A gas chromatography tandem mass-spectrometry method dedicated to the analysis of 50 metabolites of polycyclic aromatic hydrocarbons (OH-PAHs) was applied to urine specimens collected from female Long Evans rats under controlled exposure to a mixture of PAHs (at 7 doses ranging from 0.01 to 0.8 mg/kg, by gavage, 3 times per week for 90 days). On four occasions (day 1, 28, 60 and 90), urine samples were collected over a 24 h period. Among these 50 OH-PAHs, 41 were detected in urine samples. Seven additional OH-PAHs were identified for the first time: 1 corresponding to metabolite of pyrene and 3 of anthracene.Strong linear dose versus urinary concentration relationships were observed for 25 of the 41 OH-PAHs detected in rat urine, confirming their suitability for assessing exposure to their respective parent compound. In addition, some isomers (e.g. 1-OH-pyrene, 3-OH-/4-OH-chrysene, 10-OH-benz[a]anthracene, 8-OH-benzo[k]fluoranthene, 11-OH-benzo[b]fluoranthene and 3-OH-benzo[a]pyrene) that were detected starting from the lowest levels of exposure or even in controls were considered particularly relevant biomarkers compared to metabolites only detected at higher levels of exposure. Finally, on the basis of the excretion profiles (on days 1, 28, 60 and 90) and urinary elimination kinetics of each OH-PAH detected at days 1 and 60, this study highlighted the fact that sampling time may influence the measurement of metabolites in urine.Taken together, these results provide interesting information on the suitability of the analysis of OH-PAHs in urine for the assessment of PAH exposure, which could be taken into consideration for the design of epidemiological studies in the future.

Air pollution plays a pivotal role in the deterioration of many materials used in buildings and cultural monuments causing an inestimable damage. This study aims to estimate the impacts of air pollution (SO2, HNO3, O3, PM10) and meteorological conditions (temperature, precipitation, relative humidity) on limestone, copper and bronze based on high resolution air quality data-base produced with AMS-MINNI modelling system over the Italian territory over the time period 2003–2010. A comparison between high resolution data (AMS-MINNI grid, 4 × 4 km) and low resolution data (EMEP grid, 50 × 50 km) has been performed. Our results pointed out that the corrosion levels for limestone, copper and bronze are decreased in Italy from 2003 to 2010 in relation to decrease of pollutant concentrations. However, some problem related to air pollution persists especially in Northern and Southern Italy. In particular, PM10 and HNO3 are considered the main responsible for limestone corrosion. Moreover, the high resolution data (AMS-MINNI) allowed the identification of risk areas that are not visible with the low resolution data (EMEP modelling system) in all considered years and, especially, in the limestone case. Consequently, high resolution air quality simulations are suitable to provide concrete benefits in providing information for national effective policy against corrosion risk for cultural heritage, also in the context of climate changes that are affecting strongly Mediterranean basin.

In recent years, an increasing trend towards investigating and monitoring the contamination of the environment by microplastics (MP) (plastic pieces < 5 mm) has been observed worldwide. Nonetheless, a reliable methodology that would facilitate and automate the monitoring of MP is still lacking. With the goal of selecting practical and standardized methods, and considering the challenges in microplastics detection, we present here a critical evaluation of two vibrational spectroscopies, Raman and Fourier transform infrared (FTIR) spectroscopy, and two extraction methods: thermal extraction desorption gas chromatography mass spectrometry (TED-GC-MS) and liquid extraction with subsequent size exclusion chromatography (SEC) using a soil with known contents of PE, PP, PS and PET as reference material. The obtained results were compared in terms of measurement time, technique handling, detection limits and requirements for sample preparation. The results showed that in designing and selecting the right methodology, the scientific question that determines what needs to be understood is significant, and should be considered carefully prior to analysis. Depending on whether the object of interest is quantification of the MP particles in the sample, or merely a quick estimate of sample contamination with plastics, the appropriate method must be selected. To obtain overall information about MP in environmental samples, the combination of several parallel approaches should be considered.

The effects of graphene oxide (GO) on the transport and deposition behaviors of colloids with different sizes in packed quartz sand were investigated in both NaCl (10 and 50 mM) and CaCl2 solutions (1 and 5 mM) at pH 6. Fluorescent carboxylate-modified polystyrene latex microspheres (CMLs) with size ranging from 0.2 to 2 μm were utilized as model colloids. Both breakthrough curves and retained profiles of colloids in the presence and absence of GO in suspensions under all examined solution conditions were analyzed. The breakthrough curves of all three different-sized CMLs with GO were higher yet the retained profiles were lower than those without GO at both examined ionic strengths in NaCl solutions. The observation showed that GO increased the transport and decreased the deposition of all three different-sized CMLs in NaCl solutions. However, in CaCl2 solutions, opposite observation was achieved at two different ionic strength conditions. Specifically, the presence of GO increased the transport and decreased the deposition of all three different-sized CMLs in 1 mM CaCl2 solutions, whereas, it decreased the transport and increased the deposition of all three different-sized CMLs in 5 mM CaCl2 solutions. Comparison the breakthrough curves and retained profiles of CMLs versus those of GO yielded that the overall transport and deposition behaviors of all three different-sized CMLs with GO copresent in suspensions agreed well with the transport and deposition behaviors of GO under all examined conditions. The transport and deposition behaviors of CMLs in packed porous media clearly were controlled by those of GO under the conditions investigated in present study due to the adsorption of CMLs onto GO surfaces. Our study showed that once released into natural environment, GO would adsorb (interact with) different types of colloids and thus have significant influence on the fate and transport of colloids in porous media.

Application of bioash from biofuel combustion to soil supports nutrient recycling, but may have unwanted and detrimental ecotoxicological side-effects, as the ash is a complex mixture of compounds that could affect soil invertebrates directly or through changes in their food or habitat conditions. To examine this, we performed laboratory toxicity studies of the effects of wood-ash added to an agricultural soil and the organic horizon of a coniferous plantation soil with the detrivore soil collembolans Folsomia candida and Onychiurus yodai, the gamasid predaceous mite Hypoaspis aculeifer, and the enchytraeid worm Enchytraeus crypticus. We used ash concentrations spanning 0–75 g kg⁻¹ soil. As ash increases pH we compared bioash effects with effects of calcium hydroxide, Ca(OH)2, the main liming component of ash. Only high ash concentrations above 15 g kg⁻¹ agricultural soil or 17 t ha⁻¹ had significant effects on the collembolans. The wood ash neither affected H. aculeifer nor E. crypticus. The estimated osmolalities of Ca(OH)2 and the wood ash were similar at the LC50 concentration level. We conclude that short-term chronic effects of wood ash differ among different soil types, and osmotic stress is the likely cause of effects while high pH and heavy metals is of minor importance.

Little information exists on emission factors (EFs, quantities of pollutants emitted per unit of fuel consumed) for brick kilns in China, although brick kilns are important emission sources of many air pollutants, and 45% of the world's bricks are produced in China. In this study, EFs of carbon dioxide (CO2), carbon monoxide (CO), sulfur dioxide (SO2), nitrogen oxides (NOx), particulate matters (PMs), black carbon (BC), organic carbon (OC), and polycyclic aromatic hydrocarbons (PAHs) for brick kilns were derived based on field measurements of a total of 18 brick kilns of major types in China. This was the first study to quantify EFs of both stack and fugitive sources based on a modified carbon balance method that was developed for this study. The EFs of most pollutants, especially the incomplete combustion products in fugitive emissions, were much higher than those for stack emissions, indicating a substantial underestimation of total emissions when leakage is not taken into consideration. This novel method can be applied to quantify emissions from other similar sources with both stack and fugitive emissions.

Synthetic glucocorticoids (GCs) such as dexamethasone (DEX) and prednisolone (PDS) have been used since the 1940s to cure inflammatory and auto-immune disorders. Their use has been linked to a host of deleterious effects in aquatic ecosystems such as osteoporosis in vertebrates, developmental impairments in molluscs and reduced fecundity and growth in cladocerans. Apart from these handful of studies, the effects of GCs on aquatic biota are largely unknown. The present study is a first of its kind aiming to assess the multi-generational exposure effects of DEX and PDS on the life history parameters of Ceriodaphnia dubia (C. dubia). Multigenerational studies have proved to be an advantage in assessing the cumulative damage caused by aquatic toxicants at the population level of the exposed organisms over a period of successive generations using multiple biological endpoints. Test results demonstrated that C. dubia exhibited varied sensitivities towards both the studied chemicals however were more sensitive to DEX with 48-h EC50 (95% confidence interval) of 0.75 mg/L (CI: 0.59–0.92) in comparison to PDS [19 mg/L (CI: 15–23)]. EC10 values for F0 in a multigenerational chronic bioassays were 48 μg/L (CI: 37.4–61) for DEX and 460 μg/L (CI: 341–606) for PDS and in F3 were 2.2 μg/L (CI: 1.6–3.1) for DEX and 31 μg/L (CI: 19.4–46) for PDS. There was a positive trend of increased toxicity followed by reduced life history traits such as fecundity, brood size and time to first brood and intrinsic rate of population increase and body growth (length and area) of C. dubia in the case of both studied chemicals. The results from the current work highlighted the importance of multigenerational studies in identifying the evolutionary responses of stressed non-target aquatic organisms, and data obtained can be further used in developing water quality guidelines.

Widespread use of insecticides for the control of urban pests such as ants, termites, and spiders has resulted in contamination and toxicity in urban aquatic ecosystems in different regions of the world. Passive samplers are a convenient and integrative tool for in situ monitoring of trace contaminants in surface water. However, the performance of a passive sampler depends closely on its affinity for the target analytes, making passive samplers highly specific to the types of contaminants being monitored. The goal of this study was to develop a passive sampler compatible with a wide range of insecticides, including the strongly hydrophobic pyrethroids and the weakly hydrophobic fipronil and organophosphates. Of six candidate polymeric thin films, polyurethane film (PU) was identified to be the best at enriching the test compounds. The inclusion of stable isotope labeled analogs as performance reference compounds (PRCs) further allowed the use of PU film for pyrethroids under non-equilibrium conditions. The PU sampler was tested in a large aquarium with circulatory water flow, and also deployed at multiple sites in surface streams in southern California. The concentrations of pesticides derived from the PU sampler ranged from 0.5 to 18.5 ng/L, which were generally lower than the total chemical concentration measured by grab samples, suggesting that suspended particles and dissolved organic matter in water rendered them less available. The influence of suspended particles and dissolved organic matter on bioavailability was more pronounced for pyrethroids than for fipronils. The results show that the developed PU film sampler, when coupled with PRCs, may be used for rapid and sensitive in-situ monitoring of a wide range of insecticides in surface water.

Due to the persistence of metals in the ecosystem and their threat to all living organisms, effects of heavy metal on soil microbial communities were widely studied. However, little was known about the interactions among microorganisms in heavy metal-contaminated soils. In the present study, microbial communities in Non (CON), moderately (CL) and severely (CH) contaminated soils were investigated through high-throughput Illumina sequencing of 16s rRNA gene amplicons, and networks were constructed to show the interactions among microbes. Results showed that the microbial community composition was significantly, while the microbial diversity was not significantly affected by heavy metal contamination. Bacteria showed various response to heavy metals. Bacteria that positively correlated with Cd, e.g. Acidobacteria_Gp and Proteobacteria_thiobacillus, had more links between nodes and more positive interactions among microbes in CL- and CH-networks, while bacteria that negatively correlated with Cd, e.g. Longilinea, Gp2 and Gp4 had fewer network links and more negative interactions in CL and CH-networks. Unlike bacteria, members of the archaeal domain, i.e. phyla Crenarchaeota and Euryarchaeota, class Thermoprotei and order Thermoplasmatales showed only positive correlation with Cd and had more network interactions in CH-networks. The present study indicated that (i) the microbial community composition, as well as network interactions was shift to strengthen adaptability of microorganisms to heavy metal contamination, (ii) archaea were resistant to heavy metal contamination and may contribute to the adaption to heavy metals. It was proposed that the contribution might be achieved either by improving environment conditions or by cooperative interactions.

Seasonal patterns of birth outcomes have been observed worldwide, and there was increasing evidence that ambient temperature played as a trigger of adverse birth outcomes, such as preterm birth (PTB), low birth weight (LBW), and stillbirth. To systematically review updated epidemiological evidence about the relationship between temperature exposure during pregnancy and PTB, LBW, and stillbirth, we searched for related studies published in English from electronic databases and references of identified papers. We only included original articles that directly reported the effects of prenatal temperature exposure on birth outcomes. The characteristics and main findings of included studies were examined. A total of 36 epidemiological studies were finally included in this review. Most of these studies focused on PTB and LBW, while less attention has been paid to stillbirth that was relatively rare in the occurrence. Several designs including ecological (e.g., descriptive and time-series) and retrospective cohort studies (e.g., case-crossover and time-to-event) were applied to assess temperature effects on birth outcomes. Temperature metrics and exposure windows varied greatly in these investigations. Exposure to high temperature was generally found to be associated with PTB, LBW, and stillbirth, while several studies also reported the adverse impact of low temperature on birth outcomes of PTB and LBW. Despite no conclusive causality demonstrated, the current evidence for adverse effect on birth outcomes was stronger for heat than for cold. In summary, the evidence linking birth outcomes with ambient temperature was still very limited. Consequently, more related studies are needed worldwide and should be conducted in diversified climate zones, so as to further ascertain the association between temperature and birth outcomes. Future studies should focus on more sophisticated study designs, more accurate estimation of temperature exposure during pregnancy, and more efficient methods to find out the exposure windows, as well as cold-related effects on birth outcomes.