Selenium is a trace element essential for the proper functioning of human body. Since it can only be obtained through our diet, knowing its concentrations in different food products is of particular importance. The measurement of selenium content in complex food matrices has traditionally been a challenge due to the very low concentrations involved. Some of the difficulties may arise from the abundance of various compounds, which are additionally present in examined material at different concentration levels. The solution to this problem is the efficient separation/preconcentration of selenium from the analyzed matrix, followed by its reliable quantification. This review offers an insight into cloud point extraction, a separation technique that is often used in conjunction with spectrometric analysis. The method allows for collecting information on selenium levels in waters of different complexity (drinking water, river and lake waters), beverages (wine, juices), and a broad range of food (cereals, legumes, fresh fruits and vegetables, tea, mushrooms, nuts, etc.).

The results of the validation study of the LC-ESI-MS/MS method for the determination of chlorate (ClO3−), perchlorate (ClO4−) and bromate (BrO3−) in water and food samples are summarized. Towards this, 284 samples of drinking water were analysed, out of which the 69% contained chlorate above the limit of quantitation (LOQ) of 0.01 mg/L, with maximum amount of 1.1 mg/L. Only 6 samples were found to be positive with perchlorate at levels <0.01 mg/L. Bromate was detected in 5 drinking water samples at levels above the LOQ, at concentrations up to 0.026 mg/L. For the validation of the method in food, 108 blank samples were spiked with chlorate and perchlorate for the LC-MS/MS analysis at two levels. In total 247 food samples from the market of 19 different commodities including fruits, vegetables, cereals and wine, were analysed. The maximum concentration of chlorate was found at 0.83 mg/kg in a sample of cultivated mushrooms. The number of samples contaminated with perchlorate was also small, with all the determined concentrations below the LOQ of 0.05 mg/kg. Experiments for the chlorate reduction in drinking water, showed that reverse osmosis treatment is effective in particular with newly installed cartridges. Finally, according to the results of the pilot study when chlorinated water is used for the plant irrigation, accumulation of chlorate is observed, especially in the green parts of the plant. Perchlorate was also detected in leafy samples, although it was not present in the irrigation water.