Mercury concentrations in largemouth bass and mercury accumulation rates in age-dated sediment cores were examined at Lake Ozette and Lake Dickey in Washington State. Goals of the study were to compare concentrations in fish tissues at the two lakes with a larger statewide dataset and examine mercury pathways to the lakes. After accounting for fish length, tissue concentrations at the lakes were significantly higher than other Washington State lakes. Wet deposition and historical atmospheric monitoring from the area show no indication of enhanced local or regional deposition. Sediment core records from the lakes indicate rising sedimentation rates coinciding with logging in the lakes' drainages has greatly increased the net flux of mercury to the waterbodies.

The investigation was carried out on laboratory scale to assess the feasibility of upflow anaerobic sludge blanket reactor system as a pretreatment for hydrogenated vegetable oil industry wastewater with recourse to energy recovery. The reactor system operated at 35°C, resulted in COD removal efficiency in the range 98.9-80.1% at organic loading varying in the range 1.33-10 kgCOD/m³ day. The specific methane yield varied from 0.295-0.345 m³CH₄/kgCODr. Hydraulic retention time, substrate concentrations, pH, and temperature were also varied to study the influence of operating parameters on reactor performance. The methane content decreased with increase in substrate loading rate, and varied from 53-66.7% under varying operating conditions. Impulse loading studies in terms of hydraulic, organic, and pH though resulted in destabilization of the reactor; however, the reactor rapidly achieved stable performance after steady operation.

The influence of inoculum preparation and cell density on the efficiency of Cr(VI) removal was assessed with two chromate-resistant yeasts, Pichia jadinii M9 and Pichia anomala M10, isolated from textile wastewaters. Batch cultures in yeast nitrogen base (YNB)′ liquid medium (YNB without amino acids and ammonium sulfate plus sucrose and ammonium sulfate) containing 1-mM initial Cr(VI) concentrations revealed that heavy metal removal in both isolates was substantially affected by the inoculation procedure. Inocula with high initial density or pregrown in a nutritionally rich medium (Malt Czapek) were found to be key factors in order to achieve successful Cr(VI) decontamination. In contrast, low-density inocula and/or synthetic media-precultured cells were shown to negatively influence Cr(VI) disappearance, either by increasing the time for complete degradation or by reducing the percentage of heavy metal removed. These results emphasized the relevance of the selection of an appropriate inoculum culture medium and the positive influence of increasing one order of magnitude inoculum cell density in order to achieve successful and rapid Cr(VI) removal. Under these considerations, the selected yeasts, P. jadinii M9 and P. anomala M10, exhibited a remarkable ability to tolerate and completely remove Cr(VI) concentrations up to 1 mM, thus being candidates for potential applications in bioremediation of Cr(VI)-contaminated environments.

There is evidence in the literature that the ratio of mass of sorbent (M) to volume of solution (V) affects the results of batch tests with soils and sediments. This restricts the use of such data to conditions with the same M/V ratio they were derived with, unless its influence is corrected. To find a correction, we conducted batch tests with soil and zinc solution using four M/V ratios. For each ratio, the experiments produced a different relationship between the mass of zinc sorbed per unit mass of soil (a s) and the zinc concentration in the solution after shaking and removal of the solid phase (C det), which is usually taken as the equilibrium concentration (C eq). A theoretical analysis revealed that the M/V effect can be accounted for by dividing C det by the M/V ratio, if it is caused by the presence of a “third phase”. The relationship between a s and C det×V/M is the same for all ratios then.

Toxicity of contaminated soils cannot be assessed only by chemical analyses, therefore bioassays are increasingly used. Widely accepted ecotoxicological methods include organisms from all levels of the food-chain but plant-based ones are usually restricted to germination and growth tests. In our study the toxicity of heavy metal contaminated soil samples were examined not only by germination and bacterial tests of their extracts but also by the measurement of physiological parameters of two plant species (cucumber and wheat) that were grown directly on the contaminated substrate. Changes in chlorophyll concentration, stomatal conductance, fluorescence characteristics, and malondialdehyde (MDA) level (showing oxidative damage to lipids in leaves) undoubtedly indicated the mobilisation and toxic effect of contaminants. The results showed that the sensitivity of plant physiological parameters was higher than that of the extract-based ecotoxicological tests. Whereas these latter could not reveal the toxic effect of the highly contaminated soils the plants have reacted in a more complex way and their physiological parameters have changed significantly in all cases validating their use in such studies. The applied measurements also allow quicker and more reliable testing even under field conditions (stomatal conductance) or the detection of a more complex response if detailed analyses is needed (MDA, fluorescence imaging) thus underlining the importance of plant-based methods.

Emergent wetland plant species may exhibit different capacity for phytoremediation when used in constructed wetlands. To evaluate cadmium (Cd) remediation capacity of four emergent wetland species [Baumea juncea (R.Br.) Palla, Baumea articulata (R.Br.) S.T. Blake, Schoenoplectus validus (M.Vahl) A. & D.Löve, and Juncus subsecundus N.A. Wakef.], a glasshouse experiment was conducted in hydroponics to investigate the effects of Cd (0, 5, 10, and 20 mg L⁻¹) on plant growth and Cd uptake and translocation as well as uptake of other nutrients after 14 days. The relative growth rates of the three species changed little in various Cd treatments, but was severely inhibited for B. juncea at 20 mg Cd per liter treatment. Hence, the Cd tolerance index (root length in Cd treatment vs. control) was significantly lower in B. juncea compared to other species. Among the species, the highest concentration of Cd was in the roots of J. subsecundus, followed by S. validus, B. articulata, and B. juncea, while the lowest concentration of Cd was in the S. validus shoots. Of all the species, J. subsecundus had the highest bioconcentration factor (BCF) in shoots, whereas S. validus and B. juncea had the lowest BCF in rhizomes and roots, respectively. The translocation factor was significantly lower in S. validus compared to the other species. J. subsecundus had a higher Cd accumulation rate than the other species regardless of the Cd supply. The lowest allocation of Cd in shoots was recorded for S. validus and in roots for B. juncea. The concentrations of other elements (P, S, Ca, Fe, Cu, and Zn) in shoots decreased with Cd additions, but the interactions between Cd and other elements in roots varied with the different species. These results indicate that the four wetland species have good tolerance to Cd stress (except B. juncea at high Cd exposure), varying in Cd accumulation and translocation in tissues. These properties need to be taken into account when selecting species for wetlands constructed for phytoremediation.

This paper presents the results of physicochemical treatment on Pb-, Cu-, Sb-, and Zn-contaminated Canadian small arm firing range (SAFR) backstop soils in order to evaluate the potential of such methods for remediation of SAFR backstop soils. Remediation target for the treatment assays was to attain the Québec Department of Environment commercial C criterion or more realistically, to reach the soil burial D criterion. Two treatment lines (TL) were evaluated. TL-1, consisting of jig and Wilfley table (WT) treatments on the 0.5-3 mm and 53-500 μm soil size fractions (SF), respectively, and chemical leaching on the <53 μm SF and TL-2, consisting of jig on the 1-4 mm SF, spiral, and WT treatments on 250 μm-1 mm SF, and Kelsey jig assays on the <250 μm SF. For both TL, the untreated SF (>3 mm for TL-1; >4 mm for TL-2), and the gravimetric separation concentrates could be sent for recycling in smelter facilities. Results showed that the finer SF (<53 μm SF for TL-1; <250 μm SF for TL-2) were very difficult to treat. Even with metal removed mass proportions up to 78% for Pb, concentrations were still very high after chemical leaching; and the Kelsey jig showed deceiving metal removed mass proportions (up to 47% for Pb). In both TL, the jig and the WT showed Pb removed mass proportions up to 98% and treated mass proportions up to 77% in their respective SF. Whole process efficiencies in the cleaned soils showed that TL-1 led to the remediation of up to 65% of the initial total soil, and TL-2, 36%. TL-1 and TL-2 results showed that the WT effectively treated soils of 53 μm-1 mm SF, and the jig, soils of the 1-4 mm SF. Our study shows that gravimetric concentration techniques are very promising for the treatment of SAFR backstop soils, and further research has to be done in order to treat the SF lower than 53 μm.

The capacity of microalgae to accumulate heavy metals has been widely investigated for its potential applications in wastewater (bio)treatment. In this study, the ability of Desmodesmus pleiomorphus (strain L), a wild strain isolated from a polluted environment, to remove Cd from aqueous solutions was studied, by exposing its biomass to several Cd concentrations. Removal from solution reached a maximum of 61.2 mg Cd g⁻¹ biomass by 1 day, at the highest initial supernatant concentration used (i.e., 5.0 mg Cd L⁻¹), with most metal being adsorbed onto the cell surface. Metal removal by D. pleiomorphus (strain ACOI 561), a commercially available ecotype, was also assessed for comparative purposes; a removal of 76.4 mg Cd g⁻¹ biomass was attained by 1 day for the same initial metal concentration. Assays for metal removal using thermally inactivated cells were also performed; the maximum removal extent observed was 47.1 mg Cd g⁻¹ biomass, at the initial concentration of 5 mg Cd L⁻¹. In experiments conducted at various pH values, the highest removal was achieved at pH 4.0. Both microalga strains proved their feasibility as biotechnological tools to remove Cd from aqueous solution.

Peroxidase from fenugreek (Trigonella foenum-graecum) seeds was highly effective in the decolorization of textile effluent. Effluent was recalcitrant to the action of fenugreek seeds peroxidase (FSP). However, in order to effectively decolorize effluent by peroxidase, the role of six redox mediators has been investigated. The maximum decolorization of textile effluent was observed in the presence of 1.0 mM 1-hydroxybenzotrizole, 0.7 mM H₂O₂, and 0.4 U ml⁻¹ of FSP in the buffer of pH 5.0 at 40°C in 2.5 h. The decolorization of textile effluent in a batch process by peroxidase was 85% in 5 h, whereas the complete decolorization of textile effluent by membrane-entrapped FSP was observed within 11 h of its operation. The absorption spectra of treated effluent exhibited a marked diminution in the absorbance at different wavelengths compared to untreated effluent.

The objective of this paper is to design a pilot plant electrochemical reactor and to prove the operational concept of the electrochemical production of ferrate in situ and its online application for sewage treatment. To that end, the first part of this paper focuses on the analysis of the main engineering aspects of the reactor and the electrochemical process that affect the ferrate production, using laboratory scale experiments such as the interelectrode gap, the space-time yield, the area/volume (A/V) ratio, the current efficiency, and the energy consumption. The second part focuses on the production of ferrate using a pilot plant scale to prove the operational concept of the electrochemical generation of ferrate in situ and its online application as a step towards its full scale application for water and wastewater treatment.