Detailed information on post-logging sediment dynamics in tropical catchments is required for modelling downstream impacts on communities and ecosystems. Sediment tracing methods, which are potentially useful in extending to the large catchment scale and longer time scales, are tested in primary and selectively logged rainforest catchments of Sabah, Borneo. Selected nutrient (P and N) and trace metal (Ni and Zn) concentrations are shown to discriminate surface, shallow subsurface and deep subsurface sediment sources. Analysis of channel-stored fine-sediment samples and use of an unmixing model allow the relative importance of these vertical sediment sources to be estimated and erosion processes to be inferred for catchments of contrasting size.

Soil erosion and associated off-site environmental impacts have attracted increasing attention in recent decades, and there is a growing need for reliable information on rates of soil loss. The potential for using ¹³⁷Cs fallout to quantify rates and patterns of soil redistribution over medium-term timescales (ca. 45 years) has been successfully demonstrated in a wide range of environments around the world. The similar behaviour of fallout ²¹⁰Pb in soils offers potential for its use as an alternative to ¹³⁷Cs, in areas where ¹³⁷Cs inventories are low or are complicated by additional fallout from the Chernobyl accident. There have, however, to date been few attempts to validate the use of fallout ²¹⁰Pb measurements for assessing erosion rates. This paper reports an attempt to explore the use of fallout ²¹⁰Pb to estimate rates of water-induced soil erosion on uncultivated land. It focuses on three small forest/rangeland catchments located in Calabria, southern Italy, for which measurements of sediment output are available. Comparison of the estimates of net soil loss from the catchments derived from ²¹⁰Pb measurements with the measured sediment output, confirmed the validity of the ²¹⁰Pb approach. The soil redistribution rates estimated using ²¹⁰Pb measurements were also consistent with equivalent estimates obtained for the same study catchments using ¹³⁷Cs measurements.

The feasibility of degrading 16 USEPA priority polycyclic aromatic (PAH) hydrocarbons (PAHs) with heat and Fe(II)-EDTA catalyzed persulfate oxidation was investigated in the laboratory. The experiments were conducted to determine the effects of temperature (i.e. 20 [composite function (small circle)]C, 30 [composite function (small circle)]C and 40 [composite function (small circle)] C) and iron-chelate levels (i.e., 250 mg/L-, 375 mg/L- and 500 mg/L-Fe(II)) on the degradation of dissolved PAHs in aqueous systems, using a series of amber glass jars as the reactors that were placed on a shaker inside an incubator for temperature control. Each experiment was run in duplicate and had two controls (i.e., no persulfate in systems). Samples were collected after a reaction period of 144 hrs and measured for PAHs, pH and sodium persulfate levels. The extent of degradation of PAHs was determined by comparing the data for samples with the controls. The experimental results showed that persulfate oxidation under each of the tested conditions effectively degraded the 16 target PAHs. All of the targeted PAHs were degraded to below the instrument detection limits (~4 μ/L) from a range of initial concentration (i.e., 5 μ/L for benzo(a)pyrene to 57 μ/L for Phenanthrene) within 144 hrs with 5 g/L of sodium persulfate at 20 [composite function (small circle)] C, 30 [composite function (small circle)]C and 40 [composite function (small circle)]C. The data indicated that the persulfate oxidation was effective in degrading the PAHs and that external heat and iron catalysts might not be needed for the degradation of PAHs. The Fe(II)-EDTA catalyzed persulfate also effectively degraded PAHs in the study. In addition, the data on the variation of persulfate concentrations during the experiments indicated that Fe(II)-EDTA accelerated the consumption of persulfate ions. The obtained degradation data cannot be used to evaluate the influence of temperature and Fe(II) levels on the PAH degradation because the PAHs under each of the tested conditions were degraded to below the instrument detection limit within the first sampling point. However, these experiments have demonstrated the feasibility of degrading PAHs in aqueous systems with persulfate oxidation. Additional tests are being conducted to evaluate the effectiveness of treating PAHs in soils and obtaining the rate of degradation of PAHs with persulfate oxidation. Two sets of laboratory experiments were conducted to evaluate the ability of sodium persulfate in oxidizing real world PAH-contaminated soils collected from a Superfund site in Connecticut. The first set of soil sample were treated only with persulfate and to the second batch, mixture of persulfate and Fe(II)-EDTA solutions were added. The results of the second test showed that within 24 hours, 75% to 100% of the initial concentrations of seven PAH compounds detected in the soil samples were degraded by sodium persulfate mixed with FE(II)-EDTA.

While a presumed equality between uncertainty and probability is dominant in subsurface hydrology, in other areas of science and engineering progress in the mathematics of uncertainty is leading the way in providing new types of uncertainty, distinct from probability. In this paper our focus is on one of these, namely fuzzy set theory and fuzzy logic. We start with an overview of fuzzy theory introducing terminology, notation, and concepts relevant to our paper. We continue our discussion with an overview of currently known applications in several areas that include subsurface characterization, groundwater flow and transport modeling, water resources management and optimization, and groundwater health risk assessment and management.

As part of the NJ Toxics Reduction Workplan for NY-NJ Harbor, ambient water samples were collected at fifteen locations along the tidal portions of the Hackensack, Passaic, Raritan, Rahway and Elizabeth Rivers, and in Newark Bay, the Arthur Kill, and Kill van Kull. A Trace Organics Platform Sampler was used to collect a total of 75 suspended sediment phase samples between June 2000 and May 2002. These samples were analyzed for spatial and wet vs. dry weather trends in the 17 polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs; modified USEPA Method 1613b). Mean total PCDD/F (tPCDD/F) concentrations at the sampling locations ranged between 3.8 and 41.5 ng/g. On average, OCDD accounted for almost 80% of the tPCDD/F concentrations; mean total [PCDD/F - OCDD] concentrations ranged between 0.84 and 5.20 ng/g at the sampling locations. Mean 2,3,7,8-TCDD concentrations ranged between 0.003 and 0.28 ng/g, with the highest concentrations (> 0.10 ng/g) along the tidal Passaic and lower Hackensack Rivers, and in upper Newark Bay. Mean tPCDD/F Toxic Equivalency Quotients (TEQ) ranged between 45 and 344 TEQ pg/g, with the highest levels found in the lower Passaic River. Toxicity was primarily driven by 2,3,7,8-TCDD concentrations in the Passaic and Hackensack Rivers, and in Newark Bay. Examples of congener distribution patterns at some of the sampling locations are also presented.

Nutrient spiralling measurements were conducted in Lyrebird Creek, a forested stream in the Dandenong Ranges, Victoria, Australia. Spiralling indices from several nutrient ([graphic removed] , [graphic removed]) enrichment experiments were correlated with seasonal variation in factors thought to control nutrient uptake, i.e., temperature, light and algal biomass. It was hypothesized that nutrient uptake would be higher in summer as increased temperatures would promote both biotic and abiotic processes and higher light levels in summer would stimulate photosynthesis. However, results did not support this hypothesis. Uptake length for [graphic removed] and [graphic removed] and uptake velocity were not correlated with chlorophyll-a, light or temperature (r ² < 0.30, P > 0.1) despite the seasonality of these biophysical factors (r ² > 0.42, P < 0.02). Lyrebird Creek might had no seasonal trend in nutrient uptake and/or nutrient spiraling measurements only appears suitable for contrasting streams with large differences in biophysical factors that supports biotic and abiotic nutrient processing. In addition, small errors in measuring a nutrient concentration can result in a large range in the estimated S w and increased difficulty in determining significant differences in nutrient spiralling indices.

In Hypericumspecies some specimens have been found to display higher levels of the toxic heavy metal Cd than the proposed guide value of 0.5mgkg. Plant and soil samples from various regions in Eastern Austria were collected to study the variability in the Cd content of the herbs and relate it to selected soil properties and soil micronutrient contents. The soils contained between 0.01 and 0.44mgkg-¹Cd in the dry soil. Altogether about 7% of the collected plant samples exceeded 0.5mgkg-¹Cd of dry shoots, the proposed guide value for the drug Herba Hyperici. Plants low in Cd were found on sites in the Alpenvorland, the Hainburger Berge, the Eastern Viennese Basin and the Northern Limestone Alps where the levels did not exceed 0.3mgkg-¹Cd of dry shoots. Higher Cd levels in the plants were present in material from the Waldviertel, the Southern Wienerwald and the Semmering region where often bioaccumulation factors for Cd above 1 could be calculated. In these regions the soil pH and carbonate content was somewhat lower than in other regions whereas the soil organic carbon varied greatly. In the Waldviertel some plants from a field were somewhat higher in Cd than nearby plants from the natural vegetation. In a regression analysis, the soil pH, soil organic carbon and soil Cd content were the main factors influencing Cd accumulation in the plant shoots.

This study was aimed at elucidating the importance of original Pb-speciation versus soil-characteristics to mobility and distribution of Pb in industrially polluted soils. Ten industrially polluted Danish surface soils were characterized and Pb speciation was evaluated through SEM-EDX studies, examination of pH-dependent desorption, distribution in grain-size fractions and sequential extraction. Our results show that the first factors determining the speciation of Pb in soil are: (1) the stability of the original speciation and (2) the contamination level, while soil characteristics are of secondary importance. In nine of ten soils Pb was concentrated strongly in the soil fines (< 0.063 mm). In all soils, particles with a highly concentrated Pb-content were observed during SEM-EDX. In eight of the soils, the particles contained various Pb-species with aluminum/iron, phosphate, sulfate and various metals (in solder and other alloys) as important associates. In the one soil, where Pb was not concentrated in the soil fines, Pb was precipitated solely as PbCrO₄, while pure (metallic) Pb was repeatedly observed in the last soil. Pb was bound strongly to the soils with > 50% extracted in step III (oxidizing) and IV (residual) of sequential extraction for all soils but one. A significant amount of exchangeable Pb existed only in severely contaminated soils, where the bonding capacity of organic matter and oxides was exceeded. Among soil constituents, Pb was observed to adsorb preferentially to feldspars and organic matter while presence of phosphate increased the strength of the Pb-bonding in phosphate-rich soils.

Although lead (Pb) emissions have dropped drastically with the phase-out of tetra-ethyl lead (TEL) as a fuel additive, Pb deposited along highway corridors continues to be of concern because of its toxicity. This paper provides comprehensive data on the extent and distribution of Pb in roadside soils, Pb interaction with soils as a function of soil composition, the retention capacity of soil based on batch adsorption tests, the retention mechanism of Pb using selective sequential extraction, the potential for mobility using batch desorption tests with simulated rain and winter road salt, and column leach tests. Highway soils on high-traffic sections near Burnaby, Canada were found to have Pb accumulations up to 1628mg/kg soil. Contamination was mainly in the top 0.3m, with concentrations rapidly decreasing to the background level at a depth of 0.6m. The top layer contained more organic material and had a high adsorption capacity. Highway soils were found to have 3-10 times higher Pb adsorption capacities than the amount currently deposited. Selective sequential extraction indicated low exchangeable Pb in highway soils. Batch desorption tests with leaching solutions of H₂O (pH 5.5), HNO₃ solution (pH 4.0) and aqueous NaCl solution (0.17M) indicate low likelihood of significant leaching. Selective sequential extraction, leachate extraction and desorption tests show that Pb has limited mobility in highway soil.

This study has been conducted at the University of Connecticut (UCONN) in connection with the USEPA Superfund Innovative Technology Evaluation (SITE) program to evaluate a chemical oxidation technology (sodium persulfate) developed at UCONN. A protocol to assess the efficacy of oxidation technologies has been used. This protocol, which consists of obtaining data from a treatability study, tested two in-situ chemical oxidation technologies that can be used on soil and groundwater at a site in Vernon, Connecticut. Based on the treatability report results and additional field data collected at the site, the design for the field implementation of the chemical oxidation remediation was completed. The results indicate that both sodium persulfate and potassium permanganate were able to effectively degrade the target VOCs (i.e., PCE, TCE and cis-DCE) in groundwater and soil-groundwater matrices. In the sodium persulfate tests (120 hrs), the extent of destruction of target VOCs was 74% for PCE, 86% for TCE and 84% for cis-DCE by Na₂S₂O₈ alone and 68% for PCE, 76% for TCE, and 69% for cis-DCE by Fe(II)-catalyzed Na₂S₂O₈. The results demonstrate the sodium persulfate's ability to degrade PCE, TCE and cis-DCE. It is expected that given sufficient dose and treatment time, a higher destruction rate of the dissolved phase contamination can be achieved. The data also indicates that the catalytic effect of the iron chelate on persulfate chemistry was much less pronounced in the soil-groundwater matrix. This indicates an interaction between the iron chelate solution and the soil, which may have resulted in a lower availability of the chelated iron for catalysis. The study showed that the remediation of the VOCs-contaminated soil and groundwater by in-situ chemical oxidation using sodium persulfate is feasible at the Roosevelt Mills site. As a result, the USEPA SITE program will evaluate this technology at this site.