Live green microalgae Chlorella pyrenoidosa was introduced in the anode of a microbial fuel cell (MFC) to act as an electron donor. By controlling the oxygen content, light intensity, and algal cell density at the anode, microalgae would generate electricity without requiring externally added substrates. Two models of algal microbial fuel cells (MFCs) were constructed with graphite/carbon electrodes and no mediator. Model 1 algal MFC has live microalgae grown at the anode and potassium ferricyanide at the cathode, while model 2 algal MFC had live microalgae in both the anode and cathode in different growth conditions. Results indicated that a higher current produced in model 1 algal MFC was obtained at low light intensity of 2500 lx and algal cell density of 5 × 10⁶ cells/ml, in which high algal density would limit the electricity generation, probably by increasing oxygen level and mass transfer problem. The maximum power density per unit anode volume obtained in model 1 algal MFC was relatively high at 6030 mW/m², while the maximum power density at 30.15 mW/m² was comparable with that of previous reported bacteria-driven MFC with graphite/carbon electrodes. A much smaller power density at 2.5 mW/m² was observed in model 2 algal MFC. Increasing the algal cell permeability by 4-nitroaniline would increase the open circuit voltage, while the mitochondrial acting and proton leak promoting agents resveratrol and 2,4-dinitrophenol would increase the electric current production in algal MFC.

The present study investigates the kraft lignin (KL) degrading potential of novel alkalotolerant Pandoraea sp. ISTKB utilizing KL as sole carbon source. The results displayed 50.2 % reduction in chemical oxygen demand (COD) and 41.1 % decolorization after bacterial treatment. The maximum lignin peroxidase (LiP) and manganese peroxidase (MnP) activity detected was 2.73 and 4.33 U ml⁻¹, respectively, on day 3. The maximum extracellular and intracellular laccase activities observed were 1.32 U ml⁻¹ on day 5 and 4.53 U ml⁻¹ on day 4, respectively. The decolorization and degradation was maximum on day 2. Further, it registered an increase with the production of extracellular laccase. This unusual trend of decolorization and degradation was studied using various aromatic compounds and dyes. SEM and FTIR results indicated significant change in surface morphology and functional group composition during the course of degradation. Gas chromatography and mass spectroscopy (GC-MS) analysis confirmed KL degradation by emergence of new peaks and the identification of low molecular weight aromatic intermediates in treated sample. The degradation of KL progressed through the generation of phenolic intermediates. The identified intermediates implied the degradation of hydroxyphenyl, ferulic acid, guaiacyl, syringyl, phenylcoumarane, and pinoresinol components commonly found in lignin. The degradation, decolorization, and GC-MS analysis indicated potential application of the isolate Pandoraea sp. ISTKB in treatment of lignin-containing pollutants and KL valorization.

A 4-year proactive environmental surveillance of Legionella spp. in the water distribution and cooling systems of five health-care facilities was carried out as part of the strategy for the prevention of hospital-acquired Legionnaires’ disease in Northeastern Greece. Legionella spp. were detected in 71 out of 458 collected samples. The majority of strains belonged to Legionella pneumophila serogroups 2–15 (75.0 %), while all L. pneumophila serogroup 1 strains (23.6 %) were isolated from a single hospital. The highest percentage of positive samples was found in distal sites (19.4 %), while no Legionella strains were detected in cooling systems. Each hospital was colonized at least once with L. pneumophila, while remedial actions resulted in significant reduction of Legionella concentration. The molecular epidemiology of environmental L. pneumophila strains was also investigated using random amplified polymorphic DNA (RAPD) and multi-gene sequence-based analysis. Based on RAPD patterns, L. pneumophila serogroups 2–15 and serogroup 1 strains were classified into 24 and 9 operational taxonomic units (OTUs), respectively. Sequencing of housekeeping and diversifying pressure-related genes recommended by European Working Group for Legionella Infections (EWGLI) revealed not only a high intraspecies variability but also the circulation and persistence of one specific genotyping profile in the majority of hospitals. This study highlights the necessity for diachronic surveillance of Legionella in health-care facilities by adopting both cultural and molecular methods.

Solid-phase microextraction (SPME) was used to determine the equilibrium association constant for a pesticide, trifluralin (TFR), with dissolved organic matter (DOM). After optimization of the SPME method for the analysis of TFR, partition coefficients (KDOM) with three different sources of DOM were determined in buffered solutions at pH 7. Commercial humic acids and DOM fractions isolated from two surface waters were used. The values of log KDOMvaried from 4.3 to 5.8, depending on the nature of the organic material. A good correlation was established between log KDOMand DOM properties (as measured with the H/O atomic ratio and UV absorbance), in agreement with literature data. This is consistent with the effect of polarity and aromaticity for governing DOM-pollutant associations, regardless of the origin of DOM. This association phenomenon is relevant to better understand the behavior of pesticides in the environment since it controls part of pesticide leaching and fate in aquatic systems.

Airborne submicron particles (PM₁) were collected using PM₁ sampler during the fog-dominated days (December 2013–January 2014). PM₁ values varied between 58.12 μg/m³ and 198.75 μg/m³, and average mass concentration was 162.33 ± 38.25 μg/m³ while total average concentration of particle-associated polycyclic aromatic hydrocarbon (PAHs) determined was 616.31 ± 30.31 ng/m³. This is a signal for an alarming high pollution level at this site situated in the Indo-Gangetic Plain (IGP). PAHs were extracted from filters using toluene and acetonitrile. Quantitative measurements of polycyclic aromatic hydrocarbons (PAHs) were carried out using the high performance liquid chromatography (HPLC) technique. The extracts were analyzed for 16 target polycyclic aromatic hydrocarbons (PAHs) including carcinogenic compound benzo(a)pyrene (19.86 ± 38.98 ng/m³). Fluoranthene, benzo(a)anthracene, anthracene, and fluorene were the predominant compounds found in the samples collected during foggy days. Based on number of rings, four-ring PAH compounds had maximum contribution (43 %) in this fog time collected submicron particles followed by three-ring (21 %), five-ring (20 %), six-ring (13 %), and two-ring (3 %), respectively. In winter and foggy days, wood and coal combustion and biomass burning also significantly contribute to the PAH levels. However, diagnostic ratio suggests diesel emissions as the prime source of PAHs at this sampling site.

Ballast water is, together with hull fouling and aquaculture, considered the most important factor of the worldwide transfer of invasive non-indigenous organisms in aquatic ecosystems and the most important factor in European Union. With the aim of preventing and halting the spread of the transfer of invasive organisms in aquatic ecosystems and also in accordance with IMO’s International Convention for the Control and Management of Ships Ballast Water and Sediments, the systems for ballast water treatment, whose work includes, e.g. chemical treatment, ozonation and filtration, are used. Although hydrodynamic cavitation (HC) is used in many different areas, such as science and engineering, implied acoustics, biomedicine, botany, chemistry and hydraulics, the application of HC in ballast water treatment area remains insufficiently researched. This paper presents the first literature review that studies lab- and large-scale setups for ballast water treatment together with the type-approved systems currently available on the market that use HC as a step in their operation. This paper deals with the possible advantages and disadvantages of such systems, as well as their influence on the crew and marine environment. It also analyses perspectives on the further development and application of HC in ballast water treatment.

Nowadays, sewage sludge management represents one of the most important issues in wastewater treatment. Within the European project “ROUTES,” wet oxidation (WO) was proposed for sludge minimization. Four different types of sludge were treated in an industrial WO plant: (1) municipal primary sludge (chemical oxygen demand COD: 73.0 g/L; volatile suspended solid VSS: 44.1 g/L); (2) secondary sludge from an industrial wastewater treatment plant (WWTP) without primary sedimentation (COD: 71.8 g/L; VSS: 34.2 g/L); (3) secondary sludge from a mixed municipal and industrial WWTP without primary sedimentation (COD: 61.9 g/L; VSS: 38.7 g/L); and (4) mixed primary (70 %) and secondary (30 %) municipal sludge (COD: 81.2 g/L; VSS: 40.6 g/L). The effect of process parameters (temperature, reaction time, oxygen dosage) on WO performance was investigated. Depending on operating conditions, VSS and COD removal efficiency varied in the range 80–97 % and 43–71 %, respectively. A correlation between process efficiency and the initial VSS/TSS (total suspended solids) ratio was highlighted. Furthermore, a mathematical model of WO process for simulating VSS and COD profiles was developed.

Since perfluorooctane sulfonate (PFOS) had been detected in eggs of seabirds and fish, toxicity of waterborne PFOS to embryonic development of zebrafish (Danio rerio) was investigated. However, because assessment of effects by use of dietary exposure of adults is time-consuming and expensive, a study was conducted to compare effects on embryos via nanoinjection and waterborne exposure. Nanoinjection, in which small amounts of chemicals are injected into developing eggs, was used to incorporate PFOS into the yolk sac of embryos of zebrafish. Effects of PFOS during the period of development of the embryo were assessed within 96 h post-fertilization (hpf). PFOS significantly retarded development of embryos of zebrafish and resulted in abnormalities as well as lethality of developing embryos. Both methods of exposure, waterborne and nanoinjection, resulted in similar dose-dependent effects. Some sublethal effects, such as edema at 48 hpf, delayed hatching, and curvature of the spine was observed after 72 hpf. In ovo, nanoinjection was deemed to be an accurate method of exposure for controlling the actual internal dose for study of adverse effects, which closely mimicked responses to waterborne exposure of zebrafish embryo to PFOS.

Atmospheric aerosols play a major role in the global climate change. A better physical characterization of the chemical composition of atmospheric aerosols, especially in remote atmosphere, is an important step to reduce the current uncertainty in their effect on the radiative forcing of the climate. In the present work, surface aerosols have been studied over the Southern Ocean and over Bharati, Indian Research Station at Larsemann Hills at the Antarctic coast during the summer season of 2009–2010. Aerosol samples were collected using optical particle counter (OPC) and high-volume air sampler. PM₁₀ and PM₂.₅ aerosol samples were analyzed for various water-soluble and acid-soluble ionic constituents. The Hysplit model was used to compute the history of the air masses for their possible origin. Supplementary measurements of meteorological parameters were also used. The average mass concentration for PM₁₀ over the Southern Ocean was found to be 13.4 μg m³. Over coastal Antarctica, the mass of PM₁₀ was 5.13 μg m⁻³, whereas that of PM₂.₅ was 4.3 μg m⁻³. Contribution of marine components, i.e., Na, Cl and Mg was dominant over the Southern Ocean (79 %) than over the coastal Antarctica where they were dominant in coarse mode (67 %) than in fine mode (53 %) aerosols. The NH₄/nss-SO₄ ratio of 1.12 in PM₂.₅ indicates that the NH₄ and SO₄ ions were in the form of NH₄HSO₄. Computation of enrichment factors indicate that elements of anthropogenic origin, e.g., Zn, Cu, Pb, etc., were highly enriched with respect to crustal composition.

In this study, antimicrobial-resistance patterns were analyzed in Escherichia coli isolates from raw (RW) and treated wastewater (TW) of two wastewater treatment plants (WWTPs), their marine outfalls (MOut), and mouth of the Vistula River (VR). Susceptibility of E. coli was tested against different classes of antibiotics. Isolates resistant to at least one antimicrobial agent were PCR tested for the presence of integrons. Ampicillin-resistant E. coli were the most frequent, followed by amoxicillin/clavulanate (up to 32 %), trimethoprim/sulfamethoxazole (up to 20 %), and fluoroquinolone (up to 15 %)-resistant isolates. Presence of class 1 and 2 integrons was detected among tested E. coli isolates with rate of 32.06 % (n = 84) and 3.05 % (n = 8), respectively. The presence of integrons was associated with increased frequency of resistance to fluoroquinolones, trimethoprim/sulfamethoxazole, amoxicillin/clavulanate, piperacillin/tazobactam, and presence of multidrug-resistance phenotype. Variable regions were detected in 48 class 1 and 5 class 2 integron-positive isolates. Nine different gene cassette arrays were confirmed among sequenced variable regions, with predominance of dfrA1-aadA1, dfrA17-aadA5, and aadA1 arrays. These findings illustrate the importance of WWTPs in spreading of resistance genes in the environment and the need for inclusion of at least monitoring efforts in the regular WWTP processes.