The main goal of the present study was to determine and validate an aquatic Maximum Acceptable Concentration-Environmental Quality Standard (MAC-EQS) value for the agricultural fungicide azoxystrobin (AZX). Assessment factors were applied to short-term toxicity data using the lowest EC50 and after the Species Sensitivity Distribution (SSD) method. Both ways of EQS generation were applied to a freshwater toxicity dataset for AZX based on available data, and to marine toxicity datasets for AZX and Ortiva® (a commercial formulation of AZX) obtained by the present study. A high interspecific variability in AZX sensitivity was observed in all datasets, being the copepoda Eudiaptomus graciloides (LC50,48h = 38 μg L⁻¹) and the gastropod Gibbula umbilicalis (LC50,96h = 13 μg L⁻¹) the most sensitive freshwater and marine species, respectively. MAC-EQS values derived using the lowest EC50 (≤0.38 μg L⁻¹) were more protective than those derived using the SSD method (≤3.2 μg L⁻¹). After comparing the MAC-EQS values estimated in the present study to the smallest AA-EQS available, which protect against the occurrence of prolonged exposure of AZX, the MAC-EQS values derived using the lowest EC50 were considered overprotective and a MAC-EQS of 1.8 μg L⁻¹ was validated and recommended for AZX for the water column. This value was derived from marine toxicity data, which highlights the importance of testing marine organisms. Moreover, Ortiva affects the most sensitive marine species to a greater extent than AZX, and marine species are more sensitive than freshwater species to AZX. A risk characterization ratio higher than one allowed to conclude that AZX might pose a high risk to the aquatic environment. Also, in a wider conclusion, before new pesticides are approved, we suggest to improve the Tier 1 prospective Ecological Risk Assessment by increasing the number of short-term data, and apply the SSD approach, in order to ensure the safety of aquatic organisms.

In response to the restrictions of polybrominated diphenyl ether (PBDE) flame retardants in various consumer products, alternative halogenated flame retardants have been subjected to increased use. Compared to aquatic ecosystems, relatively little information is available on the contamination of alternative flame retardants in terrestrial ecosystems, especially with regards to mammalian wildlife. In this study we used a top terrestrial carnivore, the bobcat (Lynx rufus), as a unique biomonitoring species for assessing flame retardant contamination in the Midwestern United States (U.S.) terrestrial ecosystems. Concentrations of ∑PBDEs (including all detectable PBDE congeners) ranged from 8.3 to 1920 ng/g lipid weight (median: 50.3 ng/g lw) in livers from 44 bobcats collected during 2013–2014 in Illinois. Among a variety of alternative flame retardants screened, Dechloranes (including anti- and syn-Dechlorane Plus and Dechlorane-602, 603, and 604), tetrabromo-o-chlorotoluene (TBCT), and hexabromocyclododecane (HBCD) were also frequently detected, with median concentrations of 28.7, 5.2, and 11.8 ng/g lw, respectively. Dechlorane analogue compositions in bobcats were different from what has been reported in other studies, suggesting species- or analogue-dependent bioaccumulation, biomagnification, or metabolism of Dechlorane chemicals in different food webs. Our findings, along with previously reported food web models, suggest Dechloranes may possess substantial bioaccumulation and biomagnification potencies in terrestrial mammalian food webs. Thus, attention should be given to these highly bioavailable flame retardants in future environmental biomonitoring and risk assessments in a post-PBDE era.

Quietness exists in places without human induced noise sources and could offer multiple benefits to citizens. Unlit areas are sites free of human intense interference at night time. The aim of this research is to develop an integrated environmental index of noise and light pollution. In order to achieve this goal the spatial pattern of quietness and darkness of Europe was identified, as well as their overlap. The environmental index revealed that the spatial patterns of Quiet and Unlit Areas differ to a great extent highlighting the importance of preserving quietness as well as darkness in EU. The spatial overlap of these two environmental characteristics covers 32.06% of EU surface area, which could be considered a feasible threshold for protection. This diurnal and nocturnal metric of environmental quality accompanied with all direct and indirect benefits to human well-being could indicate a target for environmental protection in the EU policy and practices.

The ability to characterize the composition of emerging unconventional Bakken tight oil is essential to better prepare for potential spills and to assess associated environmental concerns. The present work measured and compared the physical and chemical properties of Bakken crudes with conventional crude oils from various regions and different types of refined petroleum products. The physicochemical properties of Bakken crude are overall similar to those of conventional light crudes. The Bakken crude consists of high concentrations of monoaromatic hydrocarbons and alkylated PAHs with a clear dominance of the alkylated naphthalene homologues followed by the phenanthrene series. Its pyrogenic index (PI) values are considerably lower than typical conventional crude oils. The Bakken crude oils in this study exhibit a low abundance of petroleum biomarker such as terpanes, steranes and diamondoids and bicyclic sesquiterpanes. Since tight oil from the Bakken region is produced from low-permeability formations, variations in abundance and diagnostic ratios of common target petroleum hydrocarbons were found among these oils.

The disposal of biosolids poses a major environmental and economic problem. Agricultural use is generally regarded as the best means of disposal. However, its impact on soil ecosystems remains uncertain. Biosolids can improve soil properties by supplying nutrients and increasing organic matter content but there is also a potentially detrimental effect arising from the introduction of heavy metals into soils. To assess the balance between these competing effects on soil health, we investigated soil bacterial and fungal diversity and community structure at a site that has been dedicated to the disposal of sewage sludge for over 100 years. Terminal restriction fragment length polymorphism (T-RFLP) was used to characterize the soil microbial communities. The most important contaminants at the site were Ni, Cu, Zn, Cd, and Pb. Concentrations were highly correlated and Zn concentration was adopted as a good indicator of the overall (historical) biosolids loading. A biosolids loading, equivalent to 700–1000 mg kg⁻¹ Zn appeared to be optimal for maximum bacterial and fungal diversity. This markedly exceeds the maximum soil Zn concentration of 300 mg kg⁻¹permitted under the current UK Sludge (use in agriculture) Regulations. Redundancy analysis (RDA) suggested that the soil microbial communities had been altered in response to the accumulation of trace metals, especially Zn, Cd, and Cu. We believe this is the first time the trade-off between positive and negative effects of long term (>100 years) biosolids disposal on soil microorganisms have been observed in the field situation.

The spatiotemporal variability of ambient volatile organic compounds (VOCs) in Tehran, Iran, is not well understood. Here we present the design, methods, and results of the Tehran Study of Exposure Prediction for Environmental Health Research (Tehran SEPEHR) on ambient concentrations of benzene, toluene, ethylbenzene, p-xylene, m-xylene, and o-xylene (BTEX). To date, this is the largest study of its kind in a low- and middle-income country and one of the largest globally. We measured BTEX concentrations at five reference sites and 174 distributed sites identified by a cluster analysis method. Samples were taken over 25 2-weeks at five reference sites (to be used for temporal adjustments) and over three 2-week campaigns in summer, winter, and spring at 174 distributed sites. The annual median (25th–75th percentile) for benzene, the most carcinogenic of the BTEX species, was 7.8 (6.3–9.9) μg/m3, and was higher than the national and European Union air quality standard of 5 μg/m3 at approximately 90% of the measured sites. The estimated annual mean concentrations of BTEX were spatially highly correlated for all pollutants (Spearman rank coefficient 0.81–0.98). In general, concentrations and spatial variability were highest during the summer months, most likely due to fuel evaporation in hot weather. The annual median of benzene and total BTEX across the 35 sites in the Tehran regulatory monitoring network (7.7 and 56.8 μg/m3, respectively) did a reasonable job of approximating the 144 city-wide sites (7.9 and 58.7 μg/m3, respectively). The annual median concentrations of benzene and total BTEX within 300 m of gas stations were 9.1 and 67.3 μg/m3, respectively, and were higher than sites outside this buffer. We further found that airport did not affect annual BTEX concentrations of sites within 1 km. Overall, the observed ambient concentrations of toxic VOCs are a public health concern in Tehran.

In this research, adsorption of Cu(II) and Cd(II) by biochars was investigated. To enhance the adsorption of these two metal ions, a simple modification of biochars by phosphoric acid (H(3)PO(4)) was carried out. The surface area was larger and the contents of oxygen-containing functional groups of modified biochars were more than pristine biochars. In comparison with pristine biochar, modified biochars sorbed Cu(II) and Cd(II) much more strongly. Surface area had significant effects on the sorption of Cu(II) and Cd(II) by modified biochars. X-ray photoelectron spectroscopy analyses indicated that the quantities of carboxyl (-COOH) and hydroxyl (-OH) functional groups of modified biochars were larger than those of pristine biochar at the same pyrolysis temperature. Compared with that of pristine biochars, the strong ability of -COOH and -OH of modified biochars to form complexes with Cu(II)/Cd(II) ions resulted in higher adsorption of these two metal ions. The phosphorus-containing groups of modified biochars, such as P=O and P=OOH from the result of Fourier transform infrared spectroscopy, interacted and also formed complexes with metal ions, possibly resulting in the enhanced adsorption of Cu(II) and Cd(II). Thus, sorption of metal ions by modified biochars was controlled by the mechanism of surface complexation between oxygen containing functional groups and metals. In general, the H(3)PO(4) modification was an effective method that prepared biochars with a high affinity for the sorption of heavy metals.

Chlorinated and brominated polycyclic aromatic hydrocarbons (Cl/Br-PAHs) are emerging semi-volatile organic pollutants in haze-associated particulate matter (PM). Their gas–particle phase partitioning and distribution among PM fractions have not been clarified. Clarification would increase understanding of atmospheric behavior and health risks of Cl/Br-PAHs. In this study, samples of the gas phase and 4 PM phases (aerodynamic diameters (dae) > 10 μm, 2.5–10 μm, 1.0–2.5 μm, and <1.0 μm) were collected simultaneously during haze events in Beijing and analyzed. Normalized histogram distribution indicated that the Cl/Br-PAHs tended to adhere to fine particles. Over 80% of the Cl-PAHs and 70% of the Br-PAHs were associated with fine PM (dae < 2.5 μm). The gas–particle phase partitioning and PM distribution of Cl/Br-PAHs when heating of buildings was required, which was associated with haze events, were obviously different from those when heating was not required. The relationship between the logarithmic geometric mean diameters of the Cl/Br-PAH congeners and reciprocal of the temperature (1/T) suggested that low air temperatures during the heating period could lead to high proportions of Cl/Br-PAHs in the fine particles. Increased coal burning during the heating period also contributed to high Cl/Br-PAH loads in the fine particles.

Di-(2-ethylhexyl)-phthalate (DEHP) is causing serious health hazard in wildlife animal and human through environment and food chain, including the effect of brain development and impacted neurobehavioral outcomes. However, DEHP exposure caused cerebellar toxicity in bird remains unclear. To evaluate DEHP-exerted potential neurotoxicity in cerebellum, male quails were exposed with 0, 250, 500 and 750 mg/kg BW/day DEHP by gavage treatment for 45 days. Neurobehavioral abnormality and cerebellar histopathological alternation were observed in DEHP-induced quails. DEHP exposure increased the contents of total Cytochrome P450s (CYPs) and Cytochrome b5 (Cyt b5) and the activities of NADPH-cytochrome c reductase (NCR) and aniline-4-hydeoxylase (AH) in quail cerebellum. The expression of nuclear xenobiotic receptors (NXRs) and the transcriptions of CYP enzyme isoforms were also influenced in cerebellum by DEHP exposure. These results suggested that DEHP exposure caused the toxic effects of quail cerebellum. DEHP exposure disrupted the cerebellar CYP enzyme system homeostasis via affecting the transcription of CYP enzyme isoforms. The cerebellar P450arom and CYP3A4 might be biomarkers in evaluating the neurotoxicity of DEHP in bird. Finally, this study provided new evidence that DEHP-induced toxic effect of quail cerebellum was associated with activating the NXRs responses and disrupting the CYP enzyme system homeostasis.

Thallium (Tl) is a highly toxic rare element. Severe Tl poisoning can cause neurological brain damage or even death. The present study was designed to investigate contents of Tl and other associated heavy metals in arable soils and twelve common vegetables cultivated around a steel plant in South China, a newly-found initiator of Tl pollution. Potential health risks of these metals to exposed population via consumption of vegetables were examined by calculating hazard quotients (HQ). The soils showed a significant contamination with Tl at a mean concentration of 1.34 mg/kg. The Tl levels in most vegetables (such as leaf lettuce, chard and pak choy) surpassed the maximum permissible level (0.5 mg/kg) according to the environmental quality standards for food in Germany. Vegetables like leaf lettuce, chard, pak choy, romaine lettuce and Indian beans all exhibited bioconcentration factors (BCF) and transfer factors (TF) for Tl higher than 1, indicating a hyperaccumulation of Tl in these plants. Although the elevated Tl levels in the vegetables at present will not immediately pose significant non-carcinogenic health risks to residents, it highlights the necessity of a permanent monitoring of Tl contamination in the steel-making areas.