In 2020, the COVID-19 pandemic led to government-enforced limits on activities worldwide, causing a marked reduction of human presence in outdoors environments, including in coastal areas that normally support substantial levels of boat traffic. These restrictions provided a unique opportunity to quantify the degree to which anthropogenic noise contributes to and impacts underwater soundscapes. In Guadeloupe, French West Indies, a significantly lower number of motor boats were recorded in the vicinity of the major urban marina during the peak of the first COVID-19 lockdown (April–May 2020), compared with the number recorded post-lockdown. The resumption of human activities at the end of May was correlated with a maximum increase of 6 decibels in the ambient noise level underwater. The change in noise level did not impact daily sound production patterns of vocal fishes, with increased activity at dusk seen both during and after the lockdown period. However, during the lockdown vocal activity was comprised of a reduced number of sounds, suggesting that anthropogenic noise has the potential to interfere with vocalization behaviours in fishes.

Fouling organisms fix and grow on submerged surfaces and may cause several economic losses. Thus, antifouling biocides have been introduced in antifouling paints in order to avoid this phenomenon. However, their widespread use became a global problem, since these substances can be highly toxic to non-target organisms, mainly in high boat traffic areas. The occurrence and environmental behavior of antifouling biocides are especially unknown in areas of ecological relevance, as Amazonian and pre-Amazonian regions. Thus, the aim of this work was to evaluate, for the first time, levels and the partitioning behavior of the antifouling organic biocides irgarol, diuron and also stable degradation products of dichlofluanid and diuron (DMSA and DCPMU, respectively) in sediments and porewaters from a high boat traffic area located in the Northeast of Brazil. Our results showed high concentrations of irgarol and diuron in sediments, and their contamination patterns suggested that misuse and discard of antifouling residues contribute for a serious risk in this environment. Additionally, DCPMU and DMSA were detected for the first time in porewaters of the Brazilian coast. This work represents one of the few registers of contamination, especially by antifouling substances, in Amazonian areas, despite their environmental relevance.

Despite their ban on small vessels in 1989 in the EU, organotin compounds (OTCs) are still being released into the environment due to their presence in historic paint layers on leisure boats. 23 paint samples scraped from recreational boats from three countries around the Baltic Sea were analyzed for total tin (Sn) and OTCs. Two antifouling paint products were also subjected to the same analyses. A new method for the detection of Sn in paint flake samples was developed and found to yield more accurate results compared to four different acid digestion methods. A new method was also developed for the extraction of OTCs from ground paint flakes. This endeavor revealed that existing methods for organotin analysis of sediment may not have full recoveries of OTCs if paint flakes are present in the sample. The hull paint samples had Sn concentrations ranging from 25 to 18,000 mg/kg paint and results showed that tributyltin (TBT) was detected in all samples with concentrations as high as 4.7 g (as Sn)/kg paint. TBT was however not always the major OTC. Triphenyltin (TPhT) was abundant in many samples, especially in those originating from Finland. Several other compounds such as monobutyltin (MBT), dibutyltin (DBT), tetrabutyltin (TeBT), monophenyltin (MPhT) and diphenyltin (DPhT) were also detected. These could be the result of degradation occurring on the hull or of impurities in the paint products as they were also identified in the two analyzed paint products. A linear correlation (r2 = 0.934) was found between the total tin content and the sum of all detected OTCs. The detection of tin can therefore be used to indicate the presence of OTCs on leisure boats.

The resuspension of polluted sediments by boat traffic could release substantial amounts of metals to the water column, affecting at the same time their bioavailability. In order to characterize the impact of sediment resuspensions on biota, caged amphipods have been deployed on three different channelized watercourses in Northern France. Firstly, the biological responses of transplanted freshwater gammarid amphipods, Gammarus fossarum, described by trace metal accumulation, feeding and reproduction activities were quite similar for the three water courses despite the differences of metal contamination and navigability. Secondly, the concentrations of metals accumulated in gammarids never exceeded the contamination thresholds previously defined for Co, Cu, Cr and Zn. Values were in the same order of magnitude whatever the studied site despite: (i) large differences noticed in the sediment quality and (ii) some concentrations in the overlying waters exceeding the Environmental Quality Standards (EQS) defined by the Water Framework Directive. Conversely, Pb was highly bioaccumulated with values systematically exceeding the threshold value whatever the site. Therefore, the impact of navigation cannot be proved and the difference between the 3 monitoring periods is rather attributed to environmental variability, probably linked to the seasonality. Moreover, this study also confirms that organisms sampled from a local population in the vicinity of the three studied watercourses could be used as test organisms, leading to similar results than the ones obtained with reference gammarids initially used for developing all the biological responses. This would simplify and then promote the development of studies based on gammarid amphipod, G. fossarum, as bioindicators.

This study presents the chemical composition of VOCs in air and gas discharges collected at Nisyros Island (Dodecanese Archipelago, Greece). The main goals are i) to discriminate between natural and anthropogenic VOC sources and ii) to evaluate their impact on local air quality. Up to 63 different VOCs were recognized and quantitatively determined in 6 fumaroles and 19 air samples collected in the Lakki caldera, where fumarolic emissions are located, and the outer ring of the island, including the Mandraki village and the main harbor. Air samples from the crater area show significant concentrations of alkanes, alkenes, cyclic, aromatics, and S- and O-bearing heterocycles directly deriving from the hydrothermal system, as well as secondary O-bearing compounds from oxidation of primary VOCs. At Mandraki village, C6H6/Σ(methylated aromatics) and Σ(linear)/Σ(branched) alkanes ratios <1 allow to distinguish an anthropogenic source related to emissions from outlet pipes of touristic and private boats and buses.

Antifouling paint particles (APPs) of between 500 μm and >2 mm in diameter have been identified in silty, intertidal estuarine sediments through a combination of microscopy and x-ray fluorescence spectrometry. APPs were heterogeneously distributed, with maximal concentrations of 430 particles L−1 (0.2 g L−1) near to a facility where boats are regularly maintained and 400 particles L−1 (4.2 g L−1) at a location where old boats had been abandoned, with the majority of particles encountered in the finest size fraction retrieved. APPs contained variable concentrations of Cu, Zn, Sn and Pb, with respective maxima of 562,000, 269,000, 9,970 and 126,000 mg kg−1. These characteristics are attributed to a multitude of contemporary and historic sources of an assortment of formulations and result in significant but heterogeneous metal contamination of local sediments. APPs were also identified in the guts of the deposit-feeding ragworm, Hediste diversicolor, that inhabited sediments impacted by abandoned boats or boating activities. The tissue of H. diversicolor was particularly enriched in Cu where ingested APPs were observed, with a significant correlation between dry weight Cu concentrations in the two media (r = 0.734) presumably reflecting the inability of the animal to regulate this metal. While the toxicity of APPs requires further investigation, there is clearly a need for stricter regulations on antifouling wastes in boatyards and marinas and a requirement to better manage abandoned boats.

Tributyltin (TBT) and other organotin compounds have been restricted for use on leisure boats since 1989 in the EU. Nonetheless, release of TBT is observed from leisure boats during hull maintenance work, such as pressure hosing. In this work, we used a handheld X-ray Fluorescence analyser (XRF) calibrated for antifouling paint matrixes to measure tin, copper and zinc in antifouling paints coated on leisure boats in Sweden. Our results show that over 10% of the leisure boats (n = 686) contain >400 μg/cm2 of tin in their antifouling coatings. For comparison, one layer (40 μm dry film) of a TBT-paint equals ≈ 800 μg Sn/cm2. To our knowledge, tin has never been used in other forms than organotin (OT) in antifouling paints. Thus, even though the XRF analysis does not provide any information on the speciation of tin, the high concentrations indicate that these leisure boats still have OT coatings present on their hull. On several leisure boats we performed additional XRF measurements by progressively scraping off the top coatings and analysing each underlying layer. The XRF data show that when tin is detected, it is most likely present in coatings close to the hull with several layers of other coatings on top. Thus, leaching of OT compounds from the hull into the water is presumed to be negligible. The risk for environmental impacts arises during maintenance work such as scraping, blasting and high pressure hosing activities. The data also show that many boat owners apply excessive paint layers when following paint manufacturers recommendations. Moreover, high loads of copper were detected even on boats sailing in freshwater, despite the more than 20 year old ban, which poses an environmental risk that has not been addressed until now.

Tire-derived particles and polyethylene (PE) debris co-exist in estuaries and potentially deteriorate water quality. Chemicals can be emitted from tire-derived particles and resorb to PE debris. However, there was lack of information about the interaction (e.g., sorption and desorption) between tire-derived chemicals and PE debris. By combining batch sorption and desorption experiments along with in situ field deployment of PE sheets, we examined the utility of benzothiazoles (BTZs) sorbed in PE as suitable markers of tire-derived inputs. The sorptive characteristics and PE-water partition coefficients (often designated as Kₚₑw) of selected tire-derived marker candidates, i.e., polycyclic aromatic hydrocarbons (PAHs), benzothiophenes (BTPs) and BTZs, were measured. Moderately polar BTPs and BTZs (except for 2-(4-morpholinyl) benzothiazole) reached equilibrium within 2–8 days, compared to 20 days for nonpolar PAHs. The measure Kₚₑw values and octanol-water partition coefficients of PAHs and BTZs were linearly correlated with each other (r² > 0.80; p < 0.05). The desorption potentiality of PAHs and BTZs from tire particles is consistent with the hydrophilic properties of the target chemicals, while desorption ratios of BTZs and PAHs are 25–87% and <20%, respectively. Samplers with PE sheets as the sorbent phase were deployed in Hailing Bay, an urbanized estuary in South China, to measure concentrations of PAHs, BTPs and BTZs. Benzothiazoles sorbed in PE samples were associated with the massive utilization of automobile tires, while PAHs were linked to the boat maintenance facilities and BTPs were not detected in any tire particle and field PE samples. Therefore sorbed BTZs in PE can potentially serve as chemical markers of tire-derived inputs to estuaries.

Anthropogenic noise underwater is increasingly recognized as a pollutant for marine ecology, as marine life often relies on sound for orientation and communication. However, noise may not only interfere with processes mediated through sound, but also have effects across sensory modalities. To understand the mechanisms of the impact of anthropogenic sound to its full extent, we also need to study cross-sensory interference. To study this, we examined the effect of boat sound playbacks on olfactory-mediated food finding behaviour of shore crabs. We utilized opaque T-mazes with a consistent water flow from both ends towards the starting zone, while one end contained a dead food item. In this way, there were no visual or auditory cues and crabs could only find the food based on olfaction. We did not find an overall effect of boat sound on food finding success, foraging duration or walking distance. However, after excluding deviant data from one out of the six different boat stimuli, we found that crabs were faster to reach the food during boat sound playbacks. These results, with and without the deviant data, seem to contradict an earlier field study in which fewer crabs aggregated around a food source during elevated noise levels. We hypothesise that this difference could be explained by a difference in hunger level, with the current T-maze crabs being hungrier than the free-ranging crabs. Hunger level may affect the motivation to find food and the decision to avoid or take risks, but further research is needed to test this. In conclusion, we did not find unequivocal evidence for a negative impact of boat sound on the processing or use of olfactory cues. Nevertheless, the distinct pattern warrants follow up and calls for even larger replicate samples of acoustic stimuli for noise exposure experiments.

Copper-containing antifouling paints (AFP) are widely used for leisure boat maintenance. Cu emitted from AFP into German surface water bodies has been suggested to be a significant source of heavy metal pollution, threatening water quality. We developed two scenarios to model Cu emissions from AFP applied on leisure boats on national scale, which allow identifying regional hotspots. The top-down approach (scenario A) was based on a previous study on national AFP consumption, while in the bottom-up approach (scenario B), median and interquartile range of Cu release rates depending on salinity conditions were considered for emission estimation. Both scenarios clearly highlighted the locally high emission pressure on inland waters in popular watersport regions, identifying these as requiring intense protection. Scenario B generally predicted lower Cu emissions (sea: 11.05–25.53 t a⁻¹, inland: 14.15–34.59 t a⁻¹) than scenario A (sea: 22.53 t a⁻¹, inland: 47.97 t a⁻¹). To evaluate their relevance, scenario results were compared to emissions modelled with MoRE (Modelling of Regionalized Emissions), which is used as reporting tool on substance emissions by Germany. According to scenarios A and B, the emission from AFP accounted for 13 % and 4–9 % of the total Cu emissions into inland waters in 2016, respectively. Scenario results were similar or higher than other emission pathways such as industrial direct dischargers. Thus, we consider Cu emissions from AFP as a significant pathway to be included in the MoRE emission inventory. We recommend scenario B for implementation as it allows a more flexible adaptation for future modelling.