Sewage sludge is a specific bulky waste and its utilization is hampered by the presence of the environmentally dangerous contaminated substances in the composition presented mainly by heavy metals, pathogens and coagulants. At the same time sewage sludge may serve as a valuable biological raw material. Utilization of the sewage sludge is crucial environmental and economic challenge. Application of the pneumatic pulse method in the technology of dehydration and utilization of the sewage sludge may allow us to speed up the process of drying, reduce power consumption and capital investment, execute process of dehydration at lower temperatures and in less hazardous explosive conditions. Proposed solution is founded on the use of the compact equipment for dehydration and utilization, including pneumatic pulse drying method. For this purpose the pulser – an airflow feeder with required time intervals or pulses, was included in the technological process. In the process of the drying sewage sludge with the use of pneumatic pulse, there is no need to spend all the energy on evaporation of the water molecules and this fact significantly reduces power consumption. Preliminary calculations, taking into account laboratory data, showed that proposed technology of drying sewage sludge allows to reduce power consumption by 25% upon receipt of the dry sludge. The aim of the study is development of sewage sludge dehydration technology for further utilization of design solutions using the pulse method.

Utilization of the sewage sludge is pressing and crucial environmental and economic challenge. High moisture content of the sludge is one of the main difficulties during the process of the sewage sludge utilization. Experimental drying module has been designed and manufactured to identify and verify effectiveness of the main parameters of the thermal drying of the sewage sludge with application of the pneumatic pulse method. The pulser is supposed to be part of the technological scheme in order to speed up the process of drying and saving energy. The pulser supplies hot air into the drying chamber with time intervals by pulse. In the drying chamber the airflow dislodges water molecules from the material by means of pulses and then they are taken away from the drying chamber. For the convenience of the comparison and evaluation of the executed experiment the following general characteristics were selected: drying rate – i – kg minE-1; power consumption – q – kWh kgE-1. The greatest effect in application of the pneumatic pulse method for dehydration of the sewage sludge was achieved at the angle of incidence equal to nearly 90° of the airflow on the dried sample and higher temperature. The experiment showed that application of the pneumatic pulse method for dehydration of the sewage sludge allows to reduce power consumption and speed up the process of drying. The process of drying can be executed at lower temperatures.