe, Co, Ni, Cu, Zn, Se, Br, Mo, Hg, and Pb, using particle-induced X-ray emission technique. Seasonal variation of the chemical elements with the size fraction was assessed. The elements K, Ca, Si, Ti, Fe, and Mn showed similar seasonal variability in the fine and coarse fractions with a low enrichment factor (<1.0) in both fractions, except for Mn and K, indicating common sources (soil dust, fly ash). Chemical species showing seasonal variability and high values of enrichment factor in fine fractions may indicate an anthropogenic origin.
Mostrar más [+] Menos [-]Glucosinolate Profiles of Arabidopsis thaliana in Response to Cadmium Exposure
2009
Sun, Xiumei | Zhang, Jixiu | Zhang, Haijun | Zhang, Qing | Ni, Yuwen | Chen, Jiping | Guan, Yafeng
The influence of cadmium on growth, cadmium accumulation, composition, and content of glucosinolates was investigated in Arabidopsis thaliana after 4 weeks of growth in hydroponics. Accumulation of 3,820 and 321 μg Cd g⁻¹ dry weight in the roots and leaves of A. thaliana, respectively, exposed to 50 μM Cd. Cadmium treatment significantly decreased the total concentration of glucosinolates both in the leaves and roots. Cd-induced alteration of total glucosinolate content in the roots was mainly due to the decrease of indolyl-glucosinolates. In the Cd treatment leaves, significant decreases were, respectively, detected for glucoibervirin and 4-methoxyglucobrassicin (P < 0.01), while other glucosinolate levels did not decrease significantly. In response to cadmium, the three indolyl-glucosinolates all showed significant decreases in the roots. The distinctive influence of cadmium on glucosinolate profiles in Cd-sensitive A. thaliana may be of great ecological importance, decreasing the resistance to phytophage attack. Taken together, our data is discussed in relation to jasmonic acid and salicylic acid as possible molecules that modulate the alteration of glucosinolate profiles in response to cadmium. The similar effects of Cd treatment on the levels of individual glucosinolates in leaves and roots were observed at higher-concentration cadmium treatment (100 μM Cd).
Mostrar más [+] Menos [-]Applying MAR Analysis to Identify Human and Non-Human Fecal Sources in Small Kentucky Watersheds
2009
Ritchey, S. A. | Coyne, M. S.
The recurrence of reports citing water quality impairments in watersheds is evidence that tools are needed to identify pollution sources and facilitate restoration efforts such as implementing total maximum daily limits (TMDLs) or best management practices (BMPs). Fecal bacteria in surface waters are one of the most commonly cited impairments to water quality. This study evaluated microbial source tracking (MST), specifically multiple antibiotic resistance (MAR) analysis, as a management tool to differentiate nonpoint source pollution into source groups. A library containing Escherichia coli (E. coli, EC) and fecal streptococci (FS) isolates from poultry (EC n = 282, FS n = 650), human (EC n = 152, FS n = 240), wildlife (EC n = 17, FS n = 43), horse (EC n = 79, FS n = 82), dairy cattle (EC n = 38, FS n = 42), and beef cattle (EC n = 49, FS n = 46) sources was created. The MAR analysis was conducted on the isolates using a profile of seven antibiotics. The antibiotic signatures of unknown source isolates from Elkhorn and Hickman Creek watersheds were evaluated against the library to determine the contributions of potential fecal inputs from the respective sources. Correct classification was >60% when analyzed at the human and non-human-level of classification. On a watershed basis, both watersheds produced similar results; inputs from non-human sources were the greatest contributors to nonpoint source pollution. The results from the multiple antibiotic resistance (MAR) analysis revealed that the information produced, coupled with knowledge of the watershed and its associated land uses, would be helpful in allocating resources to remediate impaired water quality in such watersheds.
Mostrar más [+] Menos [-]Photocatalytic Decolorization of Commercial Acid Dyes using Solar Irradiation
2009
Dias, Márlen G. | Azevedo, Eduardo B.
This work investigates the solar heterogeneous photocatalytic degradation of three commercial acid dyes: Blue 9 (C.I. 42090), Red 51 (C.I. 45430), and Yellow 23 (C.I. 19140). TiO₂ P25 from Degussa was used as the photocatalyst. The dyes were completely degraded within 120 min of treatment in the following increasing order of removal rate: Blue 9 < Yellow 23 < Red 51. The photocatalytic color removal process was well described by a two-first-order in-series reaction, followed by another first-order reaction. Photolytic experiments showed that this process is quite inefficient and highly selective towards Red 51 only. The dyes' solution was completely decolorized and organic matter removals up to 99% were achieved with photocatalysis. The lack of selectivity and the possibility of using solar light to excite the photocatalyst are promising results regarding the feasibility of this technology.
Mostrar más [+] Menos [-]Use of Enrichment Factors for the Assessment of Heavy Metal Contamination in the Sediments of Koumoundourou Lake, Greece
2009
Karageorgis, Aristomenis P. | Katsanevakis, Stelios | Kaberi, Helen
Lake Koumoundourou is a shallow meromictic lake located ∼11 km NW of Athens. It is surrounded by various industries and oil refineries, which contaminate the lake by oil spills and leakage. Moreover, the lake receives freshwater from underwater springs, plus drainage from industrialized catchment and Athens landfill. Potential contamination of the lakes' sediments in heavy metals and metalloids was assessed by means of enrichment factors (EFs) estimated against local preindustrial core sediment; elements were normalized to loss on ignition. EFs revealed that surface sediments were enriched in Pb (×10.2), Cu (×6.7), V (×5.1), Ni (×4.1), and other heavy metals. The use of EFs is recommended as a reliable method for heavy metal contamination assessment, provided that (1) element contents are corrected following a careful normalization procedure, (2) local preindustrial sediment is used as reference, and (3) reference sediment should be unaffected by diagenetic alterations.
Mostrar más [+] Menos [-]Degradative Oxidation of 2,4,6 Trichlorophenol Using Advanced Oxidation Processes - A Comparative Study
2009
Saritha, P. | Raj, D Samuel Suman | Aparna, C. | Laxmi, P Nalini Vijaya | Himabindu, V. | Anjaneyulu, Y.
In the present study, a comparative assessment of 2,4,6-T (2,4,6-Trichlorophenol) degradation by different AOPs (Advanced Oxidation Processes - UV, UV/ H₂O₂, Fenton, UV/Fenton and UV/TiO₂) in the laboratory scale is performed. The effects of different reactant concentrations and pH are assessed. 2,4,6-T removal, Total Organic Carbon mineralization (TOC) and dechlorination are monitored. Of all the AOPs, UV/Fenton process is more effective in degrading 2,4,6-T. The optimum conditions obtained for the best degradation with UV/Fenton are: pH = 3, Fe⁺² concentration of about 5 ppm, and peroxide concentration of 100 ppm for an initial 100 ppm of 2,4,6 T concentration at room temperature. In these conditions, a pseudo first-order rate constant is evaluated. The degradation rate of 2,4,6 T followed the order: {{{\text{UV}}} \mathord{\left/ {\vphantom {{{\text{UV}}} {{\text{TiO}}_{\text{2}} > {{{\text{UV}}} \mathord{\left/ {\vphantom {{{\text{UV}}} {{\text{H}}_{\text{2}} {\text{O}}_{\text{2}} > {\text{Feton}}}}} \right. \kern-\nulldelimiterspace} {{\text{H}}_{\text{2}} {\text{O}}_{\text{2}} > {\text{Feton}}}}}}} \right. \kern-\nulldelimiterspace} {{\text{TiO}}_{\text{2}} > {{{\text{UV}}} \mathord{\left/ {\vphantom {{{\text{UV}}} {{\text{H}}_{\text{2}} {\text{O}}_{\text{2}} > {\text{Feton}}}}} \right. \kern-\nulldelimiterspace} {{\text{H}}_{\text{2}} {\text{O}}_{\text{2}} > {\text{Feton}}}}}} > {\text{UV}} $$]]>
Mostrar más [+] Menos [-]Optimization of Culture Conditions for the Biodegradation of Lindane by the Polypore Fungus Ganoderma australe
2009
Dritsa, V. | Rigas, F. | Doulia, D. | Avramides, E. J. | Hatzianestis, I.
The bracket-like polypore fungus, Ganoderma australe, was selected for its potential to degrade lindane in liquid agitated sterile cultures. An orthogonal central composite design based on response surface methodology was used to find the optimum biodegradation and biosorption conditions of this pesticide and the growth conditions of the fungus. The factors tested include nitrogen content, initial concentration of lindane, incubation time, and temperature. The optimization parameters investigated were fungus biomass, fungus growth rate, final pH, specific biodegradation, specific biosorption, specific biodegradation rate, biodegraded to biosorbed ratio. The results of the experiments were statistically analyzed and the significance and effect of each factor on responses was assessed. The optimum (maximum) lindane biodegradation (3.11 mg biodegraded lindane per gram biomass) was obtained with nitrogen content of 1.28 g/L, lindane concentration of 7.0 ppm, temperature of 18.0°C, and 5 days of cultivation time.
Mostrar más [+] Menos [-]Origin of Gypsum-rich Coatings on Historic Buildings
2009
Sanjurjo Sánchez, J. | Alves, C. A. S. | Vidal Romaní, J. R. | Fernández Mosquera, D.
Gypsum-rich coatings found on buildings constructed with granitic rock ashlars have been studied, from both an urban and a rural area of the NW of Spain. Previous works have attributed gypsum to rock weathering by atmospheric pollution. Mineralogical, chemical, and physical data of coatings have allowed us to distinguish six different types of coatings formed in several ways. In most cases, they are originated by the deterioration calcium-rich plaster building materials. Sulfation of Ca-rich coatings, in situ gypsum dissolution and precipitation, and deposition of air pollution particles are the most important agents related to genesis of coatings. In fact, remains of plasters practically intact were found in some studied buildings. Also, data from coatings and rock ashlars suggest that gypsum-rich coatings are not formed by environment-rock interaction. Coatings located on different parts and façades of the buildings and submitted to different environmental conditions decay in a different way.
Mostrar más [+] Menos [-]