Seawater, sediments, and three genera of wild scleractinian corals were collected from four coral reef areas nearshore Liuqiu Island, southwestern Taiwan. Abundance, characteristics (sizes, colors, shapes, and polymer types), and enrichment of microplastics (MPs) in the corals, and their impacts on coral cover were determined. The average MPs abundances were 0.95, 0.77, and 0.36 item/g for Galaxea sp, Acropora spp, and Pocillopora sp, respectively. The MPs abundance was relatively higher on the coral surfaces than inside the skeletons, dominated by blue rayon-fibers, correspondingly observed in seawater and sediments. Large-size colorless MPs tended to be mis-ingested by Galaxea sp. (71%) compared with Pocillopora sp. (43%) and Acropora spp. (31%). The low hard coral cover (12.5%) observed at Yufu (L1) on the northeastern coastal zone nearby tourism center of Liuqiu Island where correspondingly associated with high MPs abundance in seawater (10 item/L), sediments (260 item/kg), and corals (0.60 item/g). Tourism induced sewage discharges and sailing activities significantly contributed to the MPs pollution, probably contributing to the loss of coral cover. High MPs enrichment in corals (EFMP = 25–283) shows that the marine MPs pollution can critically threaten coral reef ecosystems. Fibrous MPs present inside the coral skeleton serve as potential indicator of MPs’ impact on corals—with the dominance of textile-related rayon and polyester/PET microfibers in the coral reef zones. This study provided valuable information for coral conservation and coastal management.

Marine litter is widely distributed in marine environments and has been a severe concern worldwide, due to the disposal of waste from diverse sources. The severity of this threat has garnered increasing attention in India over the last decade, but the full consequences of this pollution are yet to be quantified. To estimate the spatiotemporal distribution, composition and beach quality of marine litter pollution, 17 beaches along the Hooghly estuary, a part of the Gangetic delta was studied. Marine litter was collected from 100 m long transects during two seasons (monsoon and post-monsoon). The OSPAR monitoring standard was applied to the 16,597 litter items collected, then grouped under 6 types and 44 categories. In terms of number, litter abundance was higher during monsoon (1.10 ± 0.39 items/m²) than that of post-monsoon (0.86 ± 0.32 items/m²). Most of the beaches were categorized as low cleanliness as computed by the general index and clean coast index and the good for the pellet pollution index. Hazardous litter constituted 6.5% of the total collected litter items. The model prediction revealed that the influence of high discharge from Hooghly, Rasulpur and Subarnarekha River carried enormous anthropogenic litter to the northeast beaches. The litter flux decreases with an increase in distance from the shore, and act as a sink to the sea-floor. The results denote that the distribution and typology of marine litter were representatives of household, tourism and fishing, which in turn highlights the need for better regional litter management measures. Suggested management practices include source reduction, mitigation, management of beach environment and change in littering behaviour through environmental education.

Beaches are key attractions for tourism and recreation, and considerable effort is made to keep beaches clean, yet many beaches still have substantial litter loads. Lasting solutions to reduce the amounts of marine litter require an understanding of litter sources. We collected bottles and other single-use containers at 32 sites around the South African coast to infer their sources based on their age and country of manufacture. Bottle densities varied greatly among beaches (8–450 bottles·km⁻¹), depending on proximity to local urban centres and beach cleaning frequency. Most bottles were plastic, despite well-developed recycling initiatives for PET and HDPE bottles in South Africa. Street litter was dominated by bottles made in South Africa (99%), but foreign-manufactured bottles comprised up to 74% of bottles at some beaches, with an increase from urban (4%) through semi-urban (24%) to remote beaches (45%). Most foreign bottles were PET drink bottles from China and other Asian countries, followed by South America and Europe, with little regional variation in the contribution from these sources. This fact, coupled with their recent manufacture dates (mainly <2 years old), indicates that most foreign PET drink bottles are dumped illegally from ships. By comparison, foreign HDPE bottles were more common along the southeast coast of South Africa than along the west coast, consistent with many of these bottles arriving by long-distance drift across the Indian Ocean from southeast Asia. The most common country of origin for these bottles was Indonesia, and most newly-arrived HDPE bottles were 4–6 years old. To tackle beach litter in South Africa we need to greatly reduce plastic leakage from land-based sources, both locally and in southeast Asia, as well as improve measures to prevent the illegal dumping of plastics and other persistent wastes from ships.

Microplastic (MPs) pollution in the aquatic and terrestrial environments has caught many attentions in the scientific literatures. Currently, no information is available about MPs pollution in Caspian Sea, the largest lake in the world. This study indicates the first report on the MPs pollution in the sediments of the southern Caspian coastal zones, northern Iran. Density separation method was conducted on 17 surficial sediments. The combination of observation techniques including SEM-EDS analysis, polarized light microscopy and Raman micro-spectroscopy were used to identify MPs. The abundance and size of microplastics in the samples ranged between 25 and 330 items/kg and 250–500 μm, respectively. Fibers constituted the most common MPs shape and polystyrene (PS) and polyethylene (PE) were major polymer types in the samples. The distribution of MPs in the study area reflected a patchy and irregular spatial pattern implying that the higher MPs concentration are near mouth of permanent rivers and in the regions with higher level of the fishing and tourism activities. The results showed the wide occurrence of MPs in the sediments of the world’s largest lake which extend the knowledge on MPs pollution in the marine system. We also recommend further research on microplastics in different compartments of Caspian Sea to inform policy discussions and the development of appropriate management responses.

Polycyclic aromatic hydrocarbons (PAHs) and aliphatic hydrocarbons (AHs), including petroleum biomarkers, were studied in four sediment cores collected around Deception and Penguin Islands, Antarctica. Total PAHs in Deception Island (DCP) samples ranged from 2.0 to 26.8 ng g⁻¹, and in Penguin Island (PGI) varied between 13.2 and 60.3 ng g⁻¹. Multiple sources of PAHs were verified in DCP, with petrogenic-derived compounds being predominant over the last 10 years. In PGI, PAHs related to natural contributions from the erosion of coal deposits were reported. Total AHs in DCP ranged from 4.5 to 19 μg g⁻¹ and in PGI varied between 5.3 and 21.9 μg g⁻¹. In DCP, the n-alkanes distribution pattern showed the presence of petroleum residues in the top sections and both terpanes and hopanes were detected, related to the use of fossil fuels for power generation and in different types of vessels. In PGI, the main source of n-alkanes was marine inputs and only terpanes were detected. The slight increase in hydrocarbon levels observed from 1980 onward in DCP was assumed to be due to the development of tourism in the region and to the scientific station activities. In PGI, anthropogenic-related hydrocarbons were detected in the recent sections and were linked to the development of tourism near the island, scientific activities and the increase in vessel traffic. In general, the concentrations of hydrocarbons found around both islands were comparable to those found in uncontaminated Antarctic regions.

The occurrence of microplastics in the beach sand of the Bohai Sea was investigated for the first time. The Bohai Sea is the largest Chinese inner sea and its coastal region is one of the most densely urbanized and industrialized zones of China. Samples from three costal sites (i.e., Bijianshan, Xingcheng and Dongdaihe) were collected, quantified and identified for microplastic analysis. Effects of sample depth and tourism activity were investigated. Surface samples (2 cm) contained higher microplastic concentrations than deep samples (20 cm). Samples from the bathing beach exhibited higher microplastic concentrations than the non-bathing beach, suggesting the direct contribution of microplastics from tourism activity. Of eight types of microplastics that were found, PEVA (polyethylene vinyl acetate), LDPE (light density polyethylene) and PS (polystyrene) were the largest in abundances. Moreover, the non-plastic items from samples were analyzed and results revealed that the majority abundance of the observed non-plastics were viscose cellulose fibers. Further studies are required to evaluate the environmental hazards of microplastics, especially as they may “act as a contaminant transporter” to the Bohai Sea ecosystem.

Intensive land development as a result of the rapidly growing tourism industry in the “Riviera Maya” region of the Yucatan Peninsula, Mexico may result in contamination of groundwater resources that eventually discharge into Caribbean coastal ecosystems. We deployed two types of passive sampling devices into groundwater flowing through cave systems below two communities to evaluate concentrations of contaminants and to indicate the possible sources. Pharmaceuticals and personal care products accumulated in the samplers could only have originated from domestic sewage. PAHs indicated contamination by runoff from highways and other impermeable surfaces and chlorophenoxy herbicides accumulated in samplers deployed near a golf course indicated that pesticide applications to turf are a source of contamination. Prevention and mitigation measures are needed to ensure that expanding development does not impact the marine environment and human health, thus damaging the tourism-based economy of the region.

UV filters (UVFs) and paraben preservatives (PBs) are widely used components in many personal care products. However, there has been a rising concern for their endocrine-disrupting effects on wildlife once they reach aquatic ecosystems via recreative activities and wastewater treatment plants effluents. This study addresses UVFs and PBs occurrence in seawater and sediment impacted by tourism and sewage discharges along the coast of Mahdia, center East Tunisia. Samples of water and sediment were collected for 6 months from 3 coastal areas. Among the 14 investigated UVFs, 8 were detected in seawater and 4 were found in sediment. All PBs were present in seawater and only methylparaben (MePB) was detected in sediment. Benzophenone-3 (oxybenzone, BP3), benzocaine (EtPABA), and MePB were present in all water samples with concentrations in the ranges 16.4–66.9, 7.3–37.7, and 17.6–222 ng/L, respectively. However, the highest value, 1420 ng/L, corresponded to octinoxate (EHMC). In sediments, avobenzone (AVO), 4-methyl benzylidene camphor (4MBC), EHMC, 5-methyl-1-H-benzotriazole (MeBZT), and MePB were detected at concentrations within the range 1.1–17.6 ng/g dw, being MePB the most frequently detected (89%). MePB and MBZT presented the highest sediment-water partition coefficients and MePB also showed a positive correlation with total suspended solids’ water content. Overall, pollutants concentrations remained rather constant along the sampling period, showing little seasonal variation. This study constitutes the first monitoring of UVFs and PBs on the Tunisian coastline and provides occurrence data for reference in further surveys in the country.

This study investigates the incidence of MPs in surface sediment samples, collected from the Anzali Wetland, Gillan province, North of Iran. This natural habitat receives municipal wastewater effluents and hosts industries and recreational activities that could release plastic to the wetland. There is need for studies to understand MPs pollution in wetlands. A total of 40 superficial sediment samples were taken covering potential pollution hotspots in the wetland. The average level of MPs was 362 ± 327.6 MP/kg: the highest MPs levels were near the outlet of a highly urbanized river (Pirbazar River) (1380 MP/kg), which runs through Rasht city. This was followed by 1255 MP/kg where there was intense fishing, boating and tourism activities in the vicinity of Bandar-e Anzali city. Fibers were the most common type of MPs (80% of the total MPs detected). The MPs polluting the wetland were predominantly white/transparent (42%), and about 40% of them were >1000 μm. Polypropylene (PP) and polyethylene (PE) prevailed in MPs found. MPs were characterized with polarized light microscopy, Raman spectroscopy, Scanning Electron Microscopy coupled with Energy-Dispersive X-ray spectroscopy. Microplastics levels were found to correlate significantly (p > 0.7) with electrical conductivity (EC) and sand-size fraction of the sediments. Coarse-grained sediments presented large capacity to lodge the MPs. This study can be used to establish protection policies in wetlands and newly highlights the opportunity of intercepting MPs in the Anzali Wetland, which are generally >250 μm, before they fragment further.

Mangroves play a vital role in protecting the coastal community from the climate change effect and in the restoration of the coastal ecosystem. This research has been designed to determine the spatial and seasonal changes of potentially toxic elements’ (PTEs) concentration in sediments and their potential source contribution among the different human-driven processes in Sundarbans, Bangladesh. Different pollution evaluation indices, random forest (RF) model, conditional inference tree (CIT), self-organizing map (SOM), geographical information system (GIS), and principal component analysis (PCA) were used for the interpretation of sources and risk assessment of PTEs. The mean concentration of PTEs both in winter and monsoon seasons has fallen below the threshold effect level but exceeded the rare effect level of marine sediments quality standards. Results showed that the PTEs were significantly enriched (EF > 1.00 < 70.00) in sediments, whereas the Cd enrichment (7.00% samples) was very alarming (EF = 60–70). Except for Zn and Cd, other PTEs were enriched in 30–60% samples. The highest geoaccumulation and contamination factors for Cd were observed in 46–72% of samples. The ecological risk (ER) factors showed similar results where Cd showed strong to very strong factors (ER = 110–2218) in 80% of samples. The CIT explained the natural/geogenic and anthropogenic sources of pollution, where the higher CIT values for Cd indicated industrial, aquaculture, and coal-based thermal powerplant. The RF model provided that shrimp firms, power plants, industry, and seaport were recognized as the influential sources for Zn, Pb, Cr, Cd, and As in sediments. Though Pb and As were found as the most significant pollutants, Cd was identified as a severe threat to ecology and public health. Based on CIT, RF, SOM and PCA the order of PTEs in mangroves sediment were:industrial/urban > aquaculture/shrimpfirm > powerplant > seaportoperation > tourism > geogenic/natural. The present study will help the policymakers for effective and sustainable management of the mangrove ecosystem.