Management of solid wastes is considered as an economic and environmental issue in the building stone industry. The current study uses raw and calcined calcareous sludge, generated in the stone cutting factories, in order to remove sulfur dioxide. Sludge characterization has been performed, using X-ray fluorescence (XRF), X-ray diffraction (XRD), scanning electron microscopy (SEM), and energy-dispersive X-ray spectroscopy (EDX) analyses. The removal experiments of sulfur dioxide have conducted under different humid contents and adsorbent doses. The results showed that the higher the adsorbent dosage and humidity content, the greater the SO2 adsorption.. The calcination process at temperatures of 400, 500, 600, and 700℃ revealed that with rising calcination temperature and humidity content, the adsorbent capability is enhanced considerably. This method could be developed for the management of stone sludge produced from the stone cutting industry through its conversion into an effective and low-cost adsorbent for desulfurization process.

The city of Tehran undergoes an increasing growth in population as well as industrial activities, both of which increase the concentration of air pollutants. The current research tries to turn a limited and focused system of air contamination measurement and control to an unlimited and extensive one that examines the concentration of each of the contaminants in any area of Tehran. Accordingly, information from twenty air-pollution measurement stations at certain points of the city helps measuring the concentrations of contaminants like SO2, NO2, CO, O3, PM2.5, and PM10 throughout a year on a daily basis. The index of AQI has also been used as the air quality index to determine the level of pollution in the city. Using ARC-GIS software, the AQI or the air quality index has been zoned and a comprehensive map, designed. Moreover, in order to illustrate this map, a map of the zoning has been drawn up for this purpose on December, 26, 2016, considered an unhealthy day in Tehran, the results of which show that only 27.8% of the city is unhealthy and the rest of the city does not fall in unhealthy area. However, due to the lack of a comprehensive map for determining the AQI in different parts of the city, the whole city closes down, leading in an economic loss of about $ 1 million a day for the city.

In this study, the lethal toxicity, behavioral responses and hematotoxicity of formulated chlorpyrifos on Clarias gariepinus was evaluated. C. gariepinus fingerlings were exposed to 0.2 mg/L, 0.25 mg/L, 0.3 mg/L, 0.35 mg/L and 0.4 mg/L of the active ingredient chlorpyrifos to determine the lethal concentrations and behavioral effects. C. gariepinus juveniles (38.84±7.67g) were then exposed to 0.0256 mg/L and 0.0128 mg/L for 14 days to study somatic indices and haematological effects. The 24h, 48h, 72h and 96h LC50 were estimated as 0.292 (0.210 – 0.376) mg/L, 0.275 (0.252 – 0.297) mg/L, 0.263 (0.242 – 0.282) mg/L, and 0.256 (0.235 – 0.275) mg/L respectively. Hyper activity, loss of equilibrium, erratic swimming, trembling, respiratory distress and poor startle response were observed in fingerlings in response to acute toxic stress of chlorpyrifos. Liver somatic index (LSI) of exposed juveniles increased significantly (p<0.05) compared with control, while there was no statistically significant difference in all the haematological parameters of the exposed fishes compared with the control (p<0.05). The results indicate that the chlorpyrifos formulation was highly toxic and induced behavioral changes in C gariepinus fingerlings, while sub-lethal concentrations induced inflammation in the liver but had no effect on haematological parameters of Clarias gariepinus juveniles. LSI was sensitive to the sub-lethal concentrations and could serve as indicators or exposure to organophosphate insecticides.

The current study investigates the dissipation kinetics of two imidacloprid (IMI) nanoformulations (entitled: Nano-IMI and Nano-IMI/TiO2) on common bean (Phaseolus vulgaris) seeds under field conditions and compares them with 35% Suspension Concentrate (SC) commercial formulation. To do so, it sprays P. vulgaris plants at 30 and 60 g/ha within green bean stage, sampling them during the 14-day period after the treatment. Following extraction and quantification of IMI residues, dissipation data have been fitted to simple-first order kinetic model (SFOK) and to first-order double-exponential decay (FODED) models, with 50% and 90% dissipation times (DT50 and DT90, respectively) assessed along the pre-harvest interval (PHI). With the exception of Nano-IMI at 60 g/ha, other decline curves are best fitted to the FODED model. In general, dissipation is faster for Nano-IMI (at 30 g/ha: DT50 = 1.09 days, DT90 = 4.30 days, PHI = 1.23 days; at 60 g/ha: DT50 = 1.29 days, DT90 = 4.29 days, PHI = 2.95 days) and Nano-IMI/TiO2 (at 30 g/ha: DT50 = 1.15 days, DT90 = 4.40 days, PHI = 1.08 days; at 60 g/ha: DT50 = 0.86 days, DT90 = 4.92 days, PHI = 3.02 days), compared to 35% SC (at 30 g/ha: DT50 = 1.58, DT90 = 6.45, PHI = 1.93; at 60 g/ha: DT50 = 1.58 days, DT90 = 14.50 days, PHI = 5.37 days). These results suggest the suitability of Nano-IMI and Nano-IMI/TiO2 application at both rates in terms of their residues on P. vulgaris seeds.

Currently, the reduction of reactive dyes present in the textile effluent is a big challenge due to the threat to the environment. Existing physical and chemical methods contains many drawbacks. In the present scenario microbial reduction pays much attention and current focus of research. Therefore, the present study isolated dye decolorizing bacterium Exiguiobacterium aurantiacum (TSL7) from activated sludge and identified by molecular techniques and 16S rDNA sequences. Decolorization was not established in Bushnell hass broth composition in accordance with absence of carbon and nitrogen source. The three environmental factors pH, starch and beef extract were selected from Plackett-Burman design experiments. The central composite design was employed to optimize the maximum removal of remazol golden yellow (91.83%) with pH, 6.89, starch, 0.49% (w/v) and beef extract 0.67% (w/v) respectively, These key factors playing a major role in the bacterial dye removal and the interactions were evaluated statistically. The optimal value of significant factors supports to maximize the dye removal competency of isolated bacterium. Thus results exhibited that local salt tolerant bacterium Exiguiobacterium aurantiacum (TSL7) could be a potential candidate for an in situ-bioremediation of inorganic salts abundant textile effluents in the textile industry.

A newly developed Smart Pouch with enclosed biomaterial (Aloe vera and coconut husk powder) has been experimented for elimination of heavy metals i.e. (Pb2+, Cu2+, Ni2+ and Zn2+) from wastewater. The effect of concentration, pH, temperature, contact duration etc. was investigated using batch experiments which resulted that the Pouch may be accepted for convenient, efficient and low-cost accumulation of several heavy metals simultaneously from waste water. The maximum Pb removal was 99.99%, 93.21% for Cu, and for Ni, it was 91.97% whereas for Zn, 86.41% was obtained and also, the uptake capacity of pouch was quite sensitive towards initial metal concentration in the studied range of 10-200mg/L present in wastewater. The findings were further interpreted by quantum chemical study as theoretical support, various adsorption isotherms, FTIR, SEM, XRD, and physiochemical properties of metal ions to justify the synergized performance of new Pouch. A good correlation was found between experimental methods and theoretical findings.

Greenhouse experiment was conducted for four months using Leucaena leucocephala and Pleurotus tuber-regium to determine their bioremediation potentials. Leucaena leucocephala, Pleurotus tuber-regium and Leucaena leucocephala combined with Pleurotus tuber-regium were tested for their ability to improve nutrient (N, P, K, total organic carbon) and reduce heavy metals (Zn, Ni, Pb, Cu) of soil polluted with spent engine oil [5% (w/v)] and soil without spent engine oil was used as control. Bioaccumulation of nutrients and heavy metals in Leucaena leucocephala and Pleurotus tuber-regium were also determined. The highest reduction in Zn, Ni, Pb and Cu (41%, 48.39%, 61.60 and 52.72% respectively) were recorded in soil remediated with Leucaena leucocephala alone, reduction of 30.40%, 26.53%, 48.07% and 39.60% respectively were recorded in soil remediated with Pleurotus tuber-regium alone while in soil remediated with combined Pleurotus tuber-regium and Leucaena leucocephala, reductions of 32.7%, 33.43%, 88.41% and 46.22% respectively were recorded. Bioaccumulation of Zn, Ni, Pb and Cu in Leucaena leucocephala increased by 73.41%, 85.46%, 3366.04% and 125.53% respectively, similarly in Pleurotus tuber-regium by 30.16%, 21.67%, 71.11% and 53.21% respectively. These studies have shown that Pleurotus tuber-regium and Leucaena leucocephala are capable of bioremediating spent engine oil polluted soil although, treatment with Leucaena leucocephala alone tends to be most effective of these treatments.

In the present study, analytical solutions are obtained for two-dimensional advection dispersion equation for conservative solute transport in a semi-infinite heterogeneous porous medium with pulse type input point source of uniform nature. The change in dispersion parameter due to heterogeneity is considered as linear multiple of spatially dependent function and seepage velocity whereas seepage velocity is nth power of spatially dependent function. Two forms of the seepage velocity namely exponentially decreasing and sinusoidal form are considered. First order decay and zero order production are also considered. The geological formation of the porous medium is considered of heterogeneous and adsorbing nature. Domain of the medium is uniformly polluted initially. Concentration gradient is considered zero at infinity. Certain new transformations are introduced to transform the variable coefficients of the advection diffusion equation into constant coefficients. Laplace Transform Technique (LTT) is used to obtain analytical solutions of advection-diffusion equation. The solutions in all possible combinations of temporally and spatially dependence dispersion are demonstrated with the help of graphs.

Biomass derived from Tamarindus indica partially activated seed coat was investigated for the removal of nitrate ions from aqueous solutions. Batch experiments were performed to evaluate the parameters like pH, contact time, sorbent dose and initial nitrate concentration. pH of the solution played vital role. The maximum sorption observed at pH=7, sorbent dose 300mg, contact time at 120min, initial nitrate concentration 5mg. Physicochemical properties of the biomass were evaluated using scanning electron microscopy (SEM), energy dispersive X-ray analysis and Fourier Transform infra red (FTIR) spectroscopy. The SEM and FTIR data reveals the suitable surface and the presence of chemical functional groups such as hydroxyl, amide, carbonyl strong acid and primary amine on the biosorbent surface contributes to biosorption. The equilibrium isotherms and kinetics were deliberated. Biosorption equilibrium followed Langmuir isotherm. Pseudo second order kinetics provided better correlation of the experimental data in comparison with pseudo-first-order kinetic model. The study indicated that Tamarindus indica partially activated seed coat biomass found to be a novel biosorbent for the removal of nitrates from aqueous solutions.

This study was undertaken to evaluate a novel aerobic wastewater treatment model for the remediation of refinery effluents and to assess the removal efficiency of Bulkholderia cepacia strain AJI and Corynebacterium kutscheri strain AJ2 to clean oil waste from petrochemical company. Wastewater quality parameters including pH, BOD5, COD, TDS, OIL &amp; GREASE, PHENOL concentration, TPH and THC were monitored at 5, 10 and 15 days of treatment and the removal efficiencies were calculated. Results indicated that the raw oily wastewater effluents used during this study had extremely high levels of all the tested parameters. The mean values  of  all physicochemical parameters  of the wastewater from primary tank at different treatment period were statistically different (P˂0.001) After 15 days of biological treatment, BOD5 ,COD, TDS, Phenol, TPH, Oil &amp; grease level of the refinery wastewater were reduced by 95.60 %, 98.40 % , 66.34 % , 100 %, 97.60 %  and 96.20 % respectively. The detection of the catabolic genes in the bacterial isolates recovered from primary tank using polymerase chain reaction revealed that both Bulkholderia cepacia strain AJ1 and Corynebacterium kutsheri strain AJ2 carried alk B and C23O but C12O was not detected in both isolates. Naphthalene dioxygenase was detected in Bulkholderia cepacia strain AJ1 but not found in Corynebacterium kutscheri strain AJ2. After treatment the waste water was filtered in the secondary tank. The results of physicochemical parameters in the outlet vessel essentially confirmed that the mixed culture in the two column model successfully carry out bioremediation of refinery wastewater. Therefore, aerobic treatment model for the bioremediation of refinery Petroleum refineries generate great amounts of wastewaters that may become seriously dangerous, leading to the accumulation of toxic products in the receiving water bodies with potentially serious long term effects to aquatic biota. Due to extreme toxicity of contaminants in refinery wastewater, there is a need to develop an economical technique to remove the pollutants from the wastewater is highly recommended owing its environmental friendliness.