Increasing concerns over bisphenol A (BPA) as an endocrine disrupting chemical (EDC) and its adverse effects on both humans and animals have led to the substitution by structural analogs, such as bisphenol F (BPF), in many application areas. Information regarding to the carry-over of this emerging chemical in farm animals is essential for legislation and risk assessment purposes. In this study, a large-scale number of animal experiments were designed to investigate the transfer of BPF from feed to eggs. One control and three experimental groups of laying hens (72 hens per group) were fed with basal diets and BPF-contaminated feed at concentration levels of 0.1, 0.5 and 2.5 mg kg⁻¹, respectively, for two weeks. The hens were then fed with BPF-free diets for a further four weeks. Eggs were collected daily, and separated into egg yolk and white for BPF analysis. The effects of different levels of BPF exposure on laying performance followed a non-monotonic dose-response curve, since low level BPF (0.1 mg kg⁻¹) exposure did increase the laying rate, mean egg weight and daily feed intake, while high level BPF (2.5 mg kg⁻¹) exposure showed a decreasing trend. BPF residues were detected in both egg yolks and whole eggs after two days of administration, and plateau phase was achieved within 9–18 days. There are clear linear dose-response relationships between the plateau BPF concentrations in feed and eggs. The residue of BPF was found mainly in egg yolks with conjugated form and depleted slowly (still detected 21 days after feeding the BPF-free diet of the high level group). Mean carry-over rate of 0.59% BPF from feed to eggs was obtained. Compared with the carry-over rates of PCBs and dioxins, BPF showed a relatively minor trend of bioaccumulation in eggs. To the best of our knowledge, this is the first report on the deposition, depletion, and bioaccumulation study of bisphenols in farm animals. The quantity of data can therefore be helpful in the frame of risk assessment, especially for a comprehensive estimation of consumer exposure to the residues of bisphenols.

The widespread adoption of genetically modified, glyphosate-tolerant corn and soybean varieties in US crop production has led to a dramatic increase in glyphosate usage. Though present at or below regulatory limits currently set for human foodstuffs, the concentration of glyphosate in companion animal feed is currently unknown. In the present study, 18 commercial companion animal feeds from eight manufacturers were analyzed for glyphosate residues using ELISA. Every product contained detectable glyphosate residues in the range of 7.83 × 10¹–2.14 × 10³ μg kg⁻¹ dry weight, with the average and medians being 3.57 × 10² and 1.98 × 10² μg kg⁻¹ respectively. Three products were tested for within-bag variation and six were tested for lot to lot variation. Little within-bag variation was found, but the concentration of glyphosate varied by lot in half of the products tested. Glyphosate concentration was significantly correlated with crude fiber content, but not crude fat or crude protein. Average daily intakes by animals consuming feeds containing the median glyphosate concentration are estimated to result in exposures that are 0.68–2.5% of the Allowable Daily Intake (ADI) for humans in the US and EU, which are 1750 and 500 μg kg⁻¹ respectively. Consumption of the most contaminated feed, however, would result in exposure to 7.3% and 25% of the above ADIs, though the relevance of such an exposure to companion animals is currently unknown.Companion animal feeds contained 7.83 × 10¹–2.14 × 10³ μg kg⁻¹ glyphosate which is likely to result in pet exposure that is 4–12 times higher than that of humans on a per Kg basis.

Diet is considered as the most important human exposure pathway for polybrominated diphenyl ethers (PBDEs). Metabolism and accumulation patterns of PBDEs in different growth periods of chickens are helpful for evaluating human dietary exposure, but such information is scarce. In this study, female chickens were fed with food spiked with BDE-209 at 85 mg kg⁻¹, and the intake, accumulation, and excretion of BDE-209 and its main metabolites in various tissues were examined. Concentrations of BDE-209 in chicken tissues increased over time in a tissue-specific manner; they were the greatest in liver and generally the lowest in breast meat during the entire exposure period. The kinetic patterns were dependent on both growth-dilution effects and accumulated concentrations of BDE-209. Tissue concentrations of ∑8PBDE (sum of BDE-28, 47, 99, 100, 153, 154, 183, and 209) followed the sequence of liver > blood > skin > intestine > stomach > leg meat > breast meat. Different tissue partition coefficients and perfusion rates for blood may have resulted in different PBDE concentrations in tissues. The absorption efficiency of BDE-209 in chicken tissues followed the sequence of liver (0.15 ± 0.032%) > skin (0.14 ± 0.038%) > intestine (0.071 ± 0.021%) > breast meat (0.062 ± 0.020%) > leg meat (0.059 ± 0.016%) > stomach (0.021 ± 0.0095%), likely due in part to facilitated absorption of BDE-209 by transport proteins (P-glycoproteins). On average, 9.3 ± 1.7% of BDE-209 was excreted in feces. Estimated human average dietary intake via the consumption of chicken tissues of ∑8PBDE for adults and children was 319 and 1380 ng day⁻¹ for liver, 211 and 632 ng day⁻¹ for leg meat, and 104 and 311 ng day⁻¹ for breast meat from the contaminated group. Liver clearly poses the highest exposure risk for human consumption, particularly if chickens are fed with contaminated feed.

Chicken organs, animal feed, droppings, and ambient air were sampled at a farm in Beijing to determine the concentrations of hexachlorocyclohexane isomers (HCHs) and dichlorodiphenyltrichloroethane and metabolites (DDTs). Mean fresh weight concentrations of HCHs and DDTs were 0.122 ± 0.061 ng/g and 0.051 ± 0.038 ng/g in the muscles. These values are 1-2 orders of magnitude lower than those reported in China in 1980. Contaminated feed was the main source of HCHs and DDTs. Only 12.8% of HCH and 3.3% of DDT of the amount consumed were excreted. Accumulated quantities of HCHs and DDTs increased during growth. However, concentrations of HCHs and DDTs did not increase because of dilution from rapid growth. Based on the observed residual levels in mature chicken and the average diet of residents of China, the contributions from chicken and egg consumption to per capita daily intake of HCHs and DDTs were 487% and 88% of those of fish consumption.

This report deals with the application of ion exchange columns to the treatment of groundwater contaminated by high concentrations of arsenic in the presence of sulphates. Two different process layouts were tested, based on the use of a single column and of two-in-series columns, respectively. Several breakthrough tests were performed, where the effect of the operating parameters, as the influent flow rate, the packed bed height and the feed water composition, were investigated. The collected data were described using three different modeling approaches, based on the Bohart–Adams, Yan and Thomas models, respectively. These models were all found to describe the experimental data with a quite good agreement (based on the R 2 value). The ion exchange capacity evaluated by the models (about 3.8 mEq/g) was comparable with the value provided by the supplier (3.8 mEq/g), but higher than the value determined through batch tests of a previous study by the same authors. The models were then successfully applied to describe the breakthrough behaviour of the two in-series column plant using a real feed contaminated by high arsenic concentrations in the presence of sulphate.

The present study was conducted to investigate the effect of graded levels of dietary bentonite supplementation on growth performance, carcass traits, nutrient digestibility, and histopathology of certain organs in rabbits fed a diet naturally contaminated with aflatoxin. In total, 125 weanling New Zealand White male rabbits were randomly assigned to five treatment groups each of five replicates. Treatments were as follows: T1, basal diet with no aflatoxin and no additives (positive control diet, PCD); T2, basal diet naturally contaminated with 150 ppb aflatoxin and no additives (negative control diet, NCD); T3, NCD plus 0.5% Egyptian bentonite; T4, NCD plus 1% Egyptian bentonite; and T5, NCD plus 1% Egyptian bentonite. The experiment lasted for 8 weeks. Results showed a significant decrease (P < 0.05) in the body weight and the body weight gain in the NCD, while they were improved (P < 0.05) in groups fed diets supplemented with different levels of bentonite. The relative weight of the liver and kidneys were higher in the NCD, while the liver weight was relatively high in the group fed NCD supplemented with 0.5% bentonite, and it was not significant in other bentonite-supplemented groups. Bentonite supplementation improved the digestibility coefficients of various nutrients. Bentonite addition decreased the histopathological lesions in liver, kidney, and intestine caused by aflatoxin-infected diets. In conclusion, bentonite supplementation overcame the negative effect of aflatoxin, enhanced growth performance traits, decreased the relative weights of the liver and the kidney which are usually increased by aflatoxin, caused significant improvement in nutrients’ digestibility, and decreased the histopathological lesions caused by aflatoxin-infected diets. The level of 2% bentonite is recommended for ameliorating the aflatoxin effects.

This report gives a summary of the historic use, former management and current release of polychlorinated biphenyls (PCBs) in Germany and assesses the impact of the life cycle of PCBs on the contamination of the environment and of food products of animal origin. In Germany 60,000 t of PCBs were used in transformers, capacitors or as hydraulic oils. The use of PCB oils in these “closed applications”, has been banned in Germany in 2000. Thirty to 50% of these PCBs were not appropriately managed. In West Germany, 24,000 t of PCBs were used in open applications, mainly as additive (plasticiser, flame retardant) in sealants and paints in buildings and other construction. The continued use in open applications has not been banned, and in 2013, an estimated more than 12,000 t of PCBs were still present in buildings and other constructions. These open PCB applications continuously emit PCBs into the environment with an estimated release of 7–12 t per year. This amount is in agreement with deposition measurements (estimated to 18 t) and emission estimates for Switzerland. The atmospheric PCB releases still have an relevant impact on vegetation and livestock feed. In addition, PCBs in open applications on farms are still a sources of contamination for farmed animals. Furthermore, the historic production, use, recycling and disposal of PCBs have contaminated soils along the lifecycle. This legacy of contaminated soils and contaminated feed, individually or collectively, can lead to exceedance of maximum levels in food products from animals. In beef and chicken, soil levels of 5 ng PCB-TEQ/kg and for chicken with high soil exposure even 2 ng PCB-TEQ/kg can lead to exceedance of EU limits in meat and eggs. Areas at and around industries having produced or used or managed PCBs, or facilities and areas where PCBs were disposed need to be assessed in respect to potential contamination of food-producing animals. For a large share of impacted land, management measures applicable on farm level might be sufficient to continue with food production. Open PCB applications need to be inventoried and better managed. Other persistent and toxic chemicals used as alternatives to PCBs, e.g. short chain chlorinated paraffins (SCCPs), should be assessed in the life cycle for exposure of food-producing animals and humans.

Beef and dairy products may be important vectors of human exposure to perfluoroalkyl acids (PFAAs), but the understanding of how PFAAs are accumulated and transferred through agricultural food chains is very limited. Here, the bioaccumulation of PFAAs in dairy cows receiving naturally contaminated feed and drinking water was investigated by conducting a mass balance of PFAAs for a herd of dairy cows in a barn on a typical Swedish dairy farm. It was assumed that the cows were able to reach steady state with their dietary intake of PFAAs. Perfluorooctane sulfonic acid (PFOS) and perfluoroalkyl carboxylic acids (PFCAs) with 8 to 12 carbons were detected in cow tissue samples (liver, muscle, and blood) at concentrations up to 130 ng kg(-1). Mass balance calculations demonstrated an agreement between total intake and excretion within a factor of 1.5 and consumption of silage was identified as the dominant intake pathway for all PFAAs. Biomagnification factors (BMFs) were highly tissue and homologue specific. While BMFs of PFOS and PFCAs with 9 and 10 fluorinated carbons in liver ranged from 10 to 20, perfluorooctanoic acid (PFOA) was not biomagnified (BMF < 1) in any of the investigated tissues. Biotransfer factors (BTFs; defined as the concentration in tissue divided by the total daily intake) were calculated for muscle and milk. Log BTFs ranged from -1.95 to -1.15 day kg(-1) with the highest BTF observed for PFOS in muscle. Overall, the results of this study suggest that long-chain PFAAs have a relatively high potential for transfer to milk and beef from the diet of dairy cows. However, a low input of PFAAs to terrestrial systems via atmospheric deposition and low bioavailability of PFAAs in soil limits the amount of PFAAs that enter terrestrial agricultural food chains in background contaminated environments and makes this pathway less important than aquatic exposure pathways. The BTFs estimated here provide a useful tool for predicting human exposure to PFAAs via milk and beef under different contamination scenarios.