Oil-flax has a wide range of utilization possibilities, inclusive of bioenergy production. In our research evaluated out two oil-flax varieties 'Scorpion' and 'Flanders' after the calorific value, oil, lignin, and ash content; and also the chemical composition in 2008 -2010. The results show that oil-flax shoves have a high calorific value and high lignin content but a low temperature for ash fusion. It was established that the growth year and some unexplored factors have influence on the ash content. The oil content in the seeds was 336-458 g kgE-1, depending on the chosen variety. The flax shoves can be used as a supplement for biofuel combustion, as they have a low fusion temperature, a high calorific value, but a comparatively low yield makes oil-flax unprofitable to grow for biofuel production.

The aim of this paper is to characterize and ascertain quality influencing factors of wood chips produced from forest residues in clear-cuts. The quality of food fuels varies according to the harvesting season, site characteristics and silvicultural treatment. For this study 89 piles of logging residues from clear-cuts located in Western part of Latvia were used. Piles were stored in different parts of clear-cut according to its direction against nearby stand. Piles of logging residues were pre dried and then chipped. A period of chipping and sample acquisition was from February to May of the year 2012. Results show that chips from forest residues can be successfully used for medium scale boilers. Chips with lower carbon content, calorific value, relative moisture and bulk density of wet chips can be produced in May. Location of the pile in centre and SE part of the clear cuts can decrease resulting ash content in wood chips.

This paper describes the use of Scots pine (Pinus sylvestris L) bark humus and fine fractions for animal litter pellet manufacture, and the efficacy of various additives in improving absorbency. In Latvia is no researches about litter pellet manufacture of pine bark, and possibilities of increasing water absorbency; in internationals research papers there is also no information about the possibilities of improving water absorbency of pine bark pellets with various additives. The additives tested were fresh and fallen leaves, tree needles, dried hogweed and sawdust. Pellets were manufactured with a ZLSP200B granulator at Adazi city, Latvia, in 2014. The results indicated that production of small diameter pine bark pellets could be problematic. Absorbency of the pellets was tested both by rinsing and soaking the pellets, and results were compared to woodchip particle litter pellets. It was found that the best absorbency was achieved with adding up to 30% sawdust, which increased pellet absorbency both by rinsing and soaking. The results indicate that it is possible to manufacture pellets using Scots pine (Pinus sylvestris L.) bark humus and fine fraction with good absorbency which can be disposed of in sewerage systems.