This review summarizes the most relevant information on PBDEs’ occurrence and their impacts in cetaceans at global scale, with special attention on the species with the highest reported levels and therefore the most potentially impacted by the current and continuous release of these substances. This review also emphasizes the anthropogenic and environmental factors that could increase concentrations and associated risks for these species in the next future. High PBDE concentrations above the toxicity threshold and stationary trends have been related to continuous import of PBDE-containing products in cetaceans of Brazil and Australia, where PBDEs have never been produced. Non-decreasing levels documented in cetaceans from the Northwest Pacific Ocean might be linked to the increased e-waste import and ongoing production and use of deca-BDE that is still allowed in China. Moreover, high levels of PBDEs in some endangered species such as beluga whales (Delphinapterus leucas) in St. Lawrence Estuary and Southern Resident killer whales (Orcinus Orca) are influenced by the discharge of contaminated waters deriving from wastewater treatment plants. Climate change related processes such as enhanced long-range transport, re-emissions from secondary sources and shifts in migration habits could lead to greater exposure and accumulation of PBDEs in cetaceans, above all in those species living in the Arctic. In addition, increased rainfall could carry greater amount of contaminants to the marine environment, thereby, enhancing the exposure and accumulation especially for coastal species. Synergic effects of all these factors and ongoing emissions of PBDEs, expected to continue at least until 2050, could increase the degree of exposure and menace for cetacean populations. In this regard, it is necessary to improve current regulations on PBDEs and broader the knowledge about their toxicological effects, in order to assess health risks and support regulatory protection for cetacean species.

Insight in the phosphorus (P) flows and P balances in the food chain is largely unknown at county scale in China, being the most appropriate spatial unit for nutrient management advice. Here, we examined changes in P flows in the food chain in a typical agricultural county (Quzhou) during 1980–2017, using substance flow analyses. Our results show that external P inputs to the county by feed import and fertilizer were 7 times greater in 2017 than in 1980, resulting in a 7-fold increase in P losses to the environment in the last 3 decades, with the biggest source being animal production. Phosphorus use efficiency decreased from 51% to 30% in crop production (PUEc) and from 32% to 11% in the whole food chain (PUEf), but increased from 4% to 7% in animal production (PUEa). A strong reduction in P inputs and thus increase in PUE can be achieved by balanced P fertilization, which is appropriate for Quzhou considering a current average adequate soil P status. Fertilizer P use can be reduced from 7276 tons yr⁻¹ to 1765 tons yr⁻¹ to equal P removal by crops. This change would increase P use efficiency for crops from 30% to 86% but it has a negligible effect on P losses to landfills and water bodies. Increasing the recycling of manure P from the current 43%–95% would reduce fertilizer P use by 17% and reduce P losses by 47%. A combination of reduced fertilizer P use and increased recycling of manure P would save fertilizer P by 93%, reduce P accumulation by 100% and P loss by 49%. The results indicate that increasing manure-recycling and decreasing fertilizer-application are key to achieving sustainable P use in the food chain, which can be achieved through coupling crop-livestock systems and crop-based nutrient management.

China is the largest plastic consumer in the world. Despite its plastic waste import ban in 2017, this populous economy inevitably generates a large amount of waste, including plastic waste, a considerable part of which has become marine litter. Data from the 2018 National Coastal Cleanup and Monitoring Project, the largest beach litter monitoring activities using the citizen science approach in China, have been retrieved and analyzed to understand spatial patterns, composition, and original usage of marine litter. Within this project, 24 beaches were surveyed every two months. As a result, the mean density was 3.85 ± 5.39 items m⁻², much higher than that reported by previous studies in China. There were great differences in the spatial distribution of litter. The highest densities appeared in the runoff-affected area of the Yangtze River, which was another difference from previous studies. Low-density, easy-to-transport foamed plastics were the major contributor to marine litter in these areas. Along China’s coast, approximately 90% of litter was from land-based sources, and over half of that originated from domestic sources. Including foamed plastic products, plastic litter with low recycling value dominated. Both natural and human factors influencing the spatiotemporal distribution and composition of litter are discussed. Socioeconomic factors, such as the lifestyle and consumption levels of citizens and local waste management systems, are possible explanations for the low-value characteristic of marine litter. The deviation between previous data and citizen science data in this study may be caused by many factors. Based on the discussion on these factors, some suggestions for citizen science research in China are also put forward.

Africa's economy is growing faster than any other continent and it has been estimated that the middle class in Africa now exceeds 350 million people. This has meant a parallel increase in the importation of consumer goods and in the implementation of communication and information technologies (ICT), but also in the generation of large quantities of e-waste. However, inadequate infrastructure development remains a major constraint to the continent's economic growth and these highly toxic residues are not always adequately managed. Few studies have been conducted to date assessing the possible association between socioeconomic development factors, including e-waste generation, and blood levels of inorganic elements in African population. To disclose the role of geographical, anthropogenic, and socioeconomic development determinants on the blood levels of Ag, Al, As, Be, Cd, Co, Cr, Hg, Ni, Pb, Sb, and V —all of them frequently found in e-waste—, an immigrant population-based study was made including a total of 245 subjects from 16 countries recently arrived to the Canary Islands (Spain). Women presented higher levels of blood elements than men, and Northern Africans (Moroccans) were the most contaminated. People from low-income countries exhibited significantly lower blood levels of inorganic elements than those from middle-income countries. We found a significant association between the use of motor vehicles and the implementation of information and communication technologies (ICT) and the level of contamination. Immigrants from the countries with a high volume of imports of second-hand electronic equipment, telephone and internet use had higher levels of inorganic elements. In general terms, the higher level of economic development the higher the blood levels of inorganic pollutants, suggesting that the economic development of Africa, in parallel to e-waste generation and the existence of informal recycling sites, have directly affected the level of contamination of the population of the continent.

Although phosphorus (P) is an essential element needed for all lives, excess P can be harmful to the environment. The objective of this study aims to determine P flows in the fisheries sector of Thailand consisting of both sea and freshwater activities of captures and cultures. Currently, the annual fisheries catch averages 3.44 ± 0.50 Mt. Most comes from marine capture 1.95 ± 0.46 Mt, followed by coastal aquaculture 0.78 ± 0.09 Mt, freshwater aquaculture 0.49 ± 0.05 Mt, and inland capture 0.22 ± 0.01 Mt. Of this total, about 11% is contained in fresh products directly sold in local markets for consumption, while 89% is sent to processing factories prior to being sold in local markets and exported. The quantities of P entering the fisheries sector come from captures, import of fisheries products and feed produced from agriculture. This P input to the fisheries sector is found to average 28,506 t P.y−1 based on the past ten-year records. Of this total, P input from captures accounts for 76%; while, 11% represents aquatic feeds from agriculture and animal manures. About 13% is obtained from the imports of fishery products. Coastal and freshwater aquacultures are found to be P consumers because their feeds are almost all produced from agricultural crops grown inland. Moreover, these activities cause most of P losses, approximately 10,188 t P·y−1, which account for 89% of the total P loss from the fisheries sector. Overall, P in the fisheries sector is found to mobilize through three channels: (a) 44% is consumed within the country; (b) about 16% is exported; and, (c) 40% is lost from the ecosystem. Based on the results of this work it is recommended that future research be directed on ways to minimize P loss and maximize P recycle in Thailand's fisheries sector as to enhance its food security and curtail water pollution.

Dechlorane 602 (Dec 602), Dechlorane 603 (Dec 603), Dechlorane 604 (Dec 604), Dechlorane 604 component B (Dec 604 CB) and Dechlorane Plus (DP) were analyzed in soil and fish collected across e-waste recycling sites in Guiyu. The results indicate that soil and fish are contaminated with dechlorane compounds especially Dec 602 and DP which show high concentrations in the samples near recycling sites. Dec 604 and Dec 604 CB are not detected. The photo-degradation experiment indicates that Dec 604 and Dec 604 CB have much faster degradation rates compared to other dechloranes, suggesting they might be more vulnerable to degradation during recycling processes and further studies are needed for assessing the environmental fate and persistence of their degradation products. Dec 602 has not been manufactured in China, the detection of Dec 602 in soil and fish implies that it might be from imports of recyclable materials from developed countries.

The Community Multi-Scale Air Quality (CMAQ) model was applied to evaluate the air quality in the coastal city of Kannur, India, during the 2020 COVID-19 lockdown. From the Pre1 (March 1–24, 2020) period to the Lock (March 25–April 19, 2020) and Tri (April 20–May 9, 2020) periods, the Kerala state government gradually imposed a strict lockdown policy. Both the simulations and observations showed a decline in the PM₂.₅ concentrations and an enhancement in the O₃ concentrations during the Lock and Tri periods compared with that in the Pre1 period. Integrated process rate (IPR) analysis was employed to isolate the contributions of the individual atmospheric processes. The results revealed that the vertical transport from the upper layers dominated the surface O₃ formation, comprising 89.4%, 83.1%, and 88.9% of the O₃ sources during the Pre1, Lock, and Tri periods, respectively. Photochemistry contributed negatively to the O₃ concentrations at the surface layer. Compared with the Pre1 period, the O₃ enhancement during the Lock period was primarily attributable to the lower negative contribution of photochemistry and the lower O₃ removal rate by horizontal transport. During the Tri period, a slower consumption of O₃ by gas-phase chemistry and a stronger vertical import from the upper layers to the surface accounted for the increase in O₃. Emission and aerosol processes constituted the major positive contributions to the net surface PM₂.₅, accounting for a total of 48.7%, 38.4%, and 42.5% of PM₂.₅ sources during the Pre1, Lock, and Tri periods, respectively. The decreases in the PM₂.₅ concentrations during the Lock and Tri periods were primarily explained by the weaker PM₂.₅ production from emission and aerosol processes. The increased vertical transport rate of PM₂.₅ from the surface layer to the upper layers was also a reason for the decrease in the PM₂.₅ during the Lock periods.

The presence of microplastics in the environment is currently receiving a lot of attention. Rubber particles from tire wear have been estimated in several mass emission inventories to be a major contributor to the total microplastic release. This work used dynamic probabilistic material flow analysis to quantify the flows of rubber particles from tires to roads and further onto soils and surface waters of Switzerland. The model considered the whole life-cycle of tires from import over the use phase to the end-of-life and the re-use of scrap tires. Uncertainties of model parameters and data variability were considered by using a probabilistic approach. Mass flows onto soils and through road drainage by both uncontrolled dispersal and engineered systems are considered. In addition, the release of rubber from artificial turfs was included. The accumulation of rubber particles in the environment was quantified over the time frame from 1988 to 2018. The results show that in 2018, 1.29 ± 0.45 kg/capita of rubber was emitted from tire wear (97%) and rubber granules (3%). Street cleaning and waste water treatment removed around 26% of this rubber mass before finally reaching the receiving environmental compartment, resulting in an effective input of 0.96 ± 0.35 kg/capita of rubber in 2018 into the natural environment. Most of this mass (74%) was deposited on roadside soils (up to 5 m distance from road), 22% flowed into surface waters and the remaining part (4%) was emitted to soils. The dynamic modeling showed an increase of the input into the environment by about 10% from 1990 to 2018. The ban of sewage sludge application on soils resulted in a marked decrease in the amount transferred to soils after the year 2000. In total, 219 ± 22 ktonnes of rubber particles have accumulated in the environment since 1988 in Switzerland.

China produces approximately 20%–30% of the total global chlorinated paraffins (CPs). The establishment of a short-chain CP (SCCP) emission inventory is a significant step toward risk assessment and regulation of SCCPs in China and throughout the globe. This study developed a gridded SCCPs emission inventory with a 1/4° longitude by 1/4° latitude resolution from 2008 to 2012 for China, which was based on the total annual CPs emissions for the nation. The total national SCCPs emission during this 5-year period was 5651.5 tons. An additive in metal cutting fluids was a major emission source in China, contributing 2680.2 tons to the total atmospheric emissions of SCCPs from 2008 to 2012, followed by the production of CPs (2281.8 tons), plasticizers (514.3 tons), flame retardants (108.6 tons), and net import (66.6 tons). Most of these emission sources are located along the eastern seaboard of China and southern China. A coupled atmospheric transport model was employed to simulate environmental contamination by SCCPs using the gridded emission inventory of SCCPs from 2008 to 2012 as the model initial conditions. Simulated atmospheric and soil concentrations were compared with field monitoring data to validate the emission inventory. The results showed good consistency between modeled and field sampling data, supporting the reliability and credibility of the gridded SCCPs emission inventory that was developed in the present study.

In several countries, flower import regulations are restricted to food security, by establishing maximum residue limits (MRL) for pesticides in flower-based food products and biosafety, in order to limit the circulation of vectors, pests and exotic species across borders. In this context, the lack of limits on pesticides in flower-products for ornamental purposes can influence the pesticide overuse in production areas, as well as the transfer of contaminated products between countries. Therefore, the purpose of this review was to discuss possible adverse effects on human and environmental health of pesticides used in floriculture, evaluating regulations on the use of these pesticides in the main importing and flower-producing countries. This review included 92 documents. The use of 201 compounds was identified by interviews and analytical measurements. Among them, 93 are banned by the European Union (EU), although 46.3 % of these compounds have been identified in samples from European countries. Latin American countries have a large number of scientific publications on pesticides in flower production (n = 51), while the EU and China have less studies (n = 24) and the United States and Japan have no studies. Regarding adverse health effects, poorer neurobehavioral development, reproductive disorders, congenital malformations and genotoxicity have been reported for residents of flower production areas and workers throughout the flower production cycle. Studies including water samples show overuse of pesticides, while environmental impacts are related to water and air contamination, soil degradation and adverse effects on the reproduction and development of non-target organisms. This review points out that the absence of MRL for non-edible flowers can be crucial for the trade of contaminated products across borders, including pesticides banned in importing countries. Furthermore, setting limits on flowers could reduce the use of pesticides in producing countries.