Уточнить поиск
Результаты 1-10 из 53
Potential toxicity of improperly discarded exhausted photovoltaic cells
2016
Motta, C.M. | Cerciello, R. | De Bonis, S. | Mazzella, V. | Cirino, P. | Panzuto, R. | Ciaravolo, M. | Simoniello, P. | Toscanesi, M. | Trifuoggi, M. | Avallone, B.
Low tech photovoltaic panels (PVPs) installed in the early ’80s are now coming to the end of their life cycle and this raises the problem of their proper disposal. As panels contain potentially toxic elements, unconventional, complex and costly procedures are required to avoid environmental health risks and in countries where environmental awareness and economic resources are limited this may be especially problematic. This work was designed to investigate potential risks from improper disposal of these panels. To accomplish this aim an exhausted panel was broken into pieces and these were placed in water for 30 days. The resulting leached solution was analyzed to determine chemical release or used in toto, to determine its potential toxicity in established tests. The end points were seed germination (on Cucumis sativus and Lens culinaris) and effects on early development in three larval models: two crustaceans, Daphnia magna and Artemia salina, and the sea urchin Paracentrotus lividus. Our results show that the panels release small amounts of electrolytes (Na, Ca and Mg) into solution, along with antimony and manganese, with a concentration under the accepted maximum contaminant level, and nickel at a potentially toxic concentration. Developmental defects are seen in the plant and animal test organisms after experimental exposure to the whole solution leached from the broken panel. The toxic effects revealed in in vitro tests are sufficient to attract attention considering that they are exerted on both plants and aquatic animals and that the number of old PVPs in disposal sites will be very high.
Показать больше [+] Меньше [-]Seasonal effects of atmospheric particulate matter on performance of different types of photovoltaic modules in sanliurfa, Turkey
2020
Dogan, Tuba Rastgeldi | Beşli, Nurettin | Aktacir, Mehmet Azmi | Dinç, Merve Nur | İlkhan, Mehmet Akif | Öztürk, Fatma | Yıldız, Melek
In Turkey, Southeastern Anatolia region is the highest in terms of solar radiation level. However, the provinces in the region are subject to Particulate Matter (PM) coming from the Sahara desert, the Syrian Desert and the Arabian Desert by atmospheric transport. The daily limit of PM₁₀ and PM₂.₅ set by WHO for health is often exceeded in Sanliurfa. PM₁₀ and PM₂.₅ pollutants also accumulate on the Photovoltaic (PV) panels and cause loss of PV panel performance. In this study, the effects of atmospheric dust deposition on the performance of PV panel was determined for both monocrystalline and polycrystalline technologies under Sanliurfa atmospheric conditions. Two panels with the same characteristics were used for each PV panel group from 2 different PV technologies. One of the panels in the group was cleaned by washing with distilled water every Monday while the other was not cleaned. Thus, the effect of the dust accumulation on the PV panel was determined by comparison to the cleaned PV panel. PV panel power is measured with I–V meter. Panel surface temperature, solar radiation and other meteorological parameters are measured simultaneously. The measurements were done every Monday, Wednesday and Friday at 12:00 am from May 1 to December 31, 2019. It is observed that the dust accumulation reduces the PV power output up to 8% depending on the amount of radiation. During the summer months, the power loss on the average is 4.33% for monocrystalline and 4.57% for polycrystalline. In the autumn months, it is less than 1.77%.
Показать больше [+] Меньше [-]2E (energy and exergy) analysis of solar evacuated tube-compound parabolic concentrator with different configurations of thermal energy storage system
2022
Christopher, Sathiya Satchi | Kumaresan, Vellaisamy
The intermittent nature of solar radiation requires a thermal energy storage (TES) system for reducing the mismatch between energy demand and supply. Solar water heating (SWH) systems can help save up to 90% of the utilized energy for water heating. In this study, a compound parabolic concentrator (CPC) solar collector has been coupled to three different configurations of TES system. A comprehensive analysis on the effects of PCMs arrangements in TES systems viz three PCMs (case 1) and five PCMs (case 2) on the energy efficiency, exergy efficiency, and overall loss coefficient of the solar collector and TES system has been made and compared with sensible TES system. An experimental data showed an augmented energy storage of 12% and 41% in “case 1” and “case 2” over sensible TES system as a result of reduction in heat losses with the cascaded arrangement of PCMs. The collector paired with case 2 configuration clearly exhibited a higher exergy efficiency due to supply of heat transfer fluid at relatively lower temperature while compared to other TES configurations. The outcomes of this study reveal the key role of cascaded arrangement of PCMs for enhancing energy and exergy efficiencies of solar collector.
Показать больше [+] Меньше [-]Performance analysis of sustainable solar energy operated ejector refrigeration system with the combined effect of Scheffler and parabolic trough collectors to lower greenhouse gases
2022
Nagappan, Beemkumar | Devarajan, Yuvarajan | Kariappan, Elangovan
The work aims to analyse an ejector refrigeration system powered with solar energy through serially connected collectors to lower greenhouse gases. The collectors chosen for the work are Scheffler and parabolic collectors with an area of 2.5 m² and 6 m², respectively. The steam generated by the collectors is stored temporarily in a 15-l storage tank. The thermic fluid transfers heat between the steam storage tank and refrigerant, and thus the generator temperature increases. This design was intended as an alternate for a traditional 3.5 kW room air conditioner with substantially lower energy consumption. This modified system consumed lesser energy input of about 20–30% than conventional air conditioners. Further, for the same specification, the ejector system has consumed less power of about 2.475 kW than the traditional refrigeration system.
Показать больше [+] Меньше [-]Microcontroller PIC 16F877A standard based on solar cooker using PV—evacuated tubes with an extension of heat integrated energy system
2022
Prabu, Arulraj Simon | Chithambaram, Venkatesan | Bennet, Maria Anto | Shanmugan, Sengottaiyan | Pruncu, Catalin Iulian | Lamberti, Luciano | Elsheikh, Ammar Hamed | Panchal, Hitesh | Janarthanan, Balasundaram
The unavailability of sunlight during nighttime and cloudy weather condition has limited the usage of solar cookers throughout the day. This study will attempt to engineer a solar cooker with PV (photovoltaic panel), evacuated tubes with CPC reflectors, battery, and charge controller using the microcontroller PIC 16F877A. A mathematical model is developed to predict the electrical power (Eₚ) required during cloudy weather condition and nighttime as well as the temperatures occurring at different parts of the cooker. The proposed model is validated against experimental observations gathered for one of the typical working days of the system. The cooker is tested for various cooking loads to find the cooking time, and it is proven that the proposed cooker can be utilized over 24/7 without interruption.
Показать больше [+] Меньше [-]Adaptive particle swarm optimization–based deep neural network for productivity enhancement of solar still
2022
Water is considered one of the most superabundant resources on the earth that covers 75% of the entire earth’s surface, yet numerous countries face problem due to water shortage. Desalination is considered the most efficient process to overcome this rising clean water demand. Solar energy is considered one of the efficient and finest resources to refine brackish water. Therefore, this paper proposes a novel black widow particle swarm optimization–based deep neural network approach to enhance the water productivity from a solar still. The main intension of the proposed BWPSO–based DNN approach is to enhance the performances of DNN by employing BWPSO for optimal water production. Here, the optimal weight of the DNN is determined by utilizing the BWPSO algorithm. The solar still is incorporated with a straight tube and spiral tube solar water collector. In addition to this, the study based on solar still and their experimental analysis is carried out in Coimbatore city located in Tamil Nadu. The evaluation is conducted for various parameters, namely glass temperature, average evaporation temperature, inlet and outlet temperature, water temperature, air temperature, yield, solar intensity, wind velocity, RMSE, MAE, MRE, and ECR, to determine the effectiveness of the system. Also, comparative analysis is made and the evaluation results reveal that the proposed approach outperforms various other approaches.
Показать больше [+] Меньше [-]Performance enhancement of solar photovoltaic (PV) module using a novel flat plate (NFP) glass cover by reducing the effect of bird dropping (BD) settlement
2022
Sisodia, Anil Kumar | Mathur, Ramkumar
A massive bird dropping (BD) deposition on the common rectangular flat plate (RFP) of photovoltaic (PV) module is a matter of great concern in Western Rajasthan (WR) that diminish the overall energy production capacity of the system remarkably. In this research article, a prototype novel flat plate (NFP) design of a front glass cover of PV module is proposed to prevent the impact of BD settlement by the restriction of bird’s sitting/movement on the front glass cover. In this regard, the performance analysis of PV module with common RFP and newly designed NFP glass covers has been assessed at the different inclination β° (0–90). The BD accumulation onto the both glass covers was explored by the optical transmittance profiles at the different tilt angles, i.e., explained by bird movement on each flat glass surfaces. Consequently, a significant amount of output electric energy has been gained in NFP design rather than RFP corresponding to particular tilt regions TR I (0° ≤ β ≤ 25°), TR II (25° ≤ β ≤ 60°), and TR III (60° ≤ β ≤ 90°). According to the results achieved, an excellent level of improvement in average power loss, ~ 97.85%, corresponding to optimal TR (III) has been detected by employing NFP glass collector.
Показать больше [+] Меньше [-]The impact of optical liquid filters on PV panel performance
2022
Hamdan, Mohammad | Abdelhafez, Eman
The goal of this research is to investigate the effect of utilizing selective liquids as absorption filters to prevent PV module overheating by blocking the undesirable part of the spectrum (long wavelength) while allowing the beneficial part of the spectrum (visible light and near infrared) to pass through. The fluids were evaluated on two different panels, and their results were compared to those of a control panel. In this work, two liquids were used and tested: copper sulfate solution (CuSO₄·5H₂O) and distilled water as absorption filter; each was arranged in such a way that it flows evenly over the surface of a PV module through a cavity mounted on the top side of the PV module. In addition, a standard PV panel was employed as a comparison. The average power produced by the PV when pure was used as an optical filter is 31.3%, while it was 11.3% when copper sulfate solution was used compared with base unit. Furthermore, the cooling effect of pure water on the PV was more efficient than that of copper sulfate solution, with an average PV temperature drop of 15% compared with 7.5% when copper sulfate is used compared with the base unit panel’s performance improved by an average of 31.3% when distilled water was used as the absorption filter, compared to the reference panel’s performance, while the copper sulfate solution improved the panel’s performance by an average of 11.3% compared to the reference panel’s performance.
Показать больше [+] Меньше [-]The effect of psychrometry on the performance of a solar collector
2022
Dhaundiyal, Alok | Gebremicheal, Gedion H.
The investigation of a solar collector is based on the thermal behaviour of a carrier fluid and the degradation of energy across a flat plate collector. The exergy analysis of a thermal system includes the change in the exergy function of a carrier fluid while transferring solar radiation across an air gap. The cell cast acrylic glass was used to transmit the incident solar radiation to the absorber plate, and to safeguard the absorber plate from the outside environment. With the help of the steady flow energy equation, the enthalpy of the carrier fluid (moist air) was calculated. The specific humidity of the incoming air was calculated at an average dry bulb temperature of 299.4 K. The stagnation temperature at a limiting condition was also estimated to find out the maximum permissible limit for a given thermal design. The mass flow rate of air was assumed to be 5.2 g-s⁻¹. The efficiency of the solar collector was found to vary from 40 to 42%, whereas the thermal energy available for drying was 15–59% of the exergy of the carrier fluid. The net entropy generation rate due to the collector plate was calculated to be 0.12 W-K⁻¹.
Показать больше [+] Меньше [-]Solar ponds—a mini review
2022
Perumal, Prakash | Dharmalingam, Mala
A solar pond is a simple system that collects and stores heat for thermal and electrical applications. Heat storage and heat extraction are the key factors in the solar pond. Salt is added to the pond with fresh water to form a salinity gradient solar pond (SGSP). The solar pond comprises of three zones, namely, the upper convective zone (UCZ), the non-convective zone (NCZ) and the lower convective zone (LCZ). The LCZ is also called the storage zone. Generally, the LCZ stores the heat energy of the incoming solar radiation, and this heat may be used for various applications. In this paper, a review is done on the study of solar ponds with various designs and modifications, heating methods, use of floating devices, use of baffle plates, use of heat exchangers, use of flat plate collectors, use of different types of insulation, etc.
Показать больше [+] Меньше [-]