International audience

International audience

International audience | Organic waste products (OWP) application to crop lands makes possible nutrients recycling. However, it can result in long-term accumulation of trace elements (TE) in soils. The present study aimed at (i) assessing the impact of regular applications of urban composts and manure on the TE contents of topsoils and crops in a long-term field experiment, (ii) comparing the TE mass balances with the stock variations of TE in soils, and (iii) proposing a prospective evaluation of this practice, based on estimated soil safe threshold values and simulations of soil TE accumulation for 100 years. In the long-term field experiment, physico-chemical properties and TE contents (Cd, Cr, Cu, Hg, Ni, Pb and Zn) have been measured in OWP, soils, plants and leaching waters for the period 1998–2015, and used for mass balance calculations and long-term simulations of TE accumulations. The composts of green wastes and sludge (GWS) and of municipal solid waste (MSW) were the OWP with the largest TE contents, while the farmyard manure tended to have the lowest. Repeated application of OWP led to significant accumulation of Zn and Cu in the topsoil layer (not for Cr, Cd, Hg, Ni, Pb), especially with GWS, without overpassing calculated protective threshold values. No effect of repeated application of OWP has been observed on TE contents in grains (wheat, maize, barley). The positive mass balance has been dominated by the input flux of TE through OWP and resulted in the observed increases of soil stocks for Cu and Zn. Prospective simulation of soil content evolution until 2100 showed that soil content reached 0.4 mg Cd kg−1 soil (GWS, MSW), 38 mg Cu kg−1 soil (GWS) and 109 mg Zn kg−1 soil (GWS), which remained lower than protective threshold values.

International audience | In Guadeloupe, the use between 1972 and 1993 of chlordecone, an organochlorine insecticide, has permanently contaminated the island’s soil, thus contaminating the food chain at its very beginning. There is today a strong societal requirement for an improved mapping of the contaminated zones. Given the extent of the areas to be covered, carrying out soil tests on each plot of the territory would be a long and expensive process. In this article, we explore a method of demarcating polluted areas. The approach adopted consists in carrying out, using surface water analyses, a hydrological delimitation that makes it possible to distinguish contaminated watersheds from uncontaminated ones. The selection of sampling points was based on the spatial analysis of the actual and potential contamination data existing at the beginning of the study. The approach was validated by soil analyses, after having compared the contamination data of the watersheds with the soil contamination data of the plots within them. The study thus made it possible to highlight new contaminated areas and also those at risk of contamination and to identify the plots to be targeted as a priority during future analysis campaigns by State services.

This study aims to examine the association between short-term exposures to PM₁, PM₂.₅ and PM₁₀ (particulate matter with aerodynamic diameters ≤1 μm, ≤2.5 μm and ≤10 μm, respectively) and hospital admission for ischemic stroke in China. Daily counts of hospital admission for ischemic stroke were collected in 5 hospitals in China during November 2013 to October 2015. Daily concentrations of PM₁, PM₂.₅ and PM₁₀ were collected in 5 cities where the hospitals were located. A time-stratified case-crossover design was used to examine the hospital-specific PM-ischemic stroke association after controlling for potential confounders. Then the effect estimates were pooled using a random-effect meta-analysis. A total of 68,122 hospital admissions for ischemic stroke were identified from 5 hospitals during the study period. The pooled results showed that exposures to PM₁, PM₂.₅ and PM₁₀ were significantly associated with increased hospital admission for ischemic stroke on the current day and previous 1 day. The RRs (relative risk associated with per 10 μg/m³ increase in each pollutant) and 95%CIs (confidence intervals) for the cumulative effects of PM₁, PM₂.₅ and PM₁₀ on ischemic stroke during lag 0–1 days were 1.014 (1.005, 1.0023), 1.007 (1.000, 1.014) and 1.005 (1.001, 1.009), respectively. In total, 3.5%, 3.6% and 4.1% of hospital admissions for ischemic stroke could be attributable to PM₁, PM₂.₅ and PM₁₀, respectively. Exposures to ambient PM₁, PM₂.₅ and PM₁₀ pollution showed acute adverse effects on hospital admission for ischemic stroke. The health effects of PM₁ should be considered by policy-makers.

The increasing content of platinum group metal particles emitted into the environment by car traffic is gradually attracting the attention of the scientific community. However, the methods for the determination of platinum group metals in environmental matrices are either costly or suffer from low sensitivity. To facilitate the use of less sensitive, but significantly cheaper, devices, the preconcentration of platinum group metals is employed. For platinum, a multitude of preconcentration approaches have been published. On the contrary, the preconcentration approaches for palladium are still rare. In this work, the development, optimization, and testing of a new approach is described; it is based on a preconcentration of palladium on octadecyl modified silica gel together with the complexing agent dimethylglyoxime, and it is then analyzed with the high-resolution continuum-source atomic absorption spectrometry. For comparison, a newly developed sorbent, QuadraSil™ TA, with a high affinity for platinum group metals was also tested. The preconcentraiton approach was tested on the lichen Hypogymnia physodes, which served as a bioindicator of palladium emissions. The case study site was a mid-sized city in central Europe: Brno, Czech Republic. The dry “bag” monitoring technique was used to collect the palladium near roads with a large span of traffic density. The developed analytical approach confirmed an increasing concentration of palladium with increasing exposure time and intensity of the traffic. Consequently, a simple relationship between the amount of bioaccumulated palladium and traffic density was established.

Triclocarban (TCC), a broad-spectrum lipophilic antibacterial agent, is the main ingredient of personal and health care products. Nonetheless, its ubiquitous presence in the environment has been established to negatively affect the reproduction in humans and animals. In this work, we studied the possible toxic effects of TCC on mouse oocytes maturation in vitro. Our findings revealed that TCC-treated immature mouse oocytes had a significantly reduced rate of polar body extrusion (PBE) compared to that of control. Further study demonstrated that the cell cycle progression and cytoskeletal dynamics were disrupted after TCC exposure, which resulted in the continuous activation of spindle assembly checkpoint (SAC). Moreover, TCC-treated oocytes had mitochondrial damage, reduced ATP content, and decreased mitochondrial membrane potential (MMP). Furthermore, TCC exposure induced oxidative stress and subsequently triggered early apoptosis in mouse oocytes. Besides, the levels of histone methylation were also affected, as indicated by increased H3K27me2 and H3K27me3 levels. In summary, our results revealed that TCC exposure disrupted mouse oocytes maturation through affecting cell cycle progression, cytoskeletal dynamics, oxidative stress, early apoptosis, mitochondria function, and histone modifications in vitro.

The N, S, and Fe-tridoped carbon catalysts (NSFe-Cs), Fe/ACNS1 and Fe/ACNS2, were synthesized by wet impregnation with different concentration of ammonium ferrous sulfate solution. The prepared catalysts have a similar textural structure. The N species, S species, Feᴵᴵ and Feᴵᴵᴵ were simultaneously introduced onto the surface of catalysts. Comparison with the only Fe doped catalyst, NSFe-Cs showed greater stability and higher phenol removal in catalytic wet peroxide oxidation at different reaction condition. The main intermediates including p-hydroxybenzoic acid, formic acid, and maleic acid were determined in the treated wastewater. The high catalytic activity for NSFe-C was related to the ability of H₂O₂ decomposition. NSFe-Cs have more amount of Feᴵᴵ partially due to the formation of FeS₂, which promoted the decomposition of H₂O₂ on Fe/ACNS1 and Fe/ACNS2 surface. The generation of ·OH and ·HO₂/·O₂⁻ radicals in the bulk solution was crucial to phenol degradation, and the decomposition of H₂O₂ complied with the pseudo-first-order kinetics. The highly linear relationship between decomposition kinetic constant for H₂O₂ and the amount of surface groups suggested, including Feᴵᴵ species, pyridinic N/Fe-bonded N, pyrrolic N as well as graphitic N were responsible to the high activity of NSFe-Cs.