The current study both synthesizes and uses four compounds of graphene oxide (GO), nitrogen doped graphene oxide (ND-GO), high nitrogen doped graphene oxide (HND-GO), and three dimensional high nitrogen doped graphene oxide (3D-HND-GO) in order to remove a model anionic dye, Congo red (CR) from wastewaters. It also compares their carbon nano-structure, with regard to removal efficiency and finds out that 3D-HND-G yields higher efficiency in removal of CR, especially at lower pHs. This is due to its better dispersibility and greater surface area. Also, batch adsorption technique has been utilized and all involved parameters that affect the removal efficiency, e.g. initial pH, adsorbent dosage, initial CR concentration, and contact time are examined. The study applies Central Composite Design (CCD) to figure out their efficacies, with the results showing the following optimum conditions for removal of 100 ppm of CR: 4 mg/mL of the adsorbent, pH = 3, and 25 min of contact time. Furthermore, it studies the adsorption activity of the synthesized adsorbent, including kinetics, isotherm, and desorption comprehensibly. The adsorption isotherm is well-fitted through the Langmuir model, exhibiting high CR adsorption capacity. Also, CR adsorption kinetics shows that it has obeyed a pseudo-second-order kinetic model, indicating that adsorption has made the rate-limiting step. In addition, the proposed adsorbent has successfully been applied to reduce the concentration of CR as hazardous dye materials in the water and wastewater samples.

The need for oil and natural gas as a major source of energy is vital. On the one hand, it has affected the political and economic equations at the international, regional and national level. On the other hand, it has had negative effects on sociocultural, legal, and environmental aspects as well as on the physical and mental health of human beings. Therefore, the need to provide an environmental policy that addresses the various dimensions of the oil and gas industry will be necessary. The present paper aims to set up a conceptual model of environmental policy for sustainable development in the oil and gas industries of the Kurdistan Region through the use of these 6 components: political, economic, sociocultural, technological, legal and environmental. It will also be using the techniques of PESTLE, SWOT, SPACE, FANP, FDEMATEL, and simulation with the VENSIM software. The results show the weights of the criteria respectively are Political; 1.59, Economic; 0.78, Sociocultural; 0.00, Legal; -0.99, Technological; -0.61 and Environmental; -0.70. So that all components are important, but that political and economic factors have a significant influence on environmental policies and oil and gas industries. Sociocultural components have a neutral role and the technological, legal and environmental components are impressible. Finally, fifteen strategies for the formulation of an effective environmental policy in the oil and gas industry were presented.

Ahvaz can be regarded as one of the most polluted cities in the world in terms of air pollution. Successive years of drought and weather conditions in recent years have resulted in particulate matter (PM10) concentration in Ahvaz. In this study, using probability distribution techniques, an appropriate threshold to identify the PM10 maximum extreme concentrations (MEC) has been detected. Based on log-logistics probability distribution, which has the best fit to the data of PM10 concentration in Ahvaz, the 0.99 percentile threshold which is specified by 1516 μg/m³ is known as the primary PM10 concentrations in Ahvaz air. Based on the mentioned threshold, 24 days in which the PM10 concentration was equal to or more than the threshold were selected for synoptic analysis. Analysis of the circulation of weather types showed that two weather types circulations at 500 hPa level provide the climatic conditions for the occurrence of (MEC) caused by PM10 concentration ≥1516 μg/m³ in Ahvaz in the first type (which is for hot days). Under such condition, the closed high pattern of 500 hPa level is accompanied by the ground low pressures. In the second type (which is for cold and transitional days) the closed high pattern of 500 hPa level is accompanied by the ground high pressures. In addition, this study showed that the (MEC) of PM10 in both models fed with several different sources at different levels and due to being multi-source, storms can create MEC.

Natural coagulants have received much attention for turbidity removal, thanks to their environmental friendliness. The present study investigates potential application of rice starch for removal of turbidity from aqueous solutions. It considers the effects of four main factors, namely settling time (40-140 min), pH (2-8), slow stirring speed (20-60 rpm), and rice starch dosage (0-200 mg/L), each at five levels, by means of central composite design. Results show that a quadratic model can adequately describe turbidity removal in case of non-autoclaved rice starch with statistics of R2= 0.95, R2adj.= 0.91, R2pred.= 0.77, AP = 23.75, and CV = 4.77. It has also been found that the performance of non-autoclaved rice starch is superior to the autoclaved variety, in terms of removal efficiency and floc size. In the optimal point, predicted by the model, a removal efficiency equal to 98.4% can be attained, using non-autoclaved rice starch, which is higher than that of the autoclaved rice starch (71.29%). The significant effective parameters have proven to be settling time along with pH. Overall, rice starch can be considered a promising high potential coagulant for removal of turbidity from water or wastewater.

Environmental assessments are essential in order to align the process of country's progress towards sustainable development. It is important for the project to be implemented in direction of sustainable development, which is to carry out a project in such a way that in both short and long term, the greatest advantages and the least harm are inflicted on the environment, economy, communities, and culture. Environmental assessment of gas pipelines is classified as a linear projects; therefore, the design and implementation of an appropriate method in accordance with the project's linearity, due to the use of GIS tools and multi-criteria decision-making methods, can be a good innovation for this study, in comparison to previous similar projects. The purpose of this study is to identify the best option for gas pipelines. Once the project's study scope is specified, the study based the sensitive environmental parameters of the area (based on the requirements of environmental impact assessment reports) on two methods of Analyzing Hierarchical Process (AHP) and overlaying methods for sub-parameters, ranking and prioritizing the area of evaluation. Based on the results, the first and second priorities belong to the parameter of distance and position in the protected areas with a weight of 29.9% and hydrology with a weight of 24.7%, followed by slope, vegetation, land use, and fault, which are ranked third to seventh, respectively. After identifying the best map option, the study extracts the critical points for the construction of pipelines, identifies the negative effects of the project, and presents the environmental impacts and preventive measures, reduction and compensation of negative effects in both construction and operation phases, along with a summary of the Environmental Management Program (EMP).

The transport mechanism of contaminated groundwater has been a problematic issue for many decades, mainly due to the bad impact of the contaminants on the quality of the groundwater system. In this paper, the exact solution of two-dimensional advection-dispersion equation (ADE) is derived for a semi-infinite porous media with spatially dependent initial and uniform/flux boundary conditions. The flow velocity is considered temporally dependent in homogeneous media however, both spatially and temporally dependent is considered in heterogeneous porous media. First-order degradation term is taken into account to obtain a solution using Laplace Transformation Technique (LTT) for both the medium. The solute concentration distribution and breakthrough are depicted graphically. The effect of different transport parameters is studied through proposed analytical investigation. Advection-dispersion theory of contaminant mass transport in porous media is employed. Numerical solution is also obtained using Crank Nicholson method and compared with analytical result. Furthermore, accuracy of the result is discussed with root mean square error (RMSE) for both the medium. This study has developed a transport and prediction 2-D model that allows the early remediation and removal of possible pollutant in both the porous structures. The result may also be used as a preliminary predictive tool for groundwater resource and management.

The present study aims at developing a forecasting model to predict the next year’s air pollution concentrations in the atmosphere of Iran. In this regard, it proposes the use of ARIMA, SVR, and TSVR, as well as hybrid ARIMA-SVR and ARIMA-TSVR models, which combined the autoregressive part of the autoregressive integrated moving average (ARIMA) model with the support vector regression technique (ARIMA-SVR). The main concept of generating a hybrid model is to combine different forecasting techniques so as to reduce the time-series forecasting errors. The data used in this study are annual CO2, CO, NOx, SO2, SO3, and SPM concentrations in Iran. According to the results, the ARIMA-TSVR Model is preferable over the other models, having the lowest error value among them which account for 0.0000076, 0.0000065, and 0.0001 for CO2; 0.0000043, 0.0000012, and 0.000022 for NOx; 0.00032, 0.00028., and 0.0012 for SO2; 0.000021, 0.000014, and 0.00038 for CO; 0.0000088, 0.0000005, and 0.00019 for SPM; and 0.000021, 0.000019, and 0.0044 for SO3. Furthermore, the accuracy of all models are checked in case of all pollutants, through RMSE, MAE, and MAPE value, with the results showing that the hybrid ARIMA-TSVR model has also been the best. Generally, results confirm that ARIMA-TSVR can be used satisfactorily to forecast air pollution concentration. Hence, the ARIMA-TSVR model could be employed as a new reliable and accurate data intelligent approach for the next 35 years’ forecasting.

The ever increasing pile-up of electronic waste in dumping sites, especially in developing countries such as China, Pakistan, India and several African countries, might have caused a significant alteration in the microbial community of the contaminated sites. This change in the microbial population may have significant impact to the soil ecology function. The major pollutants of electronic waste are heavy metals like cadmium, lead, nickel, mercury, hexavalent chromium, arsenic and persistent organic pollutants like polychlorinated biphenyls and polybrominated diphenyl ethers. In general, the toxic pollutants reduce the normal soil microbial biota but give rise to increase in the heavy metal resistant and organic pollutants remediating microbes. With the development of culture- independent approach as a tool for studying microbial diversity, the microbial community structures in toxic waste contaminated sites have been revealed gradually. Studies on the microbial community structure of electronic waste contaminated sites show that there are significant differences between the contaminated and the non-contaminated sites. Soil pH in the e-waste contaminated sites of various regions has been reported in a wide range varying from pH 4 to pH 12. However, the predominant phyla so far identified in the electronic waste contaminated sites, based on studies through culture independent approach, are Firmicutes, Proteobacteria, Actinobacteria, Acidobacteria, Chloroflexi, Crenarchaeota and Bacteroidetes accounting for more than 80% of the total sequence reads on an average. The genera like Pseudomonas, Bacillus, Clostridium, Rhodococcus, Achromobacter and many unclassified bacteria are the common types in the contaminated sites.

The city of Tehran undergoes an increasing growth in population as well as industrial activities, both of which increase the concentration of air pollutants. The current research tries to turn a limited and focused system of air contamination measurement and control to an unlimited and extensive one that examines the concentration of each of the contaminants in any area of Tehran. Accordingly, information from twenty air-pollution measurement stations at certain points of the city helps measuring the concentrations of contaminants like SO2, NO2, CO, O3, PM2.5, and PM10 throughout a year on a daily basis. The index of AQI has also been used as the air quality index to determine the level of pollution in the city. Using ARC-GIS software, the AQI or the air quality index has been zoned and a comprehensive map, designed. Moreover, in order to illustrate this map, a map of the zoning has been drawn up for this purpose on December, 26, 2016, considered an unhealthy day in Tehran, the results of which show that only 27.8% of the city is unhealthy and the rest of the city does not fall in unhealthy area. However, due to the lack of a comprehensive map for determining the AQI in different parts of the city, the whole city closes down, leading in an economic loss of about $ 1 million a day for the city.

In this study, the lethal toxicity, behavioral responses and hematotoxicity of formulated chlorpyrifos on Clarias gariepinus was evaluated. C. gariepinus fingerlings were exposed to 0.2 mg/L, 0.25 mg/L, 0.3 mg/L, 0.35 mg/L and 0.4 mg/L of the active ingredient chlorpyrifos to determine the lethal concentrations and behavioral effects. C. gariepinus juveniles (38.84±7.67g) were then exposed to 0.0256 mg/L and 0.0128 mg/L for 14 days to study somatic indices and haematological effects. The 24h, 48h, 72h and 96h LC50 were estimated as 0.292 (0.210 – 0.376) mg/L, 0.275 (0.252 – 0.297) mg/L, 0.263 (0.242 – 0.282) mg/L, and 0.256 (0.235 – 0.275) mg/L respectively. Hyper activity, loss of equilibrium, erratic swimming, trembling, respiratory distress and poor startle response were observed in fingerlings in response to acute toxic stress of chlorpyrifos. Liver somatic index (LSI) of exposed juveniles increased significantly (p<0.05) compared with control, while there was no statistically significant difference in all the haematological parameters of the exposed fishes compared with the control (p<0.05). The results indicate that the chlorpyrifos formulation was highly toxic and induced behavioral changes in C gariepinus fingerlings, while sub-lethal concentrations induced inflammation in the liver but had no effect on haematological parameters of Clarias gariepinus juveniles. LSI was sensitive to the sub-lethal concentrations and could serve as indicators or exposure to organophosphate insecticides.