Batch adsorption process was employed to remove copper(II) and cadmium(II) ions from contaminated water using dried orange peel powder as a cellulosic adsorbent, which supports circular economy and sustainability. Metal ion concentrations were determined using a flame atomic absorption spectroscopy (FAAS). Effects of pH, sorbate-sorbent contact time, metal ion concentration and adsorbent dose on the removal efficiency of the metal ions was investigated. The adsorption equilibrium was reached at 120 and 150 minutes for Cu(II) ions and Cd(II) ions, respectively. At optimized pH and biosorbent load, 10 mg L-1 of Cu(II) and Cd(II)  ions could be removed to the extent 96.9% and 98.1%, respectively, within 2 hrs. However, the percentage removal of metal ions decreased with increasing their initial concentrations. The observed adsorption data was also interpreted in terms of Langmuir and Freundlich adsorption isotherm models. The calculated equilibrium data fitted more adequately with Freundlich model (higher correlation coefficient, R2) than Langmuir model, indicating heterogeneity of adsorption sites due to different functional groups in cellulose. Cd(II) ions showed less binding affinity and less desorption than Cu(II) ions. The maximum adsorption capacity (qmax) of dried orange peel were 2.78 mg/g and 2.57 mg/g for copper(II) and cadmium(II) ions, respectively.

Root cell wall (RCW) modification is a widespread important defense strategy of plant to cope with trace metals. However, mechanisms underlying its remolding in cadmium (Cd) accumulation are still lacking in hyperaccumulators. In this study, changes of RCW structures and components between nonhyperaccumulating ecotype (NHE) and hyperaccumulating ecotype (HE) of Sedum alfredii were investigated simultaneously. Under 25 μM Cd treatment, RCW thickness of NHE is nearly 2 folds than that of HE and the thickened cell wall of NHE was enriched in low-methylated pectin, leading to more Cd trapped in roots tightly. In the opposite, large amounts of high-methylated pectin were assembled around RCW of HE with Cd supply, in this way, HE S. alfredii decreased its root fixation of Cd and enhanced Cd migration into xylem. TEM and AFM results further confirmed that thickened cell wall was caused by the increased amounts of cellulose and lignin while root tip lignification was resulted from variations of sinapyl (S) and guaiacyl (G) monomers. Overall, thickened cell wall and methylated pectin have synchronicity in spatial location of roots, and their coordination contributed to Cd accumulation in S. alfredii.

Pyrogenic char (biochar) with a high sorption capacity (B-HSC) can sequester hazardous chemicals (e.g., phenanthrene). However, when sorption inhibits bioavailability of some functional chemicals (e.g., the herbicidal efficacy of diuron in soil), biochar with a low sorption capacity (B-LSC) is required to prevent sorption effects. The pyrolytic B-HSC generation has been reported, but information on B-LSC formation is scarce. How fast B-HSC and B-LSC could be generated is unknown until now. Here, biochars were rapidly prepared (the shortest heating time reached 5 min and the cooling time reached < 30 min) by a direct-pyrolysis method by directly exposing packaged rice straw and pine wood to 350 °C, 500 °C and 700 °C and out-of-furnace cooling at room temperature. The sorption of diuron, phenanthrene, and twelve other chemicals was investigated. B–HSCs were obtained within 30 min of rice straw pyrolysis, and the biochar Kd values quickly increased to 7-730-fold that of the raw biomass as –OH and C–O–C in (hemi)cellulose of rice straw rapidly degraded, increasing hydrophobic interactions between the char and chemicals (solubility ≤ 82.8 g/L). In contrast, B-LSCs were generated within 30 min of PW pyrolysis, and the Kd values of the biochars were 0.2–3.0-fold that of the raw biomass, as the surface area development and hydrophobicity-driven sorption were probably delayed by the late degradation of lignin aromatic C–O and phenolic –OH. Biochar amendment revealed an enhancement effect of B-HSC but not of B-LSC on soil sorption. The fast formation of B-LSC and B-HSC provides a guide to develop time- and cost-effective technique in pyrolytically producing weakly or strongly sorbing biochars for organic chemical management.

Developing low-cost and high-performance biosorbent for water purification continues drawing more and more attention. In this study, cellulose-chitosan composite hydrogels were fabricated via a co-dissolution and regeneration process using a molten salt hydrate (a 60 wt% aqueous solution of LiBr) as a solvent. The addition of chitosan not only introduced functionality for metal adsorption but also increased the specific surface area and improved the mechanical strength of the composite hydrogel, compared to pure cellulose hydrogel. Batch adsorption experiments indicated that the composite hydrogel with 37% cellulose and 63% chitosan exhibited an adsorption capacity of 94.3 mg/g (1.49 mmol/g) toward Cu²⁺ at 23 °C, pH 5, and initial metal concentration of 1500 mg/L, which was 10 times greater than the adsorption capacity of pure cellulose hydrogel. Competitive adsorption from a mixed metals solution revealed that the cellulose-chitosan composite hydrogel exhibited selective adsorption of the metals in the order of Cu²⁺ > Zn²⁺ > Co²⁺. This study successfully demonstrated an innovative method to fabricate biosorbents from abundant and renewable natural polymers (cellulose and chitosan) for removing metal ions from water.

Ammonium molybdophosphate (AMP) exhibits high selectivity towards Cs but it cannot be directly applied in column packing, so it is necessary to prepare AMP–based adsorbents into an available form to improve its practicality. This work provided two AMP immobilized cellulose microspheres (MCC@AMP and MCC-g-AMP) as adsorbents for Cs removal by radiation grafting technique. MCC-g-AMP was prepared by radiation graft polymerization of GMA on microcrystalline cellulose microspheres (MCC) followed by reaction with AMP suspension, and MCC@AMP was synthesized by radiation hybrid grafting of AMP and GMA onto MCC through one step. The different structures and morphologies of two adsorbents were characterized by FTIR and SEM. The adsorption properties of two adsorbents against Cs were investigated and compared in batch and column experiments under different conditions. Both adsorbents were better obeyed pseudo-second-order kinetic model and Langmuir model. MCC-g-AMP presented faster adsorption kinetic and more stable structure, whereas MCC@AMP presented more facile synthesis and higher adsorption capacity. MCC@AMP was pH independent in the range of pH 1–12 but MCC-g-AMP was sensitive to pH for Cs removal. The saturated column adsorption capacities of MCC@AMP and MCC-g-AMP were 5.4 g-Cs/L-ad and 0.75 g-Cs/L-ad in column adsorption experiments at SV 10 h⁻¹. Both adsorbents exhibited very high radiation stability and can maintain an adsorption capacity of >85% even after 1000 kGy γ-irradiation. On the basis, two AMP-loaded adsorbents possessed promising application in removal of Cs from actual contaminated groundwater. These findings provided two efficient adsorbents for treatment of Cs in radioactive waste disposal.

Smoked cigarette filters a. k.a. “butts”, composed of plastic (e.g. cellulose acetate) are one of the world’s most common litter items. In response to concerns about plastic pollution, biodegradable cellulose filters are being promoted as an environmentally safe alternative, however, once smoked, both contain toxins which can leach once discarded. The impacts of biodegradable butts as littered items on the receiving environment, in comparison with conventional butts has not yet been assessed. A freshwater mesocosm experiment was used to test the effects of leachate from smoked cellulose acetate versus smoked cellulose filters at a range of concentrations (0, 0.2, 1 and 5 butts L⁻¹) on the mortality and behaviour of four freshwater invertebrates (Dreissena polymorpha, Polycelis nigra, Planorbis planorbis and Bithynia tentaculata). Leachate derived from 5 butts L⁻¹ of either type of filter caused 60–100% mortality to all species within 5 days. Leachate derived from 1 butt L⁻¹ of either type resulted in adults being less active than those exposed to no or 0.2 butts L⁻¹ leachate. Cigarette butts, therefore, regardless of their perceived degradability can cause mortality and decreased activity of key freshwater invertebrates and should always be disposed of responsibly.

The microparticle content of 37 common facial and body scrubs commercially available in the United Arab Emirates was analyzed. The chemical composition, ash content, physical characteristics, loading, particle size and shape of the microparticles were determined. Only 11 out of 37 products were found to have microplastic content. Many of the remaining products exhibited microparticles composed of microcrystalline cellulose and crushed walnut shells. Differential scanning calorimetry showed that microplastic products had softening points as low as 84 °C. Plastic microbeads of 2 products were found to fuse at 100 °C. The fusion altered the flotation characteristics of the microbeads of one product. Heat treatment of the product at 100 °C in the presence of silica gel led to entrainment of the silica and partial fragmentation of the beads upon cooling. This may be understood as one mechanism of fragmentation of a microplastic with a low softening point in the presence of hard soil particles under temperature cycling.

Knowledge of adsorption behavior of organic contaminants on high heat temperature treated biochars is essential for application of biochars as adsorbents in wastewater treatment and soil remediation. In this study, isotherms of 25 aromatic compounds adsorption on biochars pyrolyzed at 700 °C from biomass including wood chips, rice straw, bamboo chips, cellulose, lignin and chitin were investigated to establish correlations between adsorption behavior and physicochemical properties of biochars. Isotherms were well fitted by Polanyi theory-based Dubinin-Ashtakhov (DA) model with three parameters, i.e., adsorption capacity (Q⁰) and adsorption affinity (E and b). Besides the negative correlation of Q⁰ with molecular maximum cross-sectional areas (σ) of organic compounds, positive correlations of Q⁰ with total pore volume (Vₜₒₜₐₗ) and average diameter of micropore (D) of biochars were observed, indicating that adsorption by biochars is captured by the pore-filling mechanism with molecular sieving effect in biochar pores. Linear solvation energy relationships (LSERs) of adsorption affinity (E) with solvatochromic parameters of organic compounds (i. e., αₘ and π∗) were established, suggesting that hydrophobic effect, π-π interaction and hydrogen-bonding interaction are the main forces responsible for adsorption. The regression coefficient (π₁) and intercept (C) of obtained LSERs are correlated with biochar H/C and Rₘᵢcᵣₒ, respectively, implying that biochars with higher aromaticity and more micropores have stronger π-π bonding potential and hydrophobic effect potential with aromatic molecule, respectively. However, hydrogen-bonding potential of biochars for organic molecules is not changed significantly with properties of biochars. A negative correlation of b with biochar H/C is also obtained. These correlations could be used to predict the adsorption behavior of organic compounds on high heat temperature treated biochars from various biomass for the application of biochars as sorbents and for the estimating of environmental risks of organic compounds in the present of biochars.

Aluminum (Al) phytotoxicity is a major limitation in the production of crops in the soils with pH ≤ 5. Boron (B) is indispensable nutrient for the development of higher plants and B role has been reported in the alleviation Al toxicity. Trifoliate orange rootstock was grown in two B and two Al concentrations. The results of the present study showed that Al toxicity adversely inhibited root elongation and exhibited higher oxidative stress in terms of H2O2 and O2− under B-deficiency. Additionally, the X-ray diffraction (XRD) analysis confirmed the increase of the cellulose crystallinity in the cell wall (CW). Al-induced remarkable variations in the CW components were prominent in terms of alkali-soluble pectin, 2-keto-3-deoxyoctonic acid (KDO) and the degree of methyl-esterification (DME) of pectin. Interesting, B supply reduced the pectin (alkali-soluble) under Al toxicity. Moreover, the results of FTIR (Fourier transform infrared spectroscopy) and 13C-NMR (13C nuclear magnetic resonance) spectra revealed the decrease of carboxyl groups and cellulose by B application during Al exposure. Furthermore, B supply tended to decrease the Al uptake, CW thickness and callose formation. The study concluded that B could mitigate Al phytotoxicity by shielding potential Al binding sites and by reducing Al induced alterations in the CW cellulose and pectin components.

Coupling with triolein-embedded cellulose acetate membrane (TECAM) technique, hydroxypropyl β-cyclodextrins (HPCD) extraction method, and the greenhouse pot experiments, the influences of biochars on polychlorinated biphenyls (PCBs) bioavailability in soil to plant (Brassica chinensis L. and Daucus carota) were investigated. Addition of 2% biochars to soils significantly reduced the uptake of PCBs in plant, especially for di-, tri- and tetra-chlorobiphenyls. PCBs concentrations in the roots of B. chinensis and D. carota were reduced for 61.5–93.7%, and 12.7–62.4%, respectively in the presence of biochars. The kinetic study showed that in the soils amended with/without biochars, PCBs concentrations accumulated in TECAM, as well as in the HPCD extraction solution, followed significant linear relationships with those in plant roots. Application of biochars to soil is a potentially promising method to reduce PCBs bioavailability whereas TECAM technique can be a useful tool to predict the bioavailability of PCBs in soil.