peer reviewed | Microplastics (MPs) are thought to be ingested by a wide range of marine organisms before being excreted. However, several studies in marine organisms from different taxa have shown that MPs and nanoplastics could be translocated in other organs. In this study, we investigated the presence of MPs in the livers of commercial zooplanktivorous fishes collected in the field. The study focuses mainly on the European anchovy Engraulis encrasicolus but concerns also the European pilchard Sardina pilchardus and the Atlantic herring Clupea harengus. Two complementary methodologies were used to attest the occurrence of MPs in the hepatic tissue and to exclude contamination. 1) MPs were isolated by degradation of the hepatic tissue. 2) Cryosections were made on the livers and observed in polarized light microscopy. Both methods separately revealed that MPs, mainly polyethylene (PE), were translocated into the livers of the three clupeid species. In anchovy, 80 per cent of livers contained relatively large MPs that ranged from 124 μm to 438 μm, showing a high level of contamination. Two translocation pathways are hypothesized: (i) large particles found in the liver resulted from the agglomeration of smaller pieces, and/or (ii) they simply pass through the intestinal barrier. Further studies are however required to understand the exact process. © 2017 Elsevier Ltd

peer reviewed | Monitoring plastic ingestion by marine wildlife is important for both characterizing the extent of plastic pollution in the environment and understanding its effect on species and ecosystems. Current methods to detect plastic in the digestive system of animals are slow and invasive, such that the number of animals that can be screened is limited. In this article, magnetic resonance imaging (MRI) is investigated as a possible technology to perform rapid, non-invasive detection of plastic ingestion. Standard MRI methods were able to directly measure one type of plastic in a fulmar stomach and another type was able to be indirectly detected. In addition to MRI, other standard nuclear magnetic resonance (NMR) measurements were made. Different types of plastic were tested, and distinctive NMR signal characteristics were found in common for each type, allowing them to be distinguished from one another. The NMR results indicate specialized MRI sequences could be used to directly image several types of plastic. Although current commercial MRI technology is not suitable for field use, existing single-sided MRI research systems could be adapted for use outside the laboratory and become an important tool for future monitoring of wild animals.

International audience | Plastics are one of the major forms of anthropogenic pollution. This waste can affect the individual survival in many species, including seabirds. The Southern Ocean ecosystems are thought to be less affected by this pollution, due to the low human presence and the natural protective barrier provided by southern oceanic fronts. Here, we report the first observation of macroplastic ingestion in two dead King penguins (Aptenodytes patagonicus) in the Crozet archipelago located south of these fronts. There is no evidence that the macroplastic fragments found in their stomach were the direct cause of death.We suggest that they were ingested by being confused with stones they used for food grinding.Although it is difficult to assess the local or distant origin of these macroplastics, efforts to collect waste from sites as remote as the subantarctic islands must become standard practice to ensure that such ingestions do not become commonplace.

peer reviewed | The northern fulmar Fulmarus glacialis ingests a larger number of (micro)plastics than many other seabirds due to its feeding habits and gut morphology. Since 2002, they are bioindicators of marine plastics in the North Sea region, and data are needed to extend the programme to other parts of their distribution areas, such as the Arctic. In this study, we provide data on ingested plastics by fulmars collected in 1997 in Kongsfjorden, Svalbard. An extraction protocol with KOH was used and for half of the birds, the gizzard and the proventricular contents were analysed separately. Ninety-one percent of the birds had ingested at least one piece of plastic with an average of 10.3 (±11.9 SD) pieces. The gizzards contained significantly more plastics than the proventriculus. Hard fragments and polyethylene were the most common characteristics. Twelve percent of the birds exceeded the EcoQO value of 0.1 g.

peer reviewed | Microplastic contamination is an emerging issue in the marine environment including the Arctic. However, the occurrence of microplastics in the Arctic fjords remains less understood. Sample collections were conducted by trawling horizontally in surface water (0-0.4-m depth) and trawling vertically in the water column (0-200-m depth) to investigate the abundance, composition, and distribution of microplastics in the Rijpfjorden, Northern Svalbard, in the summer of 2017. Laser Direct Infrared chemical imaging technique was applied for the counting and identification of microplastic particles. A total of 1010 microplastic particles and 14 mesoplastics were identified from 41,038 particles in eight samples from the Rijpfjorden. The abundance of microplastics larger than 300 µm was 0.15 ± 0.19 n/m3 in surface water, and 0.15 ± 0.03 n/m3 in the water column of the Rijpfjorden. The microplastic particles identified in Rijpfjorden water consisted of 10 types of polymers. The dominant microplastics are polyurethane, polyethylene, polyvinyl acetate, polystyrene, polypropylene, and alkyd varnish. Historical ship activities and newly melted sea ice might be major sources of microplastics in the seawater of Rijpfjorden. In general, contamination of microplastics larger than 300 µm in Rijpfjorden water is at a low level in comparison to other polar waters. Further research is needed to confirm the origin and fate of microplastics below 300 µm in Arctic fjords.

Litter is an ecological, economic, and social problem that impacts marine environments around the world. To create prevention and mitigation measures to solve this issue, it is necessary to understand the amounts and sources of this type of pollution. Cassino Beach is an extensive sandy beach located in South Brazil (∼220 km in length) that presents multiple uses, such as touristic, portuary and fishery activities. In order to evaluate the spatial and seasonal variation of litter amounts, types and sources at Cassino Beach, litter (>2.5 cm) was collected over 27 months at two urban and two non-urban sites. At each site, the litter present in three 200 m² areas was sampled and evaluated. A total of 19,457 items were collected, mostly composed by plastic (∼88%). Paper, metal, and cloth items were also present, but in low amounts. Fragments and cigarette butts were the major types of plastic litter, with abundances of 28.4% and 17.0%, respectively. Urban sites presented higher amounts of litter, with those related to beach use being more common, emphasizing the contribution of beachgoers to litter input at these sites. During the summer season, when beach use increases, the highest total litter concentration was found. Undefined and/or beach use-related sources were dominant in all sites and seasons. Mapping the predominant materials, types and potential sources of litter creates important baseline data that can contribute not only to beach monitoring, but also to the development of litter reduction strategies.

Plastic waste are introduced into the environment inevitably and their exposure in the environment causes deterioration in mechanical and physicochemical properties and leads to the formation of plastic fragments, which are considered as microplastics when their size is < 5 mm. In recent years, microplastic pollution has been reported in all kinds of environments worldwide and is considered a potential threat to the health of ecosystems and humans. However, knowledge on the environmental degradation of plastics and the formation of microplastics is still limited. In this review, potential hotspots for the accumulation of plastic waste were identified, major mechanisms and characterization methods of plastic degradation were summarized, and studies on the environmental degradation of plastics were evaluated. Future research works should further identify the key environmental parameters and properties of plastics affecting the degradation in order to predict the fate of plastics in different environments and facilitate the development of technologies for reducing plastic pollution. Formation and degradation of microplastics, including nanoplastics, should receive more research attention to assess their fate and ecological risks in the environment more comprehensively.

The COVID-19 pandemic has resulted in an unprecedented surge of production, consumption, and disposal of personal protective equipment (PPE) including face masks, disposable gloves, and disinfectant wipes, which are often made of single use plastic. Widespread public use of these items has imposed pressure on municipalities to properly collect and dispose of potentially infectious PPE. There has been a lack of structured monitoring efforts to quantify the emerging trend of improperly disposed of PPE debris. In this study, we present a baseline monitoring survey to describe the spatial distribution of PPE debris during the COVID-19 pandemic from the metropolitan city of Toronto, Canada. Our objectives were to: (1) quantify PPE debris types among surveyed areas and; (2) identify PPE debris densities and accumulation of surveyed areas. A total of 1306 PPE debris items were documented, with the majority being disposable gloves (44%), followed by face masks (31%), and disinfecting wipes (25%). Of the face masks, 97% were designed for single use while only 3% were reusable. Of the surveyed locations, the highest daily average densities of PPE debris were recorded in the large and medium-sized grocery store parking lots and the hospital district (0.00475 items/m², 0.00160 items/m², and 0.00133 items/m² respectively). The two surveyed residential areas had the following highest PPE densities (0.00029 items/m² and 0.00027 items/m²), while the recreational trail had the lowest densities (0.00020 items/m²). Assuming a business-as-usual accumulation, an estimated 14,298 PPE items will be leaked as debris in just the surveyed areas annually. To facilitate proper disposal of PPE debris by the public we recommend development of municipal efforts to improve PPE collection methods that are informed by the described PPE waste pathways.

The perdurability of plastics in the environment is one of the major concerns of plastic pollution and, as a consequence, oceans are accumulating large amounts of plastic. The degradation of conventional and biobased materials was evaluated through a laboratory experiment for a year simulating four different conditions in the marine environment. The water column environmental compartment was simulated under euphotic and aphotic (with and without light availability) conditions. The seafloor environmental compartment was simulated with sediment under non-polluted and polluted conditions. By combining weight loss (%), spectroscopic and thermal analyses, the degradation patterns regarding the polymer structure were assessed. The studied biobased materials were polylactic acid (PLA) based materials and showed higher degradability than conventional ones. The weight loss of conventional materials was not influenced by the water column or sediment, while in PLA-based materials, the degradation rates were ca. 5 times greater in the sediment than in the water column. The absorbance (Abs) value at 3400 cm⁻¹ for polyethylene terephthalate (PET), and carbonyl (CO) index for PET and PLA could be useful to detect early signs of degradation. The crystallization index could be a useful parameter to discriminate degradation stages. The obtained results highlight the different degradability rates of materials depending on the specific environmental marine conditions.

Larvae of Zophobas atratus (synonym as Z. morio, or Z. rugipes Kirsch, Coleoptera: Tenebrionidae) are capable of eating foams of expanded polystyrene (EPS) and low-density polyethylene (LDPE), similar to larvae of Tenebrio molitor. We evaluated biodegradation of EPS and LDPE in the larvae from Guangzhou, China (strain G) and Marion, Illinois, U.S. (strain M) at 25 °C. Within 33 days, strain G larvae ingested respective LDPE and PS foams as their sole diet with respective consumption rates of 58.7 ± 1.8 mg and 61.5 ± 1.6 mg 100 larvae⁻¹d⁻¹. Meanwhile, strain M required co-diet (bran or cabbage) with respective consumption rates of 57.1 ± 2.5 mg and 30.3 ± 7.7 mg 100 larvae⁻¹ d⁻¹. Fourier transform infrared spectroscopy, proton nuclear magnetic resonance, and thermal gravimetric analyses indicated oxidation and biodegradation of LDPE and EPS in the two strains. Gel permeation chromatography analysis revealed that strain G performed broad depolymerization of EPS, i.e., both weight-average molecular weight (Mw) and number-average molecular weight (Mₙ) of residual polymers decreased, while strain M performed limited extent depolymerization, i.e., Mw and Mₙ increased. However, both strains performed limited extent depolymerization of LDPE. After feeding antibiotic gentamicin, gut microbes were suppressed, and Mw and Mₙ of residual LDPE and EPS in frass were basically unchanged, implying a dependence on gut microbes for depolymerization/biodegradation. Our discoveries indicate that gut microbe-dependent LDPE and EPS biodegradation is present within Z. atratus in Tenebrionidae, but that the limited extent depolymerization pattern resulted in undigested polymers with high molecular weights in egested frass.